A CMOS multichannel 10-Gb/s transceiver

We describe a CMOS multichannel transceiver that transmits and receives 10 Gb/s per channel over balanced copper media. The transceiver consists of two identical 10-Gb/s modules. Each module operates off a single 1.2-V supply and has a single 5-GHz phase-locked loop to supply a reference clock to two transmitter (Tx) channels and two receiver (Rx) channels. To track the input-signal phase, the Rx channel has a clock recovery unit (CRU), which uses a phase-interpolator-based timing generator and digital loop filter. The CRU can adjust the recovered clock phase with a resolution of 1.56 ps. Two sets of two-channel transceiver units were fabricated in 0.11-/spl mu/m CMOS on a single test chip. The transceiver unit size was 1.6 mm /spl times/ 2.6 mm. The Rx sensitivity was 120-mVp-p differential with a 70-ps phase margin for a common-mode voltage ranging from 0.6 to 1.0 V. The evaluated jitter tolerance curve met the OC-192 specification.     

High resistivity measurement of SiC wafers using different techniques

To establish fast, nondestructive, and inexpensive methods for resistivity measurements of SiC wafers, different resistivity-measurement techniques were tested for characterization of semi-insulating SiC wafers, namely, the four-point probe method with removable graphite contacts, the van der Pauw method with annealed metal and diffused contacts, the current-voltage (I-V) technique, and the contactless resistivity-measurement method. Comparison of different techniques is presented. The resistivity values of the semi-insulating SiC wafer measured using different techniques agree fairly well. As a result, application of removable graphite contacts is proposed for fast and nondestructive resistivity measurement of SiC wafers using the four-point probe method. High-temperature van der Pauw and room-temperature Hall characterization for the tested semi-insulating SiC wafer was also obtained and reported in this work.     

The Person Reference Process in Spontaneous Trait Inferences.

Five studies examined whether spontaneous trait inferences uniquely reference the person who performed a trait-implying behavior. On each study trial in 5 studies, participants saw 2 faces and a behavioral sentence referring to one of them. Later, participants saw face-trait pairs and indicated whether they had seen the trait word in the sentence presented with the face. Participants falsely recognized implied traits more when these traits were paired with actors' faces than with control faces. This effect was replicated for a large set effaces (120), after a week delay between study and recognition test, when equal attention was paid to each face, and when the orientation of the face at recognition was different from the orientation at encoding. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Management gaps analysis: a case study of groundwater resource management in New Zealand

The primary objective of this project is to identify gaps, whether real or perceived, that hinder effective groundwater management in New Zealand. These gaps show as gaps in information, gaps in implementation, gaps in technological and management tools, and gaps in understanding of fundamental processes. The secondary objective is to propose a management strategy to close the identified gaps. Several methods are used to meet these objectives: surveys distributed to selected staff in each regional council; the review of various written reports; the analysis of land-use databases; and private consultation within each regional council. Results show that groundwater management in New Zealand is generally reactionary with the main gaps being in strategic planning and national guidelines. Most gaps appear to be predominantly information and implementation issues. In some cases there are gaps in the understanding of fundamental processes within an aquifer system, including the long-term effects of land-use on groundwater quality. An adaptive management approach is suggested as a means of closing these gaps.     

End-to-end congestion control schemes: utility functions, random losses and ECN marks

We present a framework for designing end-to-end congestion control schemes in a network where each user may have a different utility function and may experience noncongestion-related losses. We first show that there exists an additive-increase-multiplicative-decrease scheme using only end-to-end measurable losses such that a socially optimal solution can be reached. We incorporate round-trip delay in this model, and show that one can generalize observations regarding TCP-type congestion avoidance to more general window flow control schemes. We then consider explicit congestion notification (ECN) as an alternate mechanism (instead of losses) for signaling congestion and show that ECN marking levels can be designed to nearly eliminate losses in the network by choosing the marking level independently for each node in the network. While the ECN marking level at each node may depend on the number of flows through the node, the appropriate marking level can be estimated using only aggregate flow measurements, i.e., per-flow measurements are not required.     

