基于推断策略多介质反应温度控制系统研究与实现

针对反应釜夹套多种热/冷介质温度自动控制检测硬件复杂、实现困难等问题,分析了夹套介质切换操作过程,提出了基于推断识别的夹套介质自动切换解决方案,最大程度地简化了系统硬件配置。通过记忆阀门操作推断识别夹套内当前介质,替代在线检测与分析物质成分检测系统。分析了影响压空时间的因素,关联了压空时间与压空用压缩空气压力的关系,并根据压空操作时间推断判定夹套介质压空终点,解决了传感器检测压空操作终点存在的问题。设计了基于推断识别的夹套介质自动切换控制系统,实际应用中克服了人工操作过程复杂、效率低和易出错等问题。实际应用表明,该方案介质切换的效率高、安全可靠。     

Se doped nickel-molybdenum bimetal sulfide with enhanced electrochemical activity for hydrogen evolution reaction

In this work, we synthesized Se doped MoS₂@Ni₃S₂ with nanosheets coated nanorods structure supported on Ni foam (MoNiSeS). Firstly, MoS₂@Ni₃S₂ (MoNiS) nanorods was synthesized by hydrothermal method. After selenization treatment, MoSe₂ successfully formed on the edge of MoS₂ nanosheets and particle Ni₃S₂ transformed into NiSe, in which MoSe₂ and NiSe acted as new phase in MoNiSeS. The obtained MoNiSeS only needs a low overpotential of 68 mV to reach the current density of 10 mA cm^?2, and has a low Tafel plots of 72.77 mV dec^?1 and good electrochemical durability, whose electrochemical activity is much better than that of MoNiS and NiSeS, implying the introduction of Mo and Se is beneficial to improve the electrocatalytic performance of NiS for HER. In addition, the proper amount of Mo source, which has an effect on the morphology of product, has also been investigated. For MoNiSeS, the typical nanosheets coated nanarods expose more active sites and the synergic effects is good to the improvement of the catalytic activity. Meanwhile, WNiSeS has also been prepared using the same method and the corresponding results show that the electrochemical activity of WNiSeS is much better than that of NiSeS, proving the universality of this strategy.     

Lead-free sodium niobate nanowires with strong piezo-catalysis for dye wastewater degradation

In this work, the hydrothermally-synthesized sodium niobate nanowires were used to decompose Rhodamine B dye solution through the piezo-catalytic effect. With the sodium niobate catalyst, a high piezo-catalytic degradation ratio of ～80% was achieved under the excitation of vibration for the Rhodamine B dye solution (～5?mg/l). These active species in the catalytic process, hydroxyl radicals and superoxide radicals with the strong oxidation ability, were also observed, which confirmed the key role of piezoelectric effect for piezo-catalysis. The piezo-catalysis of sodium niobate nanowires provides a high-efficiency and reusable tool in application in depredating the dye wastewater.     

基于“天空地”一体化技术的安全监测系统建设与应用

西藏江达县白格村金沙江右岸于2018年10月11日和2018年11月3日先后发生2次大规模滑坡—堰塞湖堵江事件,溃堰洪水对下游拉哇库区不良地质体的稳定性造成不同程度的影响。为保障下游水电站建设安全,对拉哇库区主要不良地质体建立了基于星载InSAR技术、无人机技术和地面传感器实时监测的“天空地”一体化监测预警体系,以多维空间采集技术获取变形信息,通过智能监控平台对信息及时进行处理、分析和可视化呈现,利用平台、短信等方式向相关人员进行分级告警,取得了较好的应用效果。     

植物细胞分裂素ortho-Topolin Riboside对人白血病细胞株THP-1的抗癌活性及机制初探

本研究以人急性髓性白血病细胞株THP-1为研究对象,初步探讨其抗癌活性及作用机制。通过光学显微镜观察N6-2-苄胺羟基腺苷(oTR)作用后THP-1细胞形态学和数目变化;CCK-8法检测oTR对THP-1细胞的增殖抑制作用,并用核苷转运体拮抗剂和腺苷受体拮抗剂预处理细胞检测oTR进入细胞的方式;用流式细胞仪分析oTR作用对THP-1细胞凋亡和分化的影响。结果表明,oTR可显著(P<0.05)抑制THP-1细胞的增殖能力,且呈浓度依赖性;核苷转运体拮抗剂Dipyridamole预处理THP-1细胞后,可明显逆转oTR的增殖抑制作用,而4种腺苷受体拮抗剂(DPCPX、SCH58261、MRS1754和MRA1191)则无显著影响;oTR可诱导处理组细胞亚倍体峰比例显著(P<0.05)高于对照组,且细胞髓系分化标志蛋白CD11b表达明显升高。以上结果表明细胞分裂素oTR通过核苷转运体途径进入THP-1细胞,显著(P<0.05)抑制细胞的增殖,并可诱导THP-1细胞发生凋亡和髓系分化。     

Two-step method to deposit ZrO2 coating on carbon fiber: Preparation,characterization, and performance in SiC composites

Recently, ceramic matrix composites reinforced by short carbon fibers (CFs) attracted increasing attentions. To further improve mechanical properties and oxidation resistances, CFs were subjected to oxidation and acidification followed by sol-gel dip-coating to deposit ZrO₂ on their surfaces. ZrO₂-C_f/SiC composites were fabricated by joint hot compression molding and sintering, compared to C_f/SiC and SiC prepared by the same method. Microstructural analyses indicated that ZrO₂ coatings were successfully deposited on CF surfaces, formed strong bonding and interfaces between CF and the matrix. Meanwhile, CFs were found uniformly distributed in SiC matrix with random orientations. Flexural curves of ZrO₂-C_f/SiC and C_f/SiC revealed the presence of “false plasticity” regions after sharp drops, which were quite different from brittle flexural behavior of SiC ceramic. Compression strength of the three samples showed step-up growth. ZrO₂-C_f/SiC exhibited the highest value, indicating the introduction of CFs and ZrO₂ coatings do have great influence on mechanical performances. After heat treatment, ZrO₂-C_f/SiC exhibited better oxidation resistance than C_f/SiC, with weight loss ratios estimated to ??3.76% and ??6.43%, respectively. These improved properties indicated that ZrO₂-C_f/SiC would be excellent alternatives to other existence materials under ultra-high temperature environments.     

Dewatering and Drying Methods for Microalgae

Microalgae can efficiently fix carbon dioxide through their phototropic metabolism, and have been recognized as a promising bioresource for animal feed, health food, fuel, cosmetic, and pharmaceutical products. However, since microalgae in cultivated medium have a low biomass concentration (0.1–1% w/w), both harvesting and concentration of microalgal biomass are often required prior to the production of commercial products. Efficient and cost-effective dewatering and drying methods for microalgae heavily affect the overall energy consumption and production cost of microalgal products. This review describes the characteristics of commonly used dewatering and drying technologies, and critically evaluates the feasibility for their use to treat microalgal biomass. No single dewatering or drying method can satisfactorily handle all types of microalgae. The suitability of each method depends on the properties of the microalgae suspension, the required process design, the quality of the end product, and the related capital and production costs.     

新型计量斗在锰粉料制块配料中的改进应用

锰粉料制块是解决铁合金冶炼精料入炉的主要途径之一,生产过程中为解决锰粉料粘附计量斗的问题,介绍了一种新型计量斗,阐述他的结构特点和工作原理,实施改进后下料流畅,降低了劳动强度,提高了生产效率。