Automatic fault detection, isolation, and recovery in transparentall-optical networks

Network fault identification is an important network management function, which is closely related to fault management and has an impact on other network management functions such as configuration management, and performance management. This paper investigates fault surveillance and fault identification mechanisms for a transparent optical network in which data travels optically from the source node to the destination node without going through any optical-to-electrical (O/E) or electrical-to-optical (E/O) conversion. Mechanisms and algorithms are proposed to detect and isolate faults such as fiber cuts, laser, receiver, or router failures. These mechanisms allow nonintrusive device monitoring without requiring any prior knowledge of the actual protocols being used in the data transmission     

一种具有带孔补偿过滤器的γ剂量计的能响补偿计算

对在低能区有过高响应的γ辐射剂量计可采用带孔补偿过滤器进行能响补偿。本文介绍了对这类补偿过滤器选择最佳补偿参数(材料厚度和孔隙率)的近似求解方法;并对 CaSO:Tm 热释光剂量计用此方法作了实例计算。文中还计算了自制带有鼠笼结构的这类补偿过滤器的 CaSO:,Tm热释光剂量计对照射量的能量响应,与实测结果比较,各能量点响应的最大相差为10%。     

The Solutions for Adjustment and Reconstruction of Water-Drive Surface Systems in the Old Areas of Daqing Oilfield

Introduction 　　Owing to long-time running, more facilities including stations, pipelines, vessels have become corrosive and aged ,some process has grown old, it has exert more burden for the maintenance and repair.Simultaneously, the fluid production rate, oil production rate and water injection rate has changed greatly so that the inflicts and problems from the established surface systems will become more obvious. Energy cost of production and running has increasing continuously. Capacity has been unbalance in systems and areas. 　　……     

关于粒子加速器人身辐射安全联锁系统设计原则的建议

本文讨论了在粒子加速器上的联锁系统设计中应遵循的一些原则,其中建立隔离区、“失效导致安全(Fail-safe)”,使用“硬件”、“多重联锁”、设置急停开关等是最重要的。     

Environmental-stress-screening using degradation measurements

ESS (environmental stress screening) has been extensively used to reduce infant mortality by precipitating defects. The existing ESS plans precipitate defects by stressing all products for specified durations. The plans usually require long screen durations to allow nearly all defective items to fail, and thus generate excessive aging effects on good items. For some products, failures are defined in terms of performance characteristics exceeding their critical values. This paper describes the principles of using degradation measurements of performance characteristics to screen the products. In an ESS, the performance characteristics of defective items degrade considerably faster than those of good ones, yielding a bimodal distribution of the characteristics. As screen duration increases, the 2 modes of the distribution shift apart. It is possible to find a tightened critical value to weed out the defective items before they fail. This paper, based on these principles, further designs the optimal 2-level screen plans which minimize a segment of life-cycle cost and which simultaneously meet the reliability requirement. The minimum cost is achieved by choosing optimal part-level and unit-level screen durations and tightened critical values of parts. A numerical example is followed by discussion. Because the ESS regime of this paper allows defective parts to be screened out before they fail, the developed optimal ESS plans can reduce life-cycle cost, shorten part-level screen duration, and alleviate aging effects on good products     

Guest Editorial

The UK-China Research Network on Intelligent Automation, Computing and Manufacturing has been established since September 2004 by grants from the Engineering and Physical Sciences Research Council (EPSRC) of the UK and the National Natural Science Foundation of China. The initiative of the network is motivated by the last visit of the UK Science Minister Lord Sainsbury to China to open the first UK-China Hi-Tech Forum and by the current EPSRC initiative to set up specific network programmes in collaboration with partners in China.     

A network management architecture for robust packet routing in meshoptical access networks

We describe an architecture for an optical local area network (LAN) or metropolitan area network (MAN) access. The architecture allows for bandwidth sharing within a wavelength and is robust to both link and node failures. The architecture can be utilized with an arbitrary, link-redundant mesh network (node-redundancy is necessary only to handle all node failures), and assumes neither the use of a star topology nor the ability to embed such a topology within the physical mesh. Reservation of, bandwidth is performed in a centralized fashion at a (replicated) head end node, simplifying the implementation of complex sharing policies relative to implementation on a distributed set of routers. Unlike a router, however, the head end does not take any action on individual packets and, in particular, does not buffer packets. The architecture thus avoids the difficulties of processing packets in the optical domain while allowing for packetized shared access of wavelengths. We describe the route construction scheme and prove its ability to recover from single link and single node failures, outline a flexible medium access protocol and discuss the implications for implementing specific policies, and propose a simple implementation of the recovery protocol in terms of state machines for per-link devices     

用硫酸铁铵容量法测定钛精矿中二氧化钛含量

样品在过氧化钠熔融、水浸取及盐酸酸化后，在盐酸和硫酸介质中，隔绝空气，用金属铝将钛(Ⅳ)还原至钛(Ⅲ)，以硫氰酸盐为指示剂，用硫酸铁铵标准溶液滴定。