Structural,morphological, dielectric and magnetic properties of Zn-Zr co-doping yttrium iron garnet

In this study, yttrium iron garnet co-doped with Zn and Zr atoms with a chemical formula Y₃Zn_xZr_xFe_(5−2x)O₁₂ (x = 0.0-0.3) has been successfully prepared by the solid-state reaction method. The effects of doping concentration on the microstructure, crystal structure, magnetic properties, and dielectric properties of Y₃Zn_xZr_xFe_(5−2x)O₁₂ were investigated. The microstructure analysis indicates that co-doping of YIG with Zn and Zr can effectively reduce the grain size of the ceramic. The crystal structure results reveal that the doping concentration of Zn–Zr has substantial influence on the lattice parameters of YIG, such as, increases the lattice constant, crystal cell size, and interplanar spacing. However, the second phase of ZrO₂ appears once x ≥ 0.15. Additionally, the dielectric properties of YIG ferrite can be regulated using this Zn–Zr co-doping method. Zn–Zr co-doping can improve the dielectric stability and reduce the dielectric loss at high temperature. The magnetization measurement shows that the saturation magnetization is stabilized at x < 0.15, and the magnetic loss is decreased with the increase in the doping concentration. Overall, the findings show that the ceramic with x = 0.1 exhibits better properties included high saturation magnetization (24.607 emu/g), low magnetic loss (0.0025 @ 1 MHz), and relatively low dielectric loss (496 @ 400°C).     

Effects of ethylene-octene copolymer (POE) on the brittle to ductile transition of high-density polyethylene/POE blends

Three kinds of ethylene-octene copolymers (POE) were melt-blended with high-density polyethylene (PE-HD) in different proportions. Detailed characterizations were conducted to analyze their structural differences of POE and its effects in toughening PE-HD. The higher molecular weight POE can improve the toughness of PE-HD. 60:40 PE-HD/POE is elongated to break up to 700% while impact strength is 84.7 kJ/m² at −30°C, which is 21-fold of PE-HD. In the brittle to ductile transition (BDT) during impact, the fracture mechanism changes from the crazing mode to the shear yield-plastic deformation mode. The BDT temperature decreases as the POE molecular weight and its content increase. The interface strength in tension is estimated to access their effects. The Boltzmann-type models were successfully extended to describe the typical S-shaped curves in BDT of notched impact strength vs POE content or temperature. The supplementary decay model is suggested for the attenuation in toughening. Transition map in impact is proposed to select the use range of composition (c ) and temperature (T ) for high toughness. The curves are converted into 3D graph of T -c -impact strength for illustrating their coupling-separate effects, and further into the contour map of impact strength in T -c space for finding their partial equivalence.     

从7-ADCA生产过程中环境友好的回收苯乙酸

采用新工艺回收7-氨基-3-脱乙酰氧基头孢烷酸(7-ADCA)生产中产生的苯乙酸,并对苯乙酸回收过程中产生的废硫酸进行处理。采用硫酸(9 8%)洗涤二氯甲烷,硫酸与二氯甲烷适宜的体积比为1∶50,洗涤好的二氯甲烷中含苯乙酸4%。蒸馏出二氯甲烷,趁热向熔融苯乙酸中加入母液,降温析出苯乙酸。晾干的苯乙酸为白色鳞片状,含量大于99%,苯乙酸母液补充部分清水套用到下一批析出苯乙酸。废浓硫酸用芬顿试剂氧化,控制80℃氧化4h,双氧水和七水硫酸亚铁重量比为6∶1,废浓硫酸COD下降85%以上。氧化结束后向废硫酸中加入铁粉和双氧水,制得聚合硫酸铁。     

Tuning effect of silicon substitution on magnetic and high frequency electromagnetic properties of R2Fe17 and their composites

In this work, we report the tuning effect of the Si substitution on the magnetic and high frequency electromagnetic properties of R₂Fe₁₇ compounds and their paraffin composites. It is found that the introduction of Si can remarkably improve the magnetic and electromagnetic properties of the R₂Fe₁₇ compounds, making the R₂Fe_17–xSi_x-paraffin composites excellent microwave absorption materials (MAMs). By introducing the Si element, their saturation magnetizations decrease slightly, while much higher Curie temperatures are obtained. Furthermore, better impedance match is reached due to the decrease of the high-frequency permittivity ε′ by about 40%–50%, which finally enhances the performance of the microwave absorption. The peak frequency (f_RL) of the reflection loss (RL) curve moves toward high frequency domain and the qualified bandwidth (QB, RL ≤ ?10 dB) increases remarkably. The maximum QB of 3.3 GHz (12.0–15.3 GHz) is obtained for the Sm_1.5Y_0.5Fe₁₅Si₂-paraffin composite (d = 1.0 mm) and the maximum RL of ?53.6 dB is achieved for Nd₂Fe₁₅Si₂-paraffin composite (d = 2.2 mm), both surpassing most of the reported MAMs. Additionally, a distinguished dielectric microwave absorption peak is observed, which further increases the QB in these composites.     

