Polyvinylidene fluoride and polyetherimide hollow fiber membranes for CO2 stripping in membrane contactor

Porous polyvinylidene fluoride (PVDF) and polyetherimide (PEI) hollow fiber membranes incorporating polyethylene glycol (PEG) were prepared via spinning process for CO₂ membrane stripping. CO₂ loaded diethanolamine solution was used as liquid absorbent while N₂ was used as a strip gas. The characterization study of the fibers was carried out in terms of permeation test, contact angle measurement and liquid entry pressure (wetting pressure). Performance study via membrane contactor stripping was carried out at specific operating condition. The experimental results showed that PVDF membrane have high gas permeation, effective surface porosity and contact angle despite having lower liquid entry pressure in comparison with PEI membrane. PVDF-PEG membrane showed the highest stripping flux of 4.0 × 10⁻² mol m⁻² s⁻¹ at 0.7 ms⁻¹ compared to that of PEI membrane. Although the stripping flux for PEI-PEG membranes was slightly lower than PVDF membrane (e.g. 3.5 × 10⁻² mol m⁻² s⁻¹ at liquid velocity of 0.85 ms⁻¹), the membrane wetting pressure of PEI membrane is higher than hydrophobic PVDF membrane. Long term performance of both membranes showed severe flux reduction but started to level-off after 30 h of operation.     

Determination of four priority polycyclic aromatic hydrocarbons (4PAHs) by GC-MS in traditional Turkish yoghurts

ABSTRACT

Polycyclic aromatic hydrocarbons (PAHs) are ingested with foods and cause toxicities for humans. Yoghurt is one of the main foods that mediate PAH ingestion. Yan?k yoghurt, a traditional strained yoghurt, can contain PAHs due to its production process. Therefore, the concentration and types of four polycyclic aromatic hydrocarbons were determined by gas chromatography-mass spectrometry (GC-MS). Yan?k yoghurt samples were collected from different shops in Denizli, Turkey. For the method validation, the Eurachem guide (second edition) was adopted. Accordingly, linearity, working range, limits of detection (LOD), quantification (LOQ), precision and trueness values were set. Due to the selected validation parameters, the limit for detection was between 0.03 ng g^?1and 0.05 ng g^?1while the limit for quantification was between 0.10 ng g^?1 and 0.16 ng g^?1. Recovery rates higher than 83.80 % were obtained for four PAHs at two spiked concentrations (2.0 and 5.0 ng g^?1). Five Yan?k yoghurt samples and one commercial concentrated yoghurt sample were successfully analysed using the validated method.     

Drying Kinetics,Texture, Color,and Determination of Effective Diffusivities During Sun Drying of Chempedak

Sun drying of chempedak (Artocarpus integer) was carried out on different sample sizes to investigate the effects on product quality. Fick's second law model was used to determine the effective diffusivities of sun–dried chempedak slabs based on the drying rate versus moisture content plots. In addition, texture degradation and total color changes were investigated. The texture and color changes of dried chempedak were relatively significant (p < 0.05) compared to fresh chempedak. There was an increase in dried fruit hardness and chewiness but a decrease in springiness and cohesiveness during drying.     

The effect of magnetic and optic field in water electrolysis

Hydrogen production via water electrolysis was studied under the effect of magnetic and optical field. A diode solid state laser at blue, green and red were utilized as optical field source. Magnetic bar was employed as external magnetic field. The green laser has shown a greatest effect in hydrogen production due to its non-absorbance properties in the water. Thus its intensity of electrical field is high enough to dissociation of hydronium and hydroxide ions during orientation toward polarization of water. The potential to break the autoprotolysis and generate the auto-ionization is the mechanism of optical field to reveal the hydrogen production in water electrolysis. The magnetic field effect is more dominant to enhance the hydrogen production. The diamagnetic property of water has repelled the present of magnetic in water. Consequently the water splitting occurs due to the repulsive force induced by the external magnetic field. The magnetic distributed more homogenous in the water to involve more density of water molecule. As a result hydrogen production due to magnetic field is higher in comparison to optical field. However the combination both fields have generated superior effect whereby the hydrogen yields nine times higher in comparison to conventional water electrolysis.     

Hollow micro-mesoporous carbon polyhedra produced by selective removal of skeletal scaffolds

An approach has been demonstrated for fabricating hollow micro-mesoporous carbon polyhedra by selective removal of the skeletal scaffolds of polyurethane (PU) foam in monolithic mesostructured resin/PU composites. Hollow micro-mesoporous carbon polyhedra with an irregular shape molded from the cellular cavities of PU foam were synthesized by using phenolic resol as a precursor, triblock copolymer Pluronic F127 as a template, PU foam as a skeletal scaffold and triethyl phosphate as a reaction agent. By a reaction with triethyl phosphate, the PU foam in resin/PU composites can be degraded, simultaneously leading to the disassembly of the monolithic structure into separated polyhedral particles. The method can also be used for synthesizing hollow micro-mesoporous carbon–silica polyhedra, using tetraethyl orthosilicate as a silica source. Moreover, after etching the silica away, hollow micro-mesoporous carbon polyhedra with an ordered hexagonal mesostructure (space group p6mm), large particle sizes of 65–500 μm, a large surface area of 1384 m² g^?1, a uniform pore size of 3.2 nm and a high pore volume of 1.15 cm³ g^?1 as well as a high mesoporosity of 81% can be obtained, which exhibits excellent adsorption performance toward methylene blue compared with the active carbon having a similar surface area.     

