Optimal Placement of Dampers on Multistorey Frames Using Dynamic Analysis

Strength of Materials - The use of a damping system is one of the seismic protection systems that improve the seismic response of structures. The proposed methodology estimates the location (which...     

Effect of the Porous Skeletal Iron Structure on the Infiltration of Aluminum Melts

Powder Metallurgy and Metal Ceramics - The infiltration of aluminum melts into porous metal skeletons produced by powder metallurgy methods, including 3D printing, under a pressure gradient was...     

MACBHA: Modified Adaptive Cluster-Based Heuristic Approach with Co-operative Spectrum Sensing in Wireless Sensor Networks

Wireless Personal Communications - In the fusion experiment, sensitive radio frequency signal diagnostic instruments need to be protected against high power stray radiation coming from the Electron...     

Multiply Charged Conjugated Polyelectrolytes as a Multifunctional Interlayer for Efficient and Scalable Perovskite Solar Cells

A series of anionic conjugated polyelectrolytes (CPEs) is synthesized based on poly(fluorene-co-phenylene) by varying the side-chain ionic density from two to six per repeat units (MPS2-TMA, MPS4-TMA, and MPS6-TMA). The effect of MPS2, 4, 6-TMA as interlayers on top of a hole-extraction layer of poly(bis(4-phenyl)-2,4,6-trimethylphenylamine (PTAA) is investigated in inverted perovskite solar cells (PeSCs). Owing to the improved wettability of perovskites on hydrophobic PTAA with the CPEs, the PeSCs with CPE interlayers demonstrate a significantly enhanced device performance, with negligible device-to-device dependence relative to the reference PeSC without CPEs. By increasing the ionic density in the MPS-TMA interlayers, the wetting, interfacial defect passivation, and crystal growth of the perovskites are significantly improved without increasing the series resistance of the PeSCs. In particular, the open-circuit voltage increases from 1.06 V for the PeSC with MPS2-TMA to 1.11 V for the PeSC with MPS6-TMA. The trap densities of the PeSCs with MPS2,4,6-TMA are further analyzed using frequency-dependent capacitance measurements. Finally, a large-area (1 cm²) PeSC is successfully fabricated with MPS6-TMA, showing a power conversion efficiency of 18.38% with negligible hysteresis and a stable power output under light soaking for 60 s.     

On Heating and Relaxation of the Electron—Hole-Gas Energy in the Track of a Primary Recoil Atom

Semiconductors - On the basis of the Monte Carlo algorithm, a method for calculating the energy spectrum of hot nonequilibrium electrons and holes in the track of a primary recoil atom after being...     

Analysis of a two-dimensional symmetric problem on extension of an Al-polyimide-Cu layered structure with a model crack

To increase the efficiency of designing systems intended for monitoring surface cracks in aluminum structures during their working life, we have analyzed a two-dimensional symmetric problem on uniaxial extension of an Al-polyimide-Cu layered structure with ideal adhesion between layers and a model crack in the aluminum base. The problem has been first solved for a sample with the crack modeled by a zero-thickness notch using the ANSYS engineering simulation program package. It is shown that this setting of the problem can lead to inadequate results as manifested, in particular, by significantly overstated mechanical stresses in aluminum in the region of crack emergence on the surface. In order to eliminate this difficulty, we propose to use the structure with a model defect in the form of a notch of nonzero thickness in the initial unstressed state of the structure. Recommendations for selecting the thickness of a notch used in the model structure are given.