Local residence time,residence revolution,and residence volume distributions in twin‐screw extruders

This work was aimed at studying the overall, partial, and local residence time distributions (RTD); overall, partial and local residence revolution distributions (RRD) and overall, partial and local residence volume distributions (RVD) in a co‐rotating twin screw extruder, on the one hand; and establishing the relationships among them, on the other hand. Emphasis was placed on the effects of the type and geometry of mixing elements (a gear block and various types of kneading elements differing in staggering angle) and process parameters on the RTD, RRD and RVD. The overall and partial RTD were directly measured in‐line during the extrusion process and the local ones were calculated by deconvolution based on a statistical theory. The local RTD allowed comparing the mixing performance of mixing elements. Also it was confirmed both experimentally and theoretically that specific throughput, defined as a ratio of throughput (Q) over screw speed (N), controlled all the above three types of residence distributions, be they local, partial or overall. The RRD and RVD do not provide more information on an extrusion process than the corresponding RTD. Rather they are different ways of representing the same phenomena. POLYM. ENG. SCI., 48:19–28, 2008. © 2007 Society of Plastics Engineers     

土卡河水电站施工导截流设计

针对土卡河水电站枢纽布置、河道的水文气象条件及坝址区河谷地形等综合因素,介绍土卡河水电站施工导流方案、导流标准以及导流程序设计。根据现场交通条件和实际情况,进行截流设计,并将实际截流发生情况与设计进行比较。     

智能电动机控制器在电收尘通风机上的应用

对智能电动机控制器的情况作了介绍，结合工作实践提出了维护要点和建议，并对该控制器的参数设置进行了说明，这对使用该设备的工业企业有一定的指导意义。     

Research on Marine Boiler＇s Pressurized Combustion and Heat Transfer

The effect of pressure on combustion and heat transfer is analyzed. The research is based on the basic combustion and heat transfer theorem. A correction for the heat calculation method for pressurized furnace is made on the basis of the normal pressure case. The correction takes the effect of pressurizing into account. The results show that the correction is reasonable and the method is applicable to combustion and heat transfer of the marine supercharged boiler.     

基于MoCA标准的家庭网络研究

本文描述了一种基于MOCA标准的家庭网络,并对该网络及设备进行了基本性能的测试.本文首先介绍了家庭网络的发展现状,对目前的各种家庭网络标准进行了比较.在此基础上详细描述了基于MOCA标准的家庭网络,并对该网络的设计,实现、网络性能进行了详述.然后对该网络进行了测试并得出了相关的测试结论.最后指出该网络的不足及改进之处.     

偏高岭土的研究现状及展望

简要介绍了偏高岭土的反应机理和在国内外的研究现状。同时对偏高岭土的研究进行了展望 ,提出因麦特林水泥原料丰富 ,污染小 ,加工简单 ,性能优越 ,其应用前景广阔 ,应对其加强研究。     

基于光敏自组装多层膜的液晶光控取向膜

采用layer-by-layer(LBL)的方法，将基板依次在具有光敏双键的季铵盐水溶液和聚乙烯基苯磺酸钠水溶液中浸泡，石英基板表面形成了自组装多层沉积膜。经线性偏振紫外光辐照后，LBL多层膜表现出明显的紫外吸收各向异性。将两片带有各向异性薄膜的基板做成平行液晶器件。在正交的偏光显微镜下观察，发现取得均一、稳定的取向效果。该种光控取向膜有望用作LCoS微显示的取向层。     

Experimental Research on Erbium-doped Superfluorescent Fiber Source

The effects of the variations in fiber length, fiber mirror reflectance on efficiency and output power are experimentally investigated for erbium-doped double pass backward superfluorescent fiber sources (SFSs). The influence of fiber length on mean wavelength stability (MWS) has also been demonstrated. By incorporating a short section of un-pumped erbium-doped fiber (EDF) at the output port, the pump power dependent on MWS becomes independent of pumped EDF length. This is a novel phenomenon that hasn‘t been reported up to now,and should be helpful to SFS fabrication and theory analysis. By using a fiber Michelson interferometer as spectrum slicing component,a multi-wavelength fiber source (MWFS) with ～20 channels (from 1542nm to 1559nm) is got. The MWFS has a channel spacing of ～0. 8 nm which satisfies ITUstandard. The intensity fluctuation among channels is less than 0.5dB,and the extinction ratio of all channels is above 14dB. This kind of MWFS should be useful to wavelength division multiplexing systems.     

1/3码的动态CMOS全自检电路的设计

自检测电路设计方法有多种多样,本文中介绍了TSC电路的概念,并采用1/3码的动态CMOS设计TSC电路,通过在Cadence环境下仿真,仿真结果表明本设计可行。