Use of X-ray computed microtomography to understand why gels reduce relative permeability to water more than that to oil

X-ray computed microtomography (XMT) was used to investigate why gels reduce relative permeability to water more than that to oil in strongly water-wet Berea sandstone. XMT allows saturation differences to be monitored for individual pores during various stages of oil, water, and gelant flooding. The method also characterizes distributions of pore size, aspect ratio, and coordination number for the porous media. We studied a Cr(III) acetate–HPAM gel that reduced permeability to water (at S_or) by a factor 80–90 times more than that to oil (at S_wr). In Berea, the gel caused disproportionate permeability reduction by trapping substantial volumes of oil that remained immobile during water flooding (i.e., 43.5% S_or before gel placement versus 78.7% S_or after gel placement). With this high trapped oil saturation, water was forced to flow through narrow films, through the smallest pores, and through the gel itself. In contrast, during oil flooding, oil pathways remained relatively free from constriction by the gel.     

Spectral properties of diesel fuel droplets

Absorption spectra of several types of diesel fuel are studied experimentally. Index of refraction of these fuels is calculated using subtractive Kramers-Krönig analysis. The ageing process of fuels is simulated by prolonged boiling. Radiative properties of diesel fuel droplets are calculated using the Mie theory and a simplified approach, based on approximations of absorption and scattering efficiency factors. It is pointed out that the accuracy of the simplified approach is sufficient for practical applications in the visible and infrared ranges, for various types of diesel fuel, and for droplet radii in the range from 5 to 50 μm. The monodisperse approximation is shown to be applicable for the analysis of infrared radiative properties of realistic polydisperse diesel fuel sprays.     

An evaluation of biological and abiotic controls for grapevine powdery mildew. 2. Vineyard trials

Grapevine powdery mildew ( Erysiphe necator) affects grape yield and fruit quality worldwide. Managers of conventional vineyards rely mainly on synthetic fungicides and sulfur to control powdery mildew, while in organic vineyards sulfur is the main control agent, often in rotation with canola-based oils, bicarbonates and biological control agents. The efficacy of those materials has not been evaluated critically under field conditions in Australia. Accordingly, a range of materials showing most promise in previous greenhouse trials (Crisp et al. 2006 Australian Journal of Grape and Wine Research 12 , pp. 192–202) were assessed via field trials in commercial vineyards. Applications of either milk or whey (alone, or mixed with a canola oil-based product), as well as applications of potassium bicarbonate (commercial formulation), all reduced the severity of powdery mildew compared with untreated vines. Eight applications of a 1:10 dilution of milk, 45 g/L whey powder or programs comprising rotations of potassium bicarbonate plus oil and whey, applied at 10–14 day intervals, reduced the severity of powdery mildew to levels not significantly different from that on vines sprayed with sulfur (wettable powder, 3–6 g/L). However, the relative control of powdery mildew by the test materials in field trials was dependent on the susceptibility of the grapevine cultivar and the extent of spray coverage achieved. In vineyards where highly susceptible cultivars were planted, and spray coverage was compromised, the resultant control of powdery mildew was reduced; and sometimes to commercially unacceptable levels.     

Use of citric acid for heavy metals extraction from contaminated sewage sludge for land application.

Recent studies revealed that organic acids such as citric and oxalic acids seemed to be more promising as chemical extracting agents for removal of heavy metals from contaminated sludge, since they are biodegradable and can attain a higher metal extraction efficiency at mildly acidic pH compared to other extracting agents. Results of a lab-scale study on the efficiency of citric acid in the extraction of chromium (Cr), copper (Cu), lead (Pb), nickel (Ni) and zinc (Zn) from anaerobically digested sludge, revealed that citric acid seemed to be highly effective in extracting Cr (at 100%), Cu (at 88%), Ni (at 98%) and Zn (at 100%) at pH 2.33, mostly at 5 days leaching time except for Cu and Zn, which are at 1 day and 2 h contact times respectively. Lead removal at the same pH was also high at 95% but at a longer leaching time of 11 days. At pH 3, citric acid seemed to be highly effective in extracting Pb (at 100%) at 1 day leaching time, although higher removals were also attained for Ni (70%) and Zn (80%) at only 2 h leaching time. Chemical speciation studies showed that Cr, Cu and Ni in the sludge sample seem to predominate in residual fractions, while Pb and Zn were found mostly bound to organic and inorganic matter forms, hence the potential of the sludge for land application.