利用信息融合方法的三维特征提取

本文提出了一种基于信息融合的物体三维特征的提取方法，该方法利用两幅互相配准的三维测距图像和灰度图像，来提取多面体的三维特征。首先，通过分析灰度图像中的灰度变化及测距图像中的测距值变化，分别求取各自图像中物体的特征点及特征边；然后，利用两配准图像之间的对应关系，求得所有特征点、面与多边形在三维测距图像中的三维表示；接着，通过分析三维测距图像中所测得的各候选平面上特定点与边处的曲率及法向，验证候选平面     

Efficient diode-pumped single-frequency erbium:ytterbium fiberlaser

We report a 7.6-mW single-frequency fiber laser operating at 1545 nm, using for the first time an Er³⁺:Yb³⁺ doped fiber and a fiber grating output coupler. The laser did not exhibit self-pulsation, which is a typical problem in short three-level fiber lasers, and had a relative intensity noise (RIN) level below -145.5 dB/Hz at frequencies above 10 MHz. The linewidth of the laser was limited by the relaxation oscillation sidebands in the optical spectrum and was typically less than 1 MHz     

Effect of postoperative mydriatics on the iris

PURPOSE: To assess the role postoperative mydriatics play after extracapsular cataract extraction (ECCE) and posterior chamber intraocular lens (IOL) implantation in causing iris modifications and in controlling inflammation. SETTING: Outpatients Department, Ninewells Hospital, Dundee, Scotland. METHODS: The prospective study comprised 136 patients who had standardized ECCE. Half the patients used a mydriatic for 2 weeks postoperatively. Anterior chamber activity, pain, and eye redness were evaluated at 2 weeks postoperatively; pupil shape, peripheral anterior synechias, IOL position, and iris adhesions, at 6 weeks. RESULTS: Iris-lens adhesions were significantly more common in the group using a mydriatic. There was no difference between the two groups in postoperative inflammation. CONCLUSION: Mydriatics should not be used routinely after ECCE with posterior chamber IOL implantation.     

Sorption of vapors and gases by cellulose acetate films

Cellulose diacetate and triacetate films 6–55 µm thick with a total porosity of 0.8–2% were prepared by pouring a solution on an immobile surface and by calendering. Sorption of H₂S and CO₂ gases and acetone vapors on these films was investigated in static and dynamic conditions. It was shown that films 6–10 µm thick prepared by calendering should be used for purification of air from H₂S and CO₂ and films 15–20 µm thick prepared by pouring should be used for removal of acetone vapors.Engels Institute of Technology, Saratov State University. Translated from Khimicheskie Volokna, No. 6, pp. 44–46, November–December, 1995.     

Storage performance-metrics and benchmarks

The metrics and benchmarks used in storage performance evaluation are discussed. The technology trends taking place in storage systems, such as disk and tape evolution, disk arrays, and solid-state disks, are highlighted. The current popular I/O benchmarks are then described, reviewed, and run on three systems: a DECstation 5000/200 running the Sprite Operating System, a SPARCstation 1+ running SunOS, and an HP Series 700 (Model 730) running HP-UX. Two approaches to storage benchmarks-LADDIS and a self-scaling benchmark with predicted performance-are also described     

Thermal expansion of semiconductor materials

The thermal expansion of tellurides of germanium, bismuth, and intermetallic compounds is investigated over the temperature range 293-973 K.Belarusian Agricultural Technical University, Minsk. Translated from Inzhenerno-Fizicheskii Zhurnal, Vol. 66, No. 5, pp. 612–616, May 1994.     

Nonlinear protein binding and enzyme heterogeneity: effects on hepatic drug removal

The kinetics of substrate removal by the liver and the resulting nonlinear changes in unbound fraction along the flow path at varying input drug concentrations were examined by a model simulation study. Specifically, we varied the binding association constant, KA, and the Michaelis-Menten constants (Km and Vmax) to examine the steady state drug removal (expressed as hepatic extraction ratio E) and changes in drug binding for (i) unienzyme systems and (ii) simple, parallel metabolic pathways; zonal metabolic heterogeneity was also added as a variable. At low KA, E declined with increasing input drug concentration, due primarily to saturation of enzymes; only small differences in binding were present across the liver. At high KA, a parabolic profile for E with concentration was observed; changes in unbound fraction between the inlet and the outlet of the liver followed in parallel fashion. Protein binding was the rate-determining step at low input drug concentrations, whereas enzyme saturation was the rate-controlling factor at high input drug concentration. Heterogeneous enzymic distribution modulated changes in unbound fraction within the liver and at the outlet. Despite marked changes in unbound fraction occurring within the liver for different enzymic distributions, the overall transhepatic differences were relatively small. We then investigated the logarithmic average unbound concentration and the length averaged concentration as estimates of substrate concentration in liver in the presence of nonlinear drug binding. Fitting of simulated data, with and without assigned random error (10%), to the Michaelis-Menten equation was performed; fitting was repeated for simulated data obtained with presence of a specific inhibitor of the high-affinity, anteriorly distributed pathway. Results were similar for both concentration terms: accurate estimates were obtained for anterior, high affinity pathways; an overestimation of parameters was observed for the lower affinity posteriorly distributed pathways. Improved estimations were found for posteriorly distributed pathways upon inhibition with specific inhibitors; with added random error, however, the improvement was much decreased. We applied the method for fitting of several sets of metabolic data obtained from rat liver perfusion studies performed with salicylamide (SAM) (i) without and (ii) with the presence of 2,6-dichloro-4-nitrophenol (DCNP), a SAM sulfation inhibitor. The fitted results showed that SAM sulfation was a high-affinity high-capacity pathway; SAM glucuronidation was of lower affinity but comparable capacity as the sulfation pathway, whereas SAM hydroxylation was of lower affinity and lower capacity.