An improved cluster formation process in wireless sensor network to decrease energy consumption

Wireless sensor network has special features and many applications, which have attracted attention of many scientists. High energy consumption of these networks, as a drawback, can be reduced by a hierarchical routing algorithm. The proposed algorithm is based on the Low Energy Adaptive Clustering Hierarchy (LEACH) and Quadrant Cluster based LEACH (Q-LEACH) protocols. To reduce energy consumption and provide a more appropriate coverage, the network was divided into several regions and clusters were formed within each region. In selecting the cluster head (CH) in each round, the amount of residual energy and the distance from the center of each node were calculated by the base station (including the location and residual energy of each node) for all living nodes in each region. In this regard, the node with the largest value had the highest priority to be selected as the CH in each network region. The base station calculates the CH due to the lack of energy constraints and is also responsible for informing it throughout the network, which reduces the load consumption and tasks of nodes in the network. The information transfer steps in this protocol are similar to the LEACH protocol stages. To better evaluate the results, the proposed method was implemented with LEACH LEACH-SWDN, and Q-LEACH protocols using MATLAB software. The results showed better performance of the proposed method in network lifetime, first node death time, and the last node death time.

     

Failure Analysis and Remedy Procedure for Cracking of Fuel Nozzles in a Gas Turbine

A common failure in a certain type of gas turbine, observed during the first periodic inspection, is radial cracks in the tip plate of gas fuel nozzles. Here, each gas turbine has 18 nozzles. In all nozzles and in all similar units, these cracks of lengths ranging from 1 mm to a maximum of 14.5 mm are observed. As prescribed by the manufacturer, the defective part must be removed and replaced by welding and machining of a new one. But this problem is repeated and observed in the next periodic visits, and in all units. Depending on the number of nozzles in each gas turbine unit and the number of units in total, these repairs are very expensive and time-consuming. In this paper, the failure is analyzed and the causes of the cracks in the nozzles are investigated. Studies show that the main causes of nozzle failure are residual stresses caused by welding and thermal stresses caused by the start-up and shutdown processes. According to results, a solution has been proposed to release these residual and thermal stresses. After the implementation of this method in 1998, no more failure has been reported by the repair team, which proves the effectiveness of this solution. Since this paper has been prepared based on technical reports from the years between 1996 and 1998, the cited references of this paper are these technical reports.     

Mesoporous silica coated gold nanorods: a multifunctional theranostic platform for radiotherapy and X-ray imaging

Journal of Porous Materials - The development of theranostic nanostructures is one of the most advanced branches of pharmaceutical and medical sciences in the world today. Due to the unique...     

Taguchi Optimization of Solvent-Antisolvent Crystallization to Prepare Ammonium Perchlorate Particles

The sphericity and size of ammonium perchlorate (AP) particles significantly influence the properties of composite propellants. As the AP particles become more spherical, the accumulation coefficient increases, the viscosity during casting decreases, and the particle loading and burning rate increase. Hence, the production of micronized AP particles with an average size between 1 and 20 μm is important to increase the loading percentage of AP in the composite propellant. Here, the Taguchi experimental design was used to optimize the solvent-antisolvent crystallization (SAC) process for the preparation of micronized AP particles with higher sphericity. SAC parameters such as the type of antisolvent, the solvent-to-antisolvent ratio, the antisolvent temperature, the stirring speed, and the retention time were investigated at four levels. The type of antisolvent and the solvent-to-antisolvent ratio were found to mainly contribute to improving the sphericity and size of the AP particles, respectively.