Corrosion behavior of Cu–Sn bronze alloys in simulated archeological soil media

The corrosion behavior of synthetic Cu–Sn bronze alloys with six different Sn contents was examined through an electrochemical test and a synthetic test in a simulated corrosive medium. The mechanism of corrosion and the morphology of the corroded surfaces were characterized through field emission scanning electron microscopy equipped with energy-dispersive spectroscopy. At the corrosion potential, the corrosion behavior appears to be determined by the charge transfer step and the diffusion process. It was found that the bronze-IV (Cu–26.8Sn) specimen exhibited the best corrosion resistance, as evidenced by a low corrosion current density and a high impedance. This improvement resulted from an increase in the content of the Cu–Sn solid solution in the alloy, which was conducive to forming a relatively more protective passive film on the surface of the bronze alloy. This finding would be valuable in the anticorrosion protection of archeological artefacts after their excavation.     

以辉锑矿为原料放电等离子烧结快速制备黝铜矿Cu_(12)Sb_4S_(13)及反应机理

采用辉锑矿为原料成功制备出Cu_(12)Sb_4S_(13)块体。研究以Sb_2S_3矿物为原料时烧结工艺对Cu_(12)Sb_4S_(13)合成的影响。在400 ～ 440℃温度区间内均可快速合成Cu_(12)Sb_4S_(13)块体且二次烧结能够进一步减小中间相CuSbS_2和Cu_3SbS_3。第二相Cu_3SbS_4和残留相CuS随着烧结时间的延长而降低。二次烧结前进行机械化球磨处理,干磨比湿磨更容易减小残留相。初次烧结块体的断面SEM和EDS能谱分析表明内部存在Cu或Cu_2S颗粒团聚现象。适当降低Cu或CuS摩尔量(化学计量比0.1 mol)能促进烧结块表面反应进行。烧结过程中,硫磺蒸汽压的导致烧结块表面成分和内部粉末的成分不同。     

惠州东江水利枢纽变电站优化设计

文章结合广东省惠州东江水利枢纽工程的具体情况,对110 kV变电站进行了优化设计,通过对110 kV变电站采用敞开式布置、主变与GIS同平面布置、主变与GIS采用两层布置的三种不同设备选型及布置方式的技术和经济比较,推荐采用主变与GIS同平面的布置方案.GIS的使用,不仅满足电站运行可靠、灵活及运行维护方便等要求,而且也加快了施工进度,与周围的环境融合在一起,增添了工程的亮点.     

Service composition for generic service graphs

Service composition is a promising approach to multimedia service provisioning, due to its ability to dynamically produce new multimedia content, and to customize the content for individual client devices. Previous research work has addressed various aspects of service composition such as composibility, QoS-awareness, and load balancing. However, most of the work has focused on applications where data flow from a single source is processed by intermediate services and then delivered to a single destination. In this paper, we address the service composition problem for multimedia services that can be modeled as directed acyclic graphs (DAGs). We formally define the problem and prove its NP hardness. We also design a heuristic algorithm to solve the problem. Our simulation results show that the algorithm is effective at finding low-cost composition solutions, and can trade off computation overhead for better results. When compared with a hop-by-hop approach for service composition, our algorithm can find composition solutions that aress 10% smaller in cost, even when the hop-by-hop approach uses exhaustive searches.     

Popular biorthogonal wavelet filters via a lifting scheme and its application in image compression

A technique using a lifting scheme is presented for constructing compactly supported wavelets whose coefficients are composed of free variables locating in an interval. An efficient approach-based wavelet for image compression is developed by selecting the coefficients of the 9-7 wavelet filter and associated lifting scheme. Furthermore, the rationalised coefficients wavelet filter that can be implemented with simple integer arithmetic is achieved and its characteristic is close to the well known original irrational coefficients 9-7 wavelet filters developed by A. Cohen et al. (Commun. Pure Appl. Maths., vol.45, no.1, p.485-560, 1992). To reduce the computational cost of image coding applications further, an acceleration technique is proposed for the lifting steps. Software and hardware simulations show that the new method has very low complexity, and simultaneously preserves the high quality of the compressed image.     

Ru/MCM-41催化剂上苯的液相加氢反应

 以Si-MCM-41、Al-MCM-41(1) (n(Si)/n(Al)=15)、Al-MCM-41(2) (n(Si)/n(Al)=10)以及用NH4NO3或HAc的醇溶液分别与Si-MCM-41离子交换所得的H-MCM-41(N)和H-MCM-41(H)为载体制备了系列Ru/MCM-41催化剂。采用N2吸附、XRD和H2-TPR表征了负载Ru前后催化剂的结构及Ru在各种载体表面上的分散状态。以0.5%（质量分数）苯的环己烷溶液为模型化合物，在298K、3.0MPa反应条件下，考察了上述催化剂的苯液相加氢反应性能，并与Ru/HY、Ru/H&#61538;和Pt/MCM-41催化剂进行了比较。结果表明，载体MCM-41的n(Si)/n(Al)和表面化学组成等性质对Ru在其表面上的分散状态、还原性及催化性能均有影响。对苯的转化率与反应时间的关系曲线进行拟合，发现其遵循一级动力学方程，加氢反应速率常数按照Ru/Al-MCM-41(2)相似文献