合成气