Influence of chromium on the local structure and morphology of ferric oxyhydroxides

The extended X-ray absorption fine structure (EXAFS) method and transmission electron microscopy (TEM) have been used for characterizing the local structure and morphology of ferric oxyhydroxides, α-FeOOH and γ-FeOOH, with and without chromium. These ferric oxyhydroxide powders were prepared from aqueous solutions containing iron and chromium ions. Radial structural functions for iron obtained by Fe K edge EXAFS spectra showed that the linkage of structural units formed by FeO₆ octahedra in γ-FeOOH is distorted by chromium addition, while such distortion in α-FeOOH is not clearly detected. On the other hand, Cr K edge EXAFS spectra showed that the local structure around chromium does not necessarily correspond to the local structure around of iron, which is observed by Fe K edge EXAFS spectra. This suggests that the structural units containing iron and chromium are heterogeneously distributed in these ferric oxyhydroxides. The local structural information was discussed coupled with morphological features of these ferric oxyhydroxides observed by TEM.     

Linearized method: A new approach for kinetic analysis of central dopamine D(2) receptor specific binding

We proposed a new method (;linearized method') to analyze neuroleptic ligand-receptor specific binding in a human brain using positron emission tomography (PET). We derived the linear equation to solve four rate constants, k(3), k(4), k(5), k(6) from PET data. This method does not demand a radioactivity curve in plasma as an input function to the brain, and can perform fast calculations in order to determine rate constants. We also tested the nonlinearized method including nonlinear equations which is a conventional analysis using plasma radioactivity corrected for ligand metabolites as an input function. We applied these methods to evaluate dopamine D(2) receptor specific binding of [(11)C] YM-09151-2. The value of B(max)/K(d)=k(3)/k (4) obtained by the linearized method was 5.72+/-3.1 which was consistent with the value of 5.78+/-3.4 obtained by the nonlinearized method.     

Analysis of neutron yield produced by high-energy proton

Comparisons have been made between computational results obtained with the BNL code system and experimental data measured by Vasfl'kov et al. for 56 x 56 x 64 cm natural and depleted uranium blocks surrounded by lead walls and primary proton energies of 400 and 660 MeV. The energetic protons from a linear accelerator are used to produce an intensive neutron source inthe uraniumblocko The computercode system prepared at BNL to perform nuclear design analyses of linear accelerator reactors consists of six main programs: NMTC for spallation-evaporation processes above 15 MeV, HIST3D for the analysis of collision event records obtained by NMTC to get P₃ neutron source distribution, DLC-2 to compile 100 energy group cross sections, TAPEMAKER for format conversion, ANISN to collapse 100 group cross sections to fewer group P₃ cross section sets, and the principal code TWOTRAN-II which performs neutron reaction and transport calculations in the energy range below 15 MeV. Our computational method gives conservative total neutron yields, i.e., underestimates of about 16.8–29.8% in comparison with measured values depending on proton energy. Radiative capture²³⁸U(n,) density distributions have been compared between the calculation and experiment. The calculated distribution has the higher peak in the central part of the target system and the steeper gradient both in the r and z directions.Brookhaven National Laboratory, Upton, New York 11973. Published in Atomnaya Énergiya, Vol. 47, No. 2, pp. 83–91, August, 1979.     

Transfection of glutathione S-transferase (GST)-pi antisense complementary DNA increases the sensitivity of a colon cancer cell line to adriamycin, cisplatin, melphalan, and etoposide

The goal of this study was to demonstrate that glutathione S-transferase (GST)-pi is directly involved in the intrinsic and acquired resistance of cancer cells to anticancer drugs. To this end, GST-pi antisense cDNA was transfected into the cultured human colon cancer cell line M7609, which expresses an innately high level of GST-pi and shows intrinsic drug resistance, and into an M7609 strain with acquired resistance to Adriamycin (ADR;i.e., M7609/ADR cells). The changes in the sensitivity of these transfectants to various anticancer drugs were investigated. The intracellular concentrations of GST-pi in M7609/anti-1 cells and M7609/anti-2 cells, two clones that were established by transfection of GST-pi antisense cDNA into M7609 cells, were decreased to approximately half of those detected in the parent cells (M7609) and in the control cells transfected with vector alone (M7609/pLJ). The sensitivities of the antisense transfectants in relation to ADR, cisplatin, melphalan, and etoposide were increased -3.3-fold, 2.3-fold, 2.2-fold, and 2.1-fold, respectively, compared with those of M7609 and M7609/pLJ. On the other hand, the sensitivities of the antisense transfectants to Taxol, vincristine, 5-fluorouracil, and mitomycin C were not significantly changed. Similarly, the transfection of antisense cDNA into M7609/ADR cells resulted in the reduction of intracellular GST-pi concentration (by about half) and an increased sensitivity to ADR (4.4-fold), but no increase in 5-fluorouracil sensitivity. Thus, GST-pi is considered to be a multidrug resistance factor that is responsible for both the intrinsic and acquired resistance of cancer cells to anticancer drugs such as ADR, cisplatin, melphalan, and etoposide.     

