基于虚拟仪器的现代温度检测系统的研究

对一个基于虚拟仪器的现代温度检测系统进行了系统的论述，并给出了具体实现方案及结果。     

低渗低温低压水敏性储气层压裂改造技术研究与应用

低渗低温低压水敏性储气层因压裂液快速破胶困难、黏土膨胀水敏伤害严重和压后压裂液返排动力不足等因素，使得压裂增产面临诸多难题。针对上述难题进行了技术攻关，形成了弱交联、低温活化剂与超量破胶剂的低温储层快速破胶技术、有机盐与无机盐双元体系复合防膨技术以及高比例液氮全程助排的排液技术。该压裂增产改造技术使牛101井头屯河组首次获得工业油气流，扩展了三塘湖盆地勘探空间。     

岩石圈深部温度压力条件下褐煤与水的热模拟研究

在压力高达1—3GPa、温度为400—700℃的条件下，在密闭体系中进行了褐煤加水的模拟实验。分析了实验产物中液态烃的变化规律，并讨论了压力、温度及恒温时间对有机质演化的影响。实验结果表明，热模拟液态产物氯仿沥青“A”的有机碳含量为0．91％-2．55％，2GPa条件下其高峰值后移至700℃，说明高压抑制了液态烃的生成，同时压力升高有利于有机质降解产物的环化、聚合和芳构化。在400—600℃条件下，温度升高或恒温时间增长，OEP和Pr／Ph值均减小；而在700℃的恒温条件下，压力增高，OEP和Pr／Ph值均增大。说明有机质的成熟度与温度和加热时间成正相关，而压力增加抑制了有机质的成熟演化。在高压条件下，芳烃演化的主要趋势是甲基化作用，压力升高有利于甲基化反应和甲基重排。     

A new detection algorithm (NDA) based on fuzzy cellular neural networks for white blood cell detection.

White blood cell detection is one of the most basic and key steps in the automatic recognition system of white blood cells in microscopic blood images. Its accuracy and stability greatly affect the operating speed and recognition accuracy of the whole system. But there are only a few methods available for cell detection or segmentation due to the complexity of the microscopic images. This paper focuses on this issue. Based on the detailed analysis of the existing two methods--threshold segmentation followed by mathematical morphology (TSMM), and the fuzzy logic method--a new detection algorithm (NDA) based on fuzzy cellular neural networks is proposed. NDA combines the advantages of TSMM and the fuzzy logic method, and overcomes their drawbacks. With NDA, we can detect almost all white blood cells, and the contour of each detected cell is nearly complete. Its adaptability is strong and the running speed is expected to be comparatively high due to the easy hardware implementation of FCN. Experimental results show good performance.     

弯曲性分叉河道中污染物扩散性的初步研究

弯曲性分叉河道中水流特征复杂,对污染物扩散有很大影响。为了定量分析其水流特征对污染物扩散的影响,采用有限元方法求解弯曲性分叉河道中的污染物扩散数学模型,研究其中污染物扩散的状况。主要针对河道回流、绕流对污染物扩散的影响进行了详细数值模拟计算,并分别给出了可视化结果及平均的扩散距离。计算结果表明:边界层稍微减弱污染物的扩散,弯道分离使污染物扩散呈现多向扩散,而回流和绕流尾迹区使污染物很难扩散,从而有利于泄漏污染物的收集和集中治理。     

炼油厂碱性污水生物催化氧化预处理工艺研究

在对炼油厂碱性污水水质分析的基础上,提出采用生物催化氧化工艺对碱性污水进行预处理。试验结果表明,在水力停留时间为4 h,曝气量(标准状态)为8 m3／h的条件下,碱性污水的硫化物去除率可达90％以上,出水中的硫化物平均值为15．2 mg/L,CODCR、酚和油的去除率分别为47．5％,44．1％,50．8％,其中CODCR体积负荷为3．85 kg／(m3·d),是传统生化处理的10倍, 达到了污水预处理的目的。     

TEM Studies of High Temperature Corrosion Behaviour of TiAl Intermetallics with Surface Modifications

The oxidation/sulphidation behaviour of a Ti‐46.7Al‐1.9W‐0.5Si alloy with a TiAl₃ diffusion coating was studied in an environment of H₂/H₂S/H₂O at 850^oC. The kinetic results demonstrate that the TiAl₃ coating significantly increased the high temperature corrosion resistance of Ti‐46.7Al‐1.9W‐0.5Si. The SEM, EDX, XRD and TEM analysis reveals that the formation of an Al₂O₃ scale on the surface of the TiAl₃‐coated sample was responsible for the enhancement of the corroison resistance. The Ti‐46.7Al‐1.9W‐0.5Si alloy was also modified by Nb ion implantation. The Nb ion implanted and as received sampels were subjected to cyclic oxidation in an open air at 800^oC. The Nb ion implantation not only increased the oxidation resistance but also substantially improved the adhesion of scale to the substrate.     

原油基压裂液研究

研制了一种适用于低压、低渗、水敏性储集层的新型原油基压裂液体系。根据基液原油的组分合成相应的增稠剂，增稠剂在原油中与交联剂反应，形成网状结构，使原油成为黏度可以调控的冻胶，从根本上改变了油基压裂液以柴油、煤油为基液的现状，降低了油基压裂液的成本，同时还提高了压裂液的抗温、抗剪切和破胶性能，并将交联时间缩短到2h以内，可以满足现场压裂施工的要求，大大降低了施工强度和压裂改造的综合成本。在青海油田进行的现场先导试验取得成功。图9表1参5