NiTi形状记忆合金激光气体氮化层表面特征

为改善NiTi合金的表面性能，利用2kW连续波Nd：YAG对NiTi合金进行激光气体氮化处理。采用SEM、TEM、XRD、XPS和纳米压痕研究了氮化层的显微组织及表面特征．结果表明：激光气体氮化可以在NiTi合金表面制备连续、无裂纹、厚度为2μm的TiN表面层，该表面层中基本不合有Ni元素且具有很高的硬度，其纳米压痕硬度为29．28GPa．     

三相异步电动机运行指标的分析

利用电机学理论分析了影响电机起动转矩、起动电流、最大转矩和最小转矩的因素。     

Study on Adsorption Behavior of Rare Earth Complexes on Nanometer-Size Titanium Dioxide with ICP-AES

Inrecentyears ,rareearthelements (REEs)havebeenwidelyusedinfunctionalmaterials ,cata lystsandotherproductsinindustry ,diagnosisreagentsofmagneticresonanceimaging (MRI)inmedicineandsomefertilizersinagricultureespeciallyinChina .However,asaresultoftheirusage ,moreandmoreREEsaregettingintotheenvironment,andalsointohumanbodyviafoodchain[1,2 ] .Itisnotclearwhetherrareearthelementsareessentialforman ,soitisveryurgenttostudythebiologicaleffectofrareearthelementsinhumanhealthandenvironment .Inthes…     

含钡合金的生产及其对钢液脱氧行为的研究

介绍了含钡合金的生产状况。在MoSi2炉上对钢管钢进行了含钡合金脱氧行为的研究，然后在150tLF／VD精炼设备上进行了使用含钡合金的工业试验。研究中主要选取SiAlBa、SiCaBa、SiAlBaCa、SiAlBaCaSr及用于钙处理的SiCa包芯线，并选用Al和FeSiAl作为对比脱氧剂，分别考察了实验室条件下和实际生产过程中，采用钡系合金对钢液脱氧的全氧含量，脱氧产物的分布、尺寸和形貌，探讨了钡系合金脱氧和对夹杂物的变质作用的机理。     

汽轮机轴承烧瓦与轴颈的渗巴氏合金现象

简述轴承工作性质，巴氏合金应用与相组成的基本情况。论述汽轮机转子在两个电厂长期运行后，由于轴颈发生的不正常摩擦损伤，在大修改造中由无损检查、机械加工揭示出轴颈存在严重的渗巴氏合金现象，低熔点金属Sn、Sb与Cu向转子材料晶界的深层渗入最终导致了3根大型在投转子的严重开裂与报废。图11表2     

吉林闹枝金矿床黄铁矿的标型特征研究

从成因矿物学及找矿矿物学的观点出发，系统地研究了闹枝金矿床黄铁矿的形态、粒度、化学成分、热电性、硫同位素方面的标型特征，为矿床的成因研究和深部远景评价提供了矿物学依据。     

A novel optical burst switching scheme—logical cascaded private subnet with start wavelength assignment policy

Many recent studies have convincingly demonstrated that network traffic exhibits a noticeable self-similar nature, which has a considerable impact on network performance, and most studies of optical burst switching (OBS) networks are under a fundamental assumption that full wavelength conversion is available throughout the network. In practice, however, economic and technical considerations are likely to dictate a more limited and sparse deployment of wavelength converters in the optical network. Therefore, we present a novel scheme for OBS networks, called logical cascaded private subnet (LCPN) with start wavelength assignment policy. We define the concept of canoe relative to cluster in self-similar traffic, and introduce a new device named payload segregator at the edge node as a gateway to the core node in OBS Networks. According to the changes in the edge node framework, we put forward the concept of cluster private subnet and canoe private subnet in the core node correspondingly. A new start wavelength assignment policy is proposed for the absence of (full) wavelength conversion capabilities in the core node of OBS Networks. The performance study indicates that, our new scheme is robust under self-similar traffic and wavelength continuity constraint.     

First Harmonic (2f) Characterisation of Resonant Frequency and Q-Factor of Micromechanical Transducers

In this paper, the response to the first harmonic component (2f) of the electrostatic force in single terminal driven electrostatic comb-drive and parallel-plate drive was used as a signal to extract device parameters, namely, the Q-factor and resonant frequency instead of the fundamental (1f) resonance response. It is shown that the difficulty in motional measurement due to electrical cross-talk (parasitics) using 1f measurement can be overcome with a higher signal-to-noise ratio of the 2f signal. Both atmospheric (low-Q) and reduced pressure environment were investigated using off-chip electronics and lock-in amplifier. The measurements were done on the electrostatic comb-drive and capacitive parallel plate sensing plates that form the two core modules of a yaw rate sensor (dual-axis resonator). The effects of AC and DC bias voltages on the measured response have been investigated. Experimental amplitude and phase response data have been analysed using the Lorentzian curve-fit, Resonance Curve Area (RCA) method, the half-power bandwidth method (3 dB) and the Nyquist plot for data fitting and determination of the Q-factor and resonance frequency.     

DSP在声频谱测井仪器中的应用

声频谱仪器是一种新型的数控全波列测井仪，采用DSP作为它的控制核心器件，以便实现对整个仪器的工作状态、数据采集及传输的控制，是声频谱测井仪器的核心部分。文章主要介绍DSP的芯片结构和性能、ADSP-2101在声频谱仪器控制系统中的功能及实现、声频谱仪器现场采集的接收全波列波形和结论。     

板载电源模块--开放式与封闭式的选择

目前,分布式电源架构被广泛用于通信和计算设备中,该电源架构经常采用板载电源(BMP)模块,在尽可能靠近负载点的地方进行电源变换.