Corrosion morphology of AZ91D exposed in an atmospheric environment

The focused ion beam technique was employed to investigate the atmospheric corrosion morphology of AZ91D. It was found that the α matrix of the alloy was preferentially corroded in the areas adjacent to intermetallic phases. The most interesting finding was that the corrosion products in corrosion cavities were pelletlike, which has never been reported before.     

Structure, properties, and thermal stability of nanocrystallite Fe-Ti-N soft magnetic films

We deposited Fe-Ti-N magnetic films with a high sputtering power of 7 W/cm/sup 2/. When the composition of the films was in the range of Fe-Ti(3.9 at.%)-N(8.8 at.%) to Fe-Ti(3.3 at.%)-N(13.5 at.%), the films were composed of /spl alpha/' and Ti/sub 2/N precipitates. With the addition of nitrogen, 4/spl pi/M/sub s/ became higher than that of pure iron, reaching a maximum of 23.8 kG. At the same time, H/sub c/ was reduced to a minimum of 1.12 Oe. The best films can meet the needs of the recording head in dual-element giant magnetoresistive/inductive heads, yielding high storage density (10 Gb/in/sup 2/). The incorporation of N in /spl alpha/-Fe brought about the /spl alpha/' phase with its higher saturation magnetization. Ti additions inhibited the equilibrium decomposition /spl alpha/'/spl rarr//spl alpha/+/spl gamma/'. Because H/sub C//sup D//spl prop/D/sup 6/, where D is average grain diameter, grain size control is very important. The nitrogen induces severe distortion of the /spl alpha/' lattice, which can cause the grains to break into pieces and reduce the grain size. High sputtering power also led to the formation of fine grains, with diameter in the order of 14 nm. Probably Ti/sub 2/N is preferentially precipitated on the grain boundary, pinning the grain boundary and stabilizing the grain size during high-temperature heat treatment. The temperature limit for stability of the structure and its associated low coercivity was not less than 520/spl deg/C.     

油层水洗级别的热解气相色谱定量判别

应用热解气相色谱资料开展水淹层评价是储层地球化学研究的一个新领域，目前，这方面的研究尚处于定性评价阶段。文章选择位于渤海湾盆地黄骅坳陷的港东油田和羊二庄油田新近系开发层系（包括馆陶组和明化镇组）为研究目的层，以岩心热解气相色谱分析为手段，开展了油层水洗级别的气相色谱定量判别的尝试。在系统分析各气相色谱参数的地质意义及其与油层水洗的关系的基础上，优选出合理的评价参数，并采用交会图技术建立不同级别水洗油层的定量判别标准，通过其他评价方法的验证，表明该定量判别方法具有实际应用价值。     

Analysis and optimization of DS-CDMA systems with time-limited partial response chip waveforms

Conventional direct sequence code division multiple access systems (DS-CDMA) using offset quadrature phase shift key (OQPSK) usually employ a strictly bandlimited partial response square-root raised cosine pulse as the chip waveform. They have the disadvantage of large envelope fluctuation that will incur performance degradation due to the intermodulation and bandwidth enlargement caused by post nonlinear processing. To improve the performance of DS-CDMA systems, the chip waveform and receiver should be properly selected. This paper presents a systematic performance analysis of a matched filter receiver and zero-forcing filter (ZF) receiver for DS-CDMA using a time-limited partial response chip waveform. Nevertheless the systematic performance analysis is applicable to bandlimited chip pulse as well. For the zero-forcing filters, we propose to select the frequency responses that satisfy the first Nyquist criterion. With this class of filters, we can choose the roll-off factor to minimize the total power of multiple access interference and noise power. The zero-forcing filter with proper choice of roll-off factor, referred to as optimum ZF, yields a performance better than the matched filter counterpart. The bit error rate (BER) performance of the optimum ZF with superposed quadrature amplitude modulation signal as the time pulse waveform is evaluated. It is shown that the optimum ZF provides better BER performance than conventional OQPSK and minimum shift keying, and its envelope uniformity is much better than that of OQPSK.     

低阻VDMOSFET的优化设计与制造

文章对9926型双N沟增强型VDMOSFET进行了结构和版图的优化设计。给出了该器件的纵横向结构参数,材料的物理参数和版图总体结构。单胞结构的优化设计使单胞密度达到204万个/cm2,比国际市场现有产品的单胞密度(156万个/cm2)提高了30%。这种设计采用浅n+注入工艺可使器件生产成本下降31%。最后对研制结果进行了分析讨论。     

经有机交联剂活化的低相对分子质量聚合物在墨西哥湾南部水波及矿场的应用

墨西哥南部地区面临的挑战之一是水管理.油流中的水增加了其处理费用,导致结垢,降低了采油量,最终关井(与修井费用有关).甚至当产层中仍然含有大量可采油气时,也常常将这些层废弃以避免产水.虽然天然裂缝对油流有积极的作用,但它们也促进了由锥进效应或油气产层和其上或下层段之间的高渗透薄夹层引起的水或气的流动.如果这些油层产水,就会很快影响其生产能力.另一个必须解决的问题是:边水通过断层、天然裂缝等流动引起的早期水突破.本文将讨论墨西哥南部使用经有机交联剂活化的低相对分子质量聚合物的实例,介绍候选对象的选择过程、总体作业设计、实验室试验结果等,以及在这一地区进行的降低产水量处理.实例中包括衰竭、高度裂缝性油藏.     

天然气井作业屏蔽暂堵技术的研究与应用

在天然气井进行井下作业前，将暂堵剂挤入生产层位附近，以暂时封堵生产层，使地层压力不被释放，井筒内的压井液不污染地层，待施工作业结束后，及时进行解堵，确保天然气井不受伤害或少伤害，从而恢复天然气井的生产能力。针对天然气井大修作业时，经常补充压井液，由于作业时间长，大量压井液进入地层，造成严重污染，导致天然气井恢复生产困难的问题，研制出一种新型气井作业的屏蔽暂堵剂，具有污染小，易解堵等特点，有效解决了大修污染问题，现场应用取得良好效果。     

Performance and Commercial Application of the Promoter LCC-A for Maximization of Propylene Yield

1 Introduction Propylene as an important feedstock for organic chemicals is mainly originated from steam cracking and catalytic cracking processes. During the FCC process the propylene content varies with the FCC catalyst and process technology adopted, resulting in significant difference in propylene concentration in the cracked product——LPG. The conventional FCC pro- cess generally gives a propylene yield of around 4%, while the FCC process with maximization of propylene yield can in…     

XMAC纵波时差高分辨率处理方法

在充分调研阵列声波测井分波提取方法的基础上，针对阿特拉斯公司的交叉多极子阵列声波测井（XMACⅡ）提供的单极波形信息，研究纵波时差提取及高分辨率处理方法。首先利用相关-互功谱法高精度地提取纵波时差，然后针对XMACⅡ仪器的接收阵列，研究组合子阵列的方法，形成共发射子阵列和共接收子阵列，最后利用子阵列对提取的纵波时差做高分辨率处理。处理现场实际测井资料，并将高分辨率处理成果与引进的eXpress软件处理成果、实测的国产高分辨率声波（纵波）测井曲线及岩心纵波时差对比分析，表明该方法提取的纵波时差曲线的纵向分辨率有很大提高，时差计算准确可靠，提取的单极纵波时差与国产高分辨率声波时差及岩心纵波时差的平均相对误差均小于7%。该方法具有较高的实用价值和广阔的应用前景。