以硅氧烷醇锂为催化剂的氟硅生胶的合成

介绍了单体三氟丙基甲基环三硅氧烷通过硅氧烷醇锂催化剂聚合成氟硅生胶,讨论了不同催化剂及其用量,原料中水分含量、不同乙烯基含量对氟硅生胶分子量的影响.     

Optically tuned superconductive-dielectric resonators with whispering-gallery modes

An analytical method is presented for calculating the resonant frequency andQ-factor of a superconducting dielectric disk resonator operating in millimeter-wave regime with whispering-gallery mode. Resonant frequency shift due to the optical generation of quasi-particles in superconducting film is investigated as a function of photon flux. An optically tunable resonant frequency of about 500 MHz is estimated, and good agreement is found between numerical results and experimental ones.     

CTLA4 mediates antigen-specific apoptosis of human T cells

The regulation of T cell-mediated immune responses requires a balance between amplification and generation of effector function and subsequent selective termination by clonal deletion. Although apoptosis of previously activated T cells can be induced by signaling of the tumor necrosis factor receptor family, these molecules do not appear to regulate T-cell clonal deletion in an antigen-specific fashion. We demonstrate that cross-linking of the inducible T-cell surface molecule CTLA4 can mediate apoptosis of previously activated human T lymphocytes. This function appears to be antigen-restricted, since a concomitant signal T-cell receptor signal is required. Regulation of this pathway may provide a novel therapeutic strategy to delete antigen-specific activated T cells.     

温度,压力对漂移室气体增益的影响

研究了温度及气体压力对漂移室（工作于正比区）气体放大倍数的影响，温度和气体压力的变化范围分别是５￣４０℃及９０￣１０５ｋＰａ。用实验数据拟合得到了函数关系并测量了几种饱和度下函数中的参数值。     

几种重氮氨基类新显色剂的合成及其与镉（Ⅱ）显色反应的研究

3种重氮氨基类新显色剂的合成及其与镉(Ⅱ)的显色反应。在表面活性剂 Triton X-100存在下,3种试剂均与镉(Ⅱ)生成络合比为3:1的红色络合物。其表观摩尔吸光系数在1.80×10~5以上。镉量在0～12μg/25mL 符合比尔定律。并对3种试剂的性能与结构的关系作了比较。将其中一种试剂(BPDAA)用于废水中痕量镉的测定,结果满意。     

Experimental investigation of adhesive meltblown web production using accessory air

Using a low‐melting‐point polymer, copolyamide, as raw material, adhesive meltblown webs were formed on the ordinary melt‐blowing line by using the accessory air and the accessory air chamber. The webs thus produced exhibit narrower fiber diameter distribution and a more uniform pore structure. At the same time, four main melt‐blowing parameters, the primary air pressure, the accessory air pressure, the melt throughput rate, and the die‐to‐collector distance, are discussed in terms of their influence on geometric mean diameter of fibers and fiber diameter distribution. POLYM. ENG. SCI., 46:1–7, 2006. © 2005 Society of Plastics Engineers     

论蒙古族传统马具设计的系统性

文章以作者亲身参与的编著项目及田野考察为契机,将蒙古族传统马具设计作为研究对象,以蒙古族传统马具设计的系统性为论点,探讨其系统构成、单元功能及三个子系统的分工与关联。     

悬浮液进样-火焰原子吸收光谱法测定茶叶中的微量铬

将茶叶悬浮于琼脂胶体中制成悬浮液 ,直接喷入空气 -乙炔火焰 ,用火焰原子吸收光谱法测定茶叶中的微量铬 ,方法简便、快速、灵敏度和精密度高、测定结果与用灰化法处理样品一致 ,检验表明 ,两种样品前处理方法之间无显著性差异。相对标准偏差为 3.4 %～ 6 .1% ,加标回收率为 95 .7%～ 10 3.8 %。     

制造任务分解与制造单元级资源配置协同优化

针对网络化制造环境下制造任务分解与资源配置脱节的问题,提出了制造任务逐层分解与制造单元级资源配置协同优化的方法,建立了协同优化流程.在对制造任务特点进行分析的基础上,建立了制造任务模型和制造单元资源模型,建立了多目标优化模型和目标的综合评价体系,利用在遗传算法求解搜索过程中所获得的动态信息进行综合评价,并随着求解搜索过程的深入对变异幅度进行调整,以达到全局优化和加快收敛速度的目的.最后以实例验证了该方法的可行性与有效性.     

Influence of electroplating conditions on magnetic properties of Fe-36wt.% Ni alloy film

A Fe-Ni soft magnetic film was prepared in sulphate solution by electroplating. The influences of the molar ratio of n [Fe2+ ]/ n [Ni2+ ], current density, bath temperature, pH and L-ascorbic acid concentration on magnetic properties of Fe-Ni alloy film were investigated. The results show that the saturated flux density(BS) of the film increases initially and decreases after it reaches the specific value with the increase of n [Fe2+ ]/ n [Ni2+ ] molar ratio, current density, bath temperature and pH. However, the relationship between L-ascorbic acid concentration and B S keeps linear. It is observed that the coercive force( Hc) is enhanced with the increase of n [Fe2+ ]/ n [Ni2+ ] molar ratio, current density and pH. By comparison, when the bath temperature increases, Hc always decreases. With the increase of L-ascorbic acid concentration, the coercive force increases initially and then decreases.