含硫化氢气井钻井过程中的腐蚀因素与防护研究

在含硫气井的钻井过程中对于HRC大于22的钻具钢材除了腐蚀疲劳之外，在pH值小于9的环境中会发生硫化物应力腐蚀破裂，这种破坏比腐蚀疲劳更突然、更快，使钻杆大量损坏。含硫气井在钻井过程中，由于湿硫化氢的出现，常常会出现油管、套管、钻井设备、钻井仪器以及对支持保护管柱的水泥环柱等腐蚀和损坏问题，为此，阐述了湿硫化氢的腐蚀特点、机理，归纳总结了影响腐蚀的因素，综述了如何在这些方面防止其腐蚀，使损失减小，为指导油管、套管防腐工程实践提供了依据。建议在钻井过程中采用碱性钻井液，其pH值可到9或更高(至pH值12)，以减缓或防止钻井过程中电化学从硫化物应力腐蚀破裂；含硫气井用的钻杆应该间歇使用。钻杆停用堆置时间可使其放氢，使钻杆恢复韧性，防止硫化物应力腐蚀断裂。     

波动方程数值模拟的隐式差分法

在有限差分波动方程数值模拟中,通常采用高阶差分方法来提高空间导数的数值逼近精度,以实现降低数值频散,提高数值模拟精度的目的。首先对差分频散进行了理论分析;然后讨论了估计一阶空间导数的隐式差分格式,并与通常采用的高阶精度显式差分格式进行了对比分析,结果表明,隐式差分格式能够在更宽的波数范围使差分频散控制在可接受的水平,如8阶精度的显式差分格式所适应的波数带宽约为O．55kmax,而隐式差分格式所适应的波数带宽约为0．7kmax;最后通过模型试算,对隐式差分格式的有效性进行了验证。模拟结果表明,用隐式差分格式在一定程度上降低了差分频散,提高了模拟精度。     

Analysis and architecture design of variable block-size motion estimation for H.264/AVC

Variable block-size motion estimation (VBSME) has become an important video coding technique, but it increases the difficulty of hardware design. In this paper, we use inter-/intra-level classification and various data flows to analyze the impact of supporting VBSME in different hardware architectures. Furthermore, we propose two hardware architectures that can support traditional fixed block-size motion estimation as well as VBSME with less chip area overhead compared to previous approaches. By broadcasting reference pixel rows and propagating partial sums of absolute differences (SADs), the first design has the fewer reference pixel registers and a shorter critical path. The second design utilizes a two-dimensional distortion array and one adder tree with the reference buffer that can maximize the data reuse between successive searching candidates. The first design is suitable for low resolution or a small search range, and the second design has advantages of supporting a high degree of parallelism and VBSME. Finally, we propose an eight-parallel SAD tree with a shared reference buffer for H.264/AVC integer motion estimation (IME). Its processing ability is eight times of the single SAD tree, but the reference buffer size is only doubled. Moreover, the most critical issue of H.264 IME, which is huge memory bandwidth, is overcome. We are able to save 99.9% off-chip memory bandwidth and 99.22% on-chip memory bandwidth. We demonstrate a 720-p, 30-fps solution at 108 MHz with 330.2k gate count and 208k bits on-chip memory.     

一种高精度的非平稳随机信号实时建模算法研究

针对传统的非平稳随机信号时变参数筹分模型算法的不足,论文把非平稳随机信号时变参数差分模型与一种带自适应遗忘因子的RLS算法结合起来,形成一种有效的非平稳随机信号实时建模算法,仿真分析表明该算法不仅能获得快的收敛速度而且能获得高的建模精度。     

相关条件下基于N-P准则的分布式检测理论研究

本文针对并行网络、二元局部判决的情况,研究了在相关条件下基于N-P准则的分布式检测融合算法,给出了在联合概率密度已知和未知两种情况下的最优融合规则的理论推导及相应的解决方案,并在实验仿真的基础上,得到了部分有益的结论。     

多带抗噪声语音识别算法研究

根据Flether等人的研究,基于感知独立性假设的子带识别方法被用于抗噪声鲁棒语音识别。本文拓展子带方法,采用基于噪声污染假定的多带框架来减少噪声影响。论文不仅从理论上分析了噪声污染假定多带框架在识别性能上的潜在优势,而且提出了多带环境下的鲁棒语音识别算法。研究表明：多带框架不仅回避了独立感知假设要求,而且与子带方法相比,多带方法能更好的减少噪声影响,提高系统识别性能。     

A new detection algorithm (NDA) based on fuzzy cellular neural networks for white blood cell detection.

White blood cell detection is one of the most basic and key steps in the automatic recognition system of white blood cells in microscopic blood images. Its accuracy and stability greatly affect the operating speed and recognition accuracy of the whole system. But there are only a few methods available for cell detection or segmentation due to the complexity of the microscopic images. This paper focuses on this issue. Based on the detailed analysis of the existing two methods--threshold segmentation followed by mathematical morphology (TSMM), and the fuzzy logic method--a new detection algorithm (NDA) based on fuzzy cellular neural networks is proposed. NDA combines the advantages of TSMM and the fuzzy logic method, and overcomes their drawbacks. With NDA, we can detect almost all white blood cells, and the contour of each detected cell is nearly complete. Its adaptability is strong and the running speed is expected to be comparatively high due to the easy hardware implementation of FCN. Experimental results show good performance.     

小水电工程径流计算的教训和建议

以2个小水电站径流计算为实例，分析移用降雨径流关系和参证站选择的教训，对改进小水电站径流计算方法提出了建议。表4个。     

Operational aspects of adsorption air‐conditioner used in diesel locomotive

A locomotive cabin adsorption air‐conditioner has been equipped in #DF4B‐2369 locomotive; and has been successfully run for 2 years. It is powered by waste heat from the exhaust of the diesel engine. The influence on heat transfer is described by the equivalent heat transfer coefficient or thermal resistance of components inside the adsorber. The variation of adsorption capacity is expressed by a non‐equilibrium adsorption function. The dynamic heat transfer process of adsorption air‐conditioning system is treated with the lumped parameter method. Some typical running experimental results are present. The diesel engine rotating speed and locomotive speed influenced on the refrigeration system are discussed. The maximum mean refrigeration power is regarded as an objective function. Based on experiments and theoretical analysis, the running characteristics of the air‐conditioning system are optimized. Some techniques of performance improvement are suggested as well. Copyright © 2006 John Wiley & Sons, Ltd.     

对CFG桩质量缺陷的探讨

根据具体工程的概况及水文地质条件，分析了CFG桩在地下水位出现大面积缩颈现象和复合地基载荷试验达不到设计要求的原因，并介绍了地基补强措施，以满足工程质量的要求。