Formation of low-resistivity poly-Si and SiNx films by Cat-CVD for ULSI application

In this paper, bulk-Si metal–oxide–semiconductor field effect transistors (MOSFETs) are fabricated using the catalytic chemical vapor deposition (Cat-CVD) method as an alternative technology to the conventional high-temperature thermal chemical vapor deposition. Particularly, formation of low-resistivity phosphorus (P)-doped poly-Si films is attempted by using Cat-CVD-deposited amorphous silicon (a-Si) films and successive rapid thermal annealing (RTA) of them. Even after RTA processes, neither peeling nor bubbling are observed, since hydrogen contents in Cat-CVD a-Si films can be as low as 1.1%. Both the crystallization and low resistivity of 0.004 Ω·cm are realized by RTA at 1000 °C for only 5 s. It is also revealed that Cat-CVD SiN_x films prepared at 250 °C show excellent oxidation resistance, when the thickness of films is larger than approximately 10 nm for wet O₂ oxidation at 1100 °C. It is found that the thickness required to stop oxygen penetration is equivalent to that for thermal CVD SiN_x prepared at 750 °C. Finally, complementary MOSFETs (CMOSs) of single-crystalline Si were fabricated by using Cat-CVD poly-Si for gate electrodes and SiN_x films for masks of local oxidation of silicon (LOCOS). At 3.3 V operation, less than 1.0 pA μm⁻¹ of OFF leakage current and ON/OFF ratio of 10⁷–10⁸ are realized, i.e. the devices can operate similarly to conventional thermal CVD process.     

New low-noise output amplifier for high-definition CCD image sensor

A new low-noise charge-coupled-device (CCD) output amplifier, the RJG detector, has been developed. The RJG detector incorporates a JFET which has an electrically floating ring-junction gate (RJG). The operating principle of the amplifier is that signal charges, transferred from the CCD into the RJG, directly modulate the drain current in the detection JFET. The performance of the detector was evaluated by operating test devices under a 37-MHz clock frequency, which is the same frequency as that for the horizontal CCD operation in the recently developed 2-million-pixel high-definition CCD image sensor. It was found that 1/f noise was reduced by introducing the JFET and that reset noise was completely eliminated by achieving complete charge transfer through the reset operation. As a result, input referred noise equivalent electrons within the 18.5-MHz baseband were reduced to 17 (electrons)     

Rapid determination of the membrane potential of mitochondria in small biopsy specimens of the liver

In liver transplantation, graft viability is ideally to be determined before implantation. Integrity of mitochondria may be a prerequisite to a viable graft. A new method is presented, which allows for the determination of the membrane potential of mitochondria (MPM; mV) in state 4 respiration within 50 min in 40-mg specimens, employing rhodamine 123 as a probe. Normal control showed a MPM of 239.2 mV. Storage in saline at 37 degrees C yielded an impaired MPM of 153.5 mV within 3 h. The cold storage at 1 degree C could preserve MPM at quasi-normal after 3 h but reduced it significantly after 24 h to 222.2 mV in saline (p < 0.005 vs. control) and 231.0 mV in UW solution (p < 0.05 vs. control): the difference between the 24-hour values was significant (p < 0.05).     

Effects of lamotrigine and conventional antiepileptic drugs on amygdala- and hippocampal-kindled seizures in rats

A computer aided monitor-data processing system (CAMP-System) was developed in order to get a consistent and comprehensive database which can very precisely reflect intra-operative haemodynamic courses. The goal of the present study was to introduce a new method to scan and to gauge haemodynamic courses and to demonstrate its superiority over the traditional way of data processing based on a handwritten anaesthesia protocol. METHODS: The computerized system was applied to a study which was designed to investigate the influence of ketanserin (K) vs. urapidil (U) on haemodynamic stability during cardiac operations. Twenty male patients scheduled for myocardial revascularization received either 20 mg K or 30 mg U. Heart rate, central venous, arterial and pulmonary artery pressures were measured and on-line recorded every 20 seconds by the computer record system. In the handwritten protocol these variables were registered at eight pre-defined time points. Computerized data processing (including artifact depletion and data condensation) was compared to the results evaluated from the handwritten protocol. RESULTS: While the only significant differences in the handwritten protocol were slightly higher values of pulmonary artery pressures in group K, the computer analysis revealed a number of further differences. Higher maximum and a less stable time course of HR in group K in the pre-bypass phase and lower mean and standard deviation of MAP during cardiopulmonary bypass. CONCLUSION: Computerized data processing including automatic artifact suppression and data condensation was able to reveal differences in the course of haemodynamic variables that cannot be detected in a conventional handwritten protocol.     

