A new space-vector-modulated control for a unidirectionalthree-phase switch-mode rectifier

A unidirectional three-phase switch-mode rectifier that delivers sinusoidal input currents in phase with the corresponding input phase voltages is proposed and analyzed in this paper. In the proposed topology, three AC switches are placed before the bridge rectifier and, respectively, across two power lines. A simple control scheme combing space-vector modulation and hysteresis current control is presented. Sinusoidal input line currents are observed in experimental results     

An analytical grain-barrier height model and its characterizationfor intrinsic poly-Si thin-film transistor

An analytical model for the grain-barrier height of the intrinsic poly-Si thin-film transistors (TFTs) is developed, in which the grain-barrier height for the applied gate voltage smaller than the threshold voltage is obtained by solving the charge neutrality equation and the grain-barrier height for the applied gate voltage larger than the threshold voltage is obtained by using the quasi-two-dimensional (2-D) method. Good agreements between experimental and simulation results are obtained for a wide gate voltage range     

Novel technique for SiO2 formed by liquid-phasedeposition for low-temperature processed polysilicon TFT

A technique for SiO₂ formation by liquid-phase deposition (LPD) at nearly room temperature for low-temperature processed (LTP) polysilicon thin-film transistor (poly-Si TFT) was developed. LPD SiO₂ film with a lower P-etch rate shows a dense structure. LPD SiO₂ also exhibits good electrical characteristics. LTP poly-Si thin-film transistors (TFTs) with LPD SiO ₂ as the gate insulator have been fabricated and investigated. Their characteristics indicate performance adequate for their use as pixel transistors in liquid crystal displays (LCDs)     

Comparison of Displacement and Mixing Diffusers

In order to cumpare the peformance of different supply diffuers of ventilation air, the airflow passern, temperature stratifiation and contaminant dispersion in a furnitured office ventilated by three kinds of air diffuer were numerically investigated. The air diffuers studied in this paper are a quarter-cylinder displacement diffuer on the floor and mixing diffuers (linear and vortex diffuers) on the ceiling. The heat sources in the of-fice are considered to be 50% convective and 50% radiative. The k-? two-equatwn model of turbulence is employed to predict the turbulent diffusion. The results show that the displacement diffuser provides a rather uniform flow field with low velocify in most areas, and the vertical temperature difference from floor to ceiling is as high as 6 K. With the linear diffuser, the air velociry is high, and the temperature is uniform both horizontally and vertically. The air velocity generated by the vortex diffuser is moderate. The distributions of the temperature and the contaminant are rather uniform.     

Multidimensional augmented current equation including velocityovershoot

The augmented drift-diffusion current equation, which includes velocity overshoot effects through the space derivatives of the electric field, cannot be directly extended beyond one dimension. A new formalism is developed which considers the carrier heating and the distribution relaxation effects to obtain a multidimensional augmented drift diffusion current equation. The equivalent mobility containing the velocity overshoot correction is derived from the perturbation analysis on the carrier temperature using the energy balance equation. The issues related to the numerical implementation of this generalized model and the validity of the assumptions are also discussed     

Electrical properties and positron annihilation study of (Ba<Subscript>1−<Emphasis Type="Italic">x</Emphasis></Subscript>Ho<Subscript><Emphasis Type="Italic">x</Emphasis></Subscript>)TiO<Subscript>3</Subscript> ceramics

DC resistivity, dielectric constant, dielectric loss and positron annihilation spectra of (Ba_1−x Ho _x )TiO₃ ceramics have been measured as a function of holmium concentration x. It has been found that the DC resistivity of (Ba_1−x Ho _x )TiO₃ is strongly dependent on the Ho content: it decreases three orders of magnitude and reaches a minimum at x = 0.4%. Doping with 0.6% holmium increases the permittivity of BaTiO₃ by approximately three times (from ∼1,300 to ∼4,000), with only a slight increase in the corresponding dielectric loss. The local electron density and defect concentration estimated using positron annihilation technique conforms well to the features found in the dielectric and resistivity measurements. The results have been discussed in terms of a mixed compensation model.     

60m高度处单片露天超高混凝土悬臂墙的设计与施工

通过采用竖向预应力技术 ,解决了 60m高度处单片 8m高悬臂钢筋混凝土墙根部裂缝宽度超过规范限值的问题 ;采用将预应力钢绞线顶端锚固于墙高中段等结构和施工措施 ,控制墙体长细比不超过 3 0 ,减少了由于长细比过大对墙体承载力的不利影响     

Coordinating Agents in Shop Floor Environments From a Dynamic Systems Perspective

In this paper, we address agent coordination from a dynamic systems perspective and propose a dynamic coordination model, which is inspired by biological metabolic systems. A new coordination mechanism through dynamic local adjustment (CDLA) is presented, and coordination is achieved when every agent utilizes explicitly the global system dynamics and performs iteratively a dynamic local adjustment procedure. The CDLA mechanism is investigated in an example multiagent shop floor system. The results show that the example manufacturing process is well-coordinated and the coordination approach is practically applicable and effective     

Modeling Power Supply Noise in Delay Testing

Excessive power supply noise during test can cause overkill. This article discusses two models for supply noise in delay testing and their application to test compaction. The proposed noise models avoid complicated power network analysis, making them much faster than existing power noise analysis tools. can cause performance degradation and