New balance ground relay for parallel four-circuit transmission lines

A 66-kV network generally is grounded through a neutral grounding resistor. In this network a single-phase ground-fault current is limited to as small as 100 to 400 A. There are parallel four-circuit transmission lines mounted on the same tower in the 66-kV network. In such transmission lines, the load and the fault currents could induce circulating current that flows through the lines. Since the circulating current has zero-phase-sequence and negative-phase-sequence components, it could cause unwanted operation of a balance ground relay using zero-phase-sequence current. However, it is difficult to compensate for the circulating current by the conventional vector compensation scheme. This paper presents a new balance ground relay to deal with the circulating current. In the relay from the ground-fault inception until first tripping, the difference current Δ3I_2d of negative-phase-sequence current 3I_2d of the differential current between two protected lines is used as an input current. The Δ3I_2d is the difference current of 3I_2d between, before and during faults. After the first tripping, the difference current of positive-phase-sequence load current and zero-phase-sequence current of the forementioned differential current are used as an input current. Consequently, a higher sensitivity of the ground-fault protection for these lines has been achieved. The correct operation of the new balance ground relay was confirmed when a single-phase-ground-fault occurred in the parallel four-circuit transmission lines, to which the relay is applied.     

方块电阻测试中的有限元理论

介绍了用有限元方法计算半导体方块电阻四探针测试中二维点电流势场的模型并且证明了其正确性。由于有限元方法对边界没有限制，该方法为方块电阻测试中精确确定边界修正系数，更重要的是为微样品测试结构确定提供直接明了的理论依据。     

用小尺寸R－CT试样研究核压力容器钢断裂韧性及与Charpy试样的比较

提出了一种用双边带深侧槽的小尺寸圆形紧凑拉伸试样评定核压力容器（ＲＰＶ）钢断裂韧性的单试作试验方法，给出了用该方法测定的两个厂家生产的核压力容器用Ａ５０８ＣＬ３钢的断裂韧性参数，还与Ｃｈａｒｐｙ试样的试验结果及大尺寸标准试样的试验结果进行了比较。研究结果表明：用双边带深侧槽的小尺寸Ｒ－ＣＴ试样测得的断裂韧性值比相同恻槽深度预制疲劳裂纹Ｃｈａｒｐｙ试样的测试值更接近有效断裂韧性值，所以，用于核压力容器断裂韧性的监测是可行的。     

非理想信道下Colpitts混沌电路的自适应同步研究

本文研究了Colpitts混沌电路在非理想信道条件下的自适应同步问题。引入自适应控制器对输入到响应部分（response system）的衰变混沌信号进行预处理，来补偿衰落信道对于同步性能的影响。给出了系统的数学模型，对恒定信道衰变和时变信道衰变两种非理想信道条件下的混沌ColpiRs电路的自适应同步进行了数值仿真研究。仿真结果表明，对于恒定或慢变化的时变信道衰变，自适应控制器可以有效的提高Colpitts电路响应部分和驱动部分（Drive system）的同步性能。     

梯形断面水力计算的一种新方法

本文从梯形水力最优断面的基本思路出发，通过理论分析找到了梯形断面水力计算的一种新方法——即通过特征参数进行梯形断面的水力计算。     

常减压蒸馏装置阻垢剂进料管腐蚀与防护

通过对常减压蒸馏装置阻垢剂进料管的材质、性能、工作条件及腐蚀形貌、腐蚀产物的全面分析,找出了使进料管发生大面积腐蚀的腐蚀介质为环烷酸.并提出了减缓阻垢剂进料管环烷酸腐蚀的措施,主要包括选用更耐蚀的316或316 L材质以及改进三通结构等.     

吸收雷达波包装材料的研究进展

论述了吸收雷达波包装材料的基本组成及其选择原则，在此基础上讨论了吸波材料的吸波原理及影响吸波性能的因素，并指出了吸波包装材料的开发现状和应用进展及其发展万向。     

各国核电厂场外应急计划的比较

本文分析和比较了各国核电厂的应急计划,特别是场外应急的干予水平和应急计划区,讨论了我国干予水平、核电厂应急计划区和香港核应急计划几个实际问题。     

Application of Code Approach for Emergency Evacuation in a Rail Station

This paper presents an emergency evacuation analysis during a mid-platform train fire in an underground rail station. A time-based evacuation scenario is developed taking into account the stairway inaccessibility due to smoke blockage. The calculation approach in NFPA 130 is then applied to a parametric study of this time-based scenario and its reliability is examined using a micro-simulation model. Both methods give consistent predictions of the exiting times. The results demonstrate that with the division of the station into two zones, the exiting time could not meet the code requirements, whereas it does meet the required exiting time without the division. Such division is due to smoke blockage and creates an uneven ratio of the occupant load to the available exiting capacity. This shows that appropriate consideration of the fire and smoke effects is important for station egress evaluation. Other issues such as the fire growth rate and the pre-evacuation time are also discussed.