HT-730改性酚醛-丁腈胶粘剂的研制

对酚醛-丁腈胶粘剂进行改性，添加5．0％的硅烷偶联剂，改善了酚醛-丁腈胶粘剂的工艺性能，提高了粘接强度，特别是降低了酚醛-丁腈胶对环境湿度的敏感性。研制的HT-730胶在环境湿度90％时仍有很高的粘接强度，同时老化性能和适用期并没有受到影响。     

Adsorption and desorption kinetics of hydrocarbons in FCC catalysts studied using a tapered element oscillating microbalance (TEOM). Part 2: numerical simulations

The factors affecting the adsorption and desorption kinetics in a TEOM are reviewed in detail with particular attention given to the assumptions required to obtain physical transport parameters from the data. Two models are presented to simulate TEOM adsorption data in the case that concentration differences down the catalyst bed can be neglected, as is appropriate when the amount of catalyst used is small, the carrier gas flowrate is large, and/or the adsorbate partial pressure is low. In the first model, the effective diffusion coefficient, D_e, is taken to be constant. In the second model, the effective diffusion coefficient is assumed to obey the Darken equation, D_e=D₀/(1−θ). The TEOM results obtained on n-hexane, n heptane, n-octane, toluene and p-xylene on a commercial FCC catalyst and on pure rare-earth exchanged zeolite Y under non-reacting conditions (373-) are analysed in detail. It is found that intracrystalline diffusion is not the limiting factor affecting the overall rates of adsorption and desorption for the systems studied. Instead, it is the transport of molecules between the adsorbed and vapour phases at the edge of zeolite crystallites that is the limiting transport step affecting the overall kinetics. For the FCC catalyst, the limiting step is the transport of molecules at the zeolite-matrix interface rather than, say, the matrix-vapour interface. Local rate constants for the desorption of the hydrocarbons at the rate-controlling interface have been obtained.     

A novel shaft-less double suction mini pump

A novel double suction shaft-less mini pump was developed for heat control of small energy systems in this study.The mini pump impeller with an exit diameter of 40 mm was combined with the motor rotor supported by the hybrid dynamic bearing.The specific speed of the pump was 125 min-1 m3 min-1 m.The hydraulic performance of the pump was investigated experimen-tally under four rotational speeds.From the test results,it was recognized that the pump could provide a flow discharge of 5 L/min and head of 1.5 m,w...     

Nanobubble generation and its applications in froth flotation (part Ⅲ): specially designed laboratory scale column flotation of phosphate

Froth flotation is used widely for upgrading raw phosphate. The flotation recovery of coarse phosphate (-1.18+0.425 mm) is much lower than that achieved on the -0.425+0.15 mm size fraction. Enhanced recovery of coarse phosphate particles is of great economic and environmental importance for phosphate industry. In this investigation, four different phosphate samples were aquired, characterized and tested in a specially designed laboratory-scale flotation column. Significant recovery improvement of coarse phosphate flotation was achieved using cavitation-generated nanobubble though its effects differ among the four testing phosphate samples. The laboratory-scale flotation column test results indicate that nanobubble increased P2O5 recovery by up to 10%-30% for a given Acid Insoluble (A.I.) rejection, depending on the characteristic of phosphate samples. The improvement ef-fect of nanobubble on the hard-to-float particles was more significant than that on easy-to-float particles, especially at lower col-lector dosages. Nanobubbles reduced the collector dosage by 1/3 to 1/2. Nanobubbles almost doubled the coarse phosphate flotation rate constant and increased the flotation selectivity index by up to 25%.     

当代教育理念与模式下的职业技术学院设计——以鹤壁职业技术学院新校区规划设计为例

面对社会对职业技术的日益重视,职业技术学校的发展也有了日新月异的变化.试图通过对鹤壁职业技术学院新校区的规划设计与分析,探讨当代教育理念与模式下高等职业技术教育的办学特色和校园文化对规划及建筑设计的影响,从而总结适应职业技术教育的设计理念和方法,塑造具有自身特色和体现城市风貌的职业技术学院.     

低雷诺数气液交叉流装置研究（I）——孔流液柱流动特性数值模拟

针对低雷诺数的气液交叉流气体净化过程,提出有效避免二次雾沫夹带的液柱流体力学条件。数值模拟结果表明,液柱表面随着离开孔口的距离而变化,采用公式Lb／d=2．84We^0.694能有效预测液柱的断裂行为。     

框架的行置换和列置换——处理复杂系统的新思维系列之四

本系列论文基于《多边矩阵理论》,由东方整体性思维所启迪,试图提供并完善一套从整体到局部处理复杂系统多指标问题、非均匀性问题、非线性问题的强有力的数学工具,并对其进行严格的理论推导和证明。本文利用群论的相关概念和结论,将其和框架的剖分运算相结合,引入了导出框架和对称框架的定义,证明了框架的行置换等价于列置换的结论,从而以后可以统一地处理指标间的置换问题。     

超细Al（OH）3的粒度控制研究

采用铝酸钠种子分解法制备超细Al（OH）3.用X射线衍射仪（XRD）表征了样品的晶相组成,用扫描电子显微镜（SEM）观察了样品的形貌,用激光粒度分析仪测定样品的粒度分布.研究了NaOH浓度、NaOH/Al（OH）3摩尔比,分解温度,分解时间、晶种率和搅拌速率等因素对Al（OH）3的粒度的影响.结果表明：NaOH浓度越高,分解温度越低,NaOH/Al（OH）3摩尔比越小,得到的Al（OH）3颗粒的粒度越小.试验条件为：NaOH浓度180 g/L,NaOH/Al（OH）3摩尔比1.15,分解温度40℃,分解时间26 h,晶种率8％,搅拌速率200 rpm时,氢氧化铝颗粒的平均粒度为2.89 μm.     

高校图书馆参加“农家书屋”建设的思考与实践

高校图书馆在参与支持“农家书屋”的建设与发展中具有专业技术人才、信息资源等优势,可以通过对“农家书屋”管理员进行图书情报业务培训、协助“农家书屋”制定管理制度与开发自动化管理软件、组织高校教职工及大学生捐献图书与声像资料、组织大学生寒暑假“三下乡”和建设高校“读者协会”的社会实践基地来推动“农家书屋”的健康发展.     

一种相控阵天线安装精度检测与校准

文中论述了一种相控阵雷达天线安装后的精度检测方法。按照雷达天线安装后的几何形态,采用光学测量仪器进行相关的数据采集,建立检测的数学模型,利用线性回归法以及最小二乘法进行数据拟合,计算出安装后雷达天线底面与水平面的最大夹角和天线边缘与正北方向的夹角,并进行了试验误差评估和分析,依据检测数据对雷达天线的水平和方位角度进行校...