Detection of a tryptophan radical as an intermediate species in the reaction of horseradish peroxidase mutant (Phe-221 --> Trp) and hydrogen peroxide

The crucial reaction intermediate in the reaction of peroxidase with hydrogen peroxide (H2O2), compound I, contains a porphyrin pi-cation radical in horseradish peroxidase (HRP), which catalyzes oxidation of small organic and inorganic compounds, whereas cytochrome c peroxidase (CcP) has a radical center on the tryptophan residue (Trp-191) and oxidizes the redox partner, cytochrome c. To investigate the roles of the amino acid residue near the heme active center in discriminating the function of the peroxidases in these two enzymes, we prepared a CcP-like HRP mutant, F221W (Phe-221 --> Trp). Although the rapid spectral scanning and stopped-flow experiments confirmed that the F221W mutant reacts with H2O2 to form the porphyrin pi-cation radical at the same rate as for the wild-type enzyme, the characteristic spectral features of the porphyrin pi-cation radical disappeared rapidly, and were converted to the compound II-type spectrum. The EPR spectrum of the resultant species produced by reduction of the porphyrin pi-cation radical, however, was quite different from that of compound II in HRP, showing typical signals from a Trp radical as found for CcP. The sequential radical formation from the porphyrin ring to the Trp residue implies that the proximal Trp is a key residue in the process of the radical transfer from the porphyrin ring, which differentiates the function of peroxidases.     

Fault tolerant approach for biosignal-based robot control

This paper proposes a fault tolerant framework for biosignal-based robot control with multiple sensor electrodes. In this approach, to cope with sensor faults, a reliable joint torque estimation model is selected from a group of estimation models based on sensor failure classifiers. The correlation among the electromyography (EMG) signal streams is used as input feature vectors for fault detection. To validate our proposed method, we artificially disconnect an EMG electrode or detach one side of an EMG probe from the skin surface during elbow-joint torque estimation experiments with five participants. When one EMG sensor electrode experiences one of the problems, the experimental results show that the joint torque can be estimated with significantly fewer errors using our proposed approach than a joint torque estimation method without sensor fault detection or than a method with a conventional sensor fault detection algorithm. Furthermore, we controlled a mannequin-arm-attached one-DOF exoskeleton based on the estimated torque profiles by generating movements with the estimated torque derived from the selected model.     

The Somatropin Reference Standard (Control 951) of the National Institute of Health Sciences

Somatropin material was examined for preparation of the "Somatropin Reference Standard". The candidate material was evaluated by a domestic collaborative study in which eight laboratories participated. The protein content was determined to be 4.5 mg/Vial based on amino acid analysis. Because of the possibility of application as a chemical reference standard for assay by the HPLC method, a physico-chemical evaluation of the candidate material was also performed. By SE-HPLC, the content of polymer, dimer were determined to be 0.54%, 0.98%, respectively. By RP-HPLC, the early peak area ascribed to desamido and sulfoxide form was 1.07% of the total peak area. And for informational data, the potency of the candidate material, being estimated by three different biological methods, weight gain assay, tibia test and adiposeconversion assay is 14.8 IU/vial. Based on the above results, the candidate was authorized as the Somatropin Reference Standard of the National Institute of Health Sciences.     

Color restoration method based on spectral information using normalized cut

This paper proposes a novel method for color restoration that can effectively apply accurate color based on spectral information to a segmented image using the normalized cut technique. Using the proposed method, we can obtain a digital still camera image and spectral information in different environments. Also, it is not necessary to estimate reflectance spectra using a spectral database such as other methods. The synthesized images are accurate and high resolution. The proposed method effectively works in making digital archive contents. Some experimental results are demonstrated in this paper.     

Interior permanent magnet linear synchronous motor forhigh-performance drives

Permanent magnet linear synchronous motors have been developed for factory automation, transportation applications, and so on. In the rotary-type permanent magnet synchronous machines, the wide speed and constant power operation are realized by using the reluctance torque due to the saliency and the flux-weakening control. In this paper, we examine the effect of the interior permanent magnet arrangement for wide speed operation and the end effect in the linear structure