Properties of Starch Films and their Improvement

The tensile strengths and elongations of starch films prepared from various unmodified and modified starches were measured. These properties were improved by addition of urea and polyvinyl alcohol to the starch paste. The results obtained were as follows.

• 1 The heating temperature greatly affected the tensile strength and elongation of various unmodified starches. Potato starch gave the best film.
• 2 Introduction of hydroxyethyl groups into corn starch had unexpectedly little affect on the properties of the films.
• 3 A combination of hydroxyethylation and acid-modification slightly improved the properties of the films.
• 4 No film could be obtained after combinations of hydroxyethylation and hypochlorite-oxidation, pyrodextrinization or α-amylase-dextrinization. However, addition of urea to these modified starches resulted in good films.
• 5 On addition of urea the elongation of starch films increased and the pastes adhered uniformly to water repellent surfaces.
• 6 A film with the best properties was prepared from a mixture of 67% acid-modified hydroxyethyl starch, 13% urea and 20% polyvinyl alcohol.

     

Sulfated Hyaluronan Binds to Heparanase and Blocks Its Enzymatic and Cellular Actions in Carcinoma Cells

We examined whether sulfated hyaluronan exerts inhibitory effects on enzymatic and biological actions of heparanase, a sole endo-beta-glucuronidase implicated in cancer malignancy and inflammation. Degradation of heparan sulfate by human and mouse heparanase was inhibited by sulfated hyaluronan. In particular, high-sulfated hyaluronan modified with approximately 2.5 sulfate groups per disaccharide unit effectively inhibited the enzymatic activity at a lower concentration than heparin. Human and mouse heparanase bound to immobilized sulfated hyaluronan. Invasion of heparanase-positive colon-26 cells and 4T1 cells under 3D culture conditions was significantly suppressed in the presence of high-sulfated hyaluronan. Heparanase-induced release of CCL2 from colon-26 cells was suppressed in the presence of sulfated hyaluronan via blocking of cell surface binding and subsequent intracellular NF-κB-dependent signaling. The inhibitory effect of sulfated hyaluronan is likely due to competitive binding to the heparanase molecule, which antagonizes the heparanase-substrate interaction. Fragment molecular orbital calculation revealed a strong binding of sulfated hyaluronan tetrasaccharide to the heparanase molecule based on electrostatic interactions, particularly characterized by interactions of (−1)- and (−2)-positioned sulfated sugar residues with basic amino acid residues composing the heparin-binding domain-1 of heparanase. These results propose a relevance for sulfated hyaluronan in the blocking of heparanase-mediated enzymatic and cellular actions.     

On-line control of feed-speed in circular sawing

An adaptive control optimization system was developed to produce a desired surface finish roughness by automatic control of the work-piece feed-rate in circular sawing. The system developed in this study consists of the interconnection of an adaptive controller with a numerically controlled circular saw. The AE signals and cutting forces were measured to monitor the machining process continuously in this system. The signals were provided to the adaptive controller to evaluate the surface finish roughness and adjust the workpiece feed-rate automatically in the machining process. Sensing of AE signals and of cutting forces was compared to determine which technique is more convenient. Experiments were carried out with a carbide-tipped circular saw. Cross cutting was done with counter-cutting during the experiments. The cutting parameters controlled were workpiece feed-rates and cutting speeds. Japanese beech (Fagus crenata Blume) and Yezo spruce (Picea jezoensis Carr.) were used as the workpiece. Experimental results indicated that adaptive control optimization took place in the system developed for circular sawing. The desired surface finish roughness was produced by automatic control of the workpiece feed-rate using the sensing technique of AE signals as well as that of cutting force. However, the system using AE signals is more convenient than taht using cutting force.