Correct Prediction of the Vibration Behavior of a High Power Ultrasonic Transducer by FEM Simulation

This paper presents a study on three types of finite element analyses of high power ultrasonic transducer by using the finite element commercial software called ANSYS. The transducer geometry was treated as a 2D axi- symmetric model, 3D quart and full 3D model. For all of the simulations the modeled transducer was used in modal analysis and harmonic solutions to understand its mechanical behavior and its natural frequency. A comparison was made between each type of modeling and experimental results. This comparison allows the parameters of FEM models to be iteratively adjusted and optimized and also leads to selection of the best modeling type. The achieved FEM results exhibited a remarkably high predictive potential of ANSYS in modeling and simulation and allowed control on the design and on the vibration behavior of the high power ultrasonic transducer.     

Differential Metabotypes in Synovial Fibroblasts and Synovial Fluid in Hip Osteoarthritis Patients Support Inflammatory Responses

Changes in cellular metabolism have been implicated in mediating the activated fibroblast phenotype in a number of chronic inflammatory disorders, including pulmonary fibrosis, renal disease and rheumatoid arthritis. The aim of this study was therefore to characterise the metabolic profile of synovial joint fluid and synovial fibroblasts under both basal and inflammatory conditions in a cohort of obese and normal-weight hip OA patients. Furthermore, we sought to ascertain whether modulation of a metabolic pathway in OA synovial fibroblasts could alter their inflammatory activity. Synovium and synovial fluid was obtained from hip OA patients, who were either of normal-weight or obese and were undergoing elective joint replacement surgery. The synovial fluid metabolome was determined by 1H NMR spectroscopy. The metabolic profile of isolated synovial fibroblasts in vitro was characterised by lactate secretion, oxygen consumption rate (OCR) and extracellular acidification rate (ECAR) using the Seahorse XF Analyser. The effects of a small molecule pharmacological inhibitor and siRNA targeted at glutaminase-1 (GLS1) were assessed to probe the role of glutamine metabolism in OA synovial fibroblast function. Obese OA patient synovial fluid (n = 5) exhibited a different metabotype, compared to normal-weight patient fluid (n = 6), with significantly increased levels of 1, 3-dimethylurate, N-Nitrosodimethylamine, succinate, tyrosine, pyruvate, glucose, glycine and lactate, and enrichment of the glutamine–glutamate metabolic pathway, which correlated with increasing adiposity. In vitro, isolated obese OA fibroblasts exhibited greater basal lactate secretion and aerobic glycolysis, and increased mitochondrial respiration when stimulated with pro-inflammatory cytokine TNFα, compared to fibroblasts from normal-weight patients. Inhibition of GLS1 attenuated the TNFα-induced expression and secretion of IL-6 in OA synovial fibroblasts. These findings suggest that altered cellular metabolism underpins the inflammatory phenotype of OA fibroblasts, and that targeted inhibition of glutamine–glutamate metabolism may provide a route to reducing the pathological effects of joint inflammation in OA patients who are obese.     

Chemical Profile and Biological Activities of Two Edible Plants: Chemical Investigation and Quantitative Analysis Using Liquid Chromatography Tandem Mass Spectrometry and Gas Chromatography Mass Spectrometry

The objectives of this study were to define the phenolic and fatty acid profiles, anticholinesterase, antioxidant, antimicrobial activities, and total phenolic-flavonoid contents of Lycopsis orientalis and Tragopogon latifolius var. angustifolius which have been used as food source and food supplement in Anatolia and have never been examined before. Rosmarinic and quinic acids (21.11 and 11.46 mg g^–1 extract, respectively) were found to be the most abundant constituents in L. orientalis and T. latifolius var. angustifolius among the studied 27 compounds by liquid chromatography tandem mass spectrometry. In the fatty acid compositions of L. orientalis and T. latifolius var. angustifolius that were determined by gas chromatography mass spectrometry, oleic (29.1%) and palmitic (28.7%) acids were identified as the major components, respectively. The high antioxidant activity of the methanol extract of L. orientalis shows parallelism to its rosmarinic acid content. Besides, this extract showed medium anticholinesterase activity. The results of the present study proves that the L. orientalis might also be used as a food source due to its high phenolic acid content and strong antioxidant property.     

Constrained model predictive control of proton exchange membrane fuel cell

A constrained model predictive control (MPC) is designed to regulate the air flow rate of proton exchange membrane fuel cell (PEMFC). Oxygen excess ratio, compressor flow rate and supply manifold pressure are constrained to avoid oxygen starvation, surge and choke phenomena. This is achieved by manipulating compressor voltage and stack current. The choice of the manipulated input to satisfy a constraint is investigated. Surge and choke avoidance is successful, when compressor voltage is manipulated. When stack current is utilized to satisfy surge and choke constraints, a large unrealistic current is needed. Oxygen starvation is successfully avoided utilizing stack current, while compressor voltage manipulation fails to prevent oxygen starvation. Thus, a current governor is implemented to handle oxygen starvation, while the compressor voltage is constrained to avoid surge and choke. Quadratic programming optimization, Laguerre and exponential weight function are employed to reduce the computational burden of the controller. The simulation results prove that the proposed controller managed to satisfy all constraints without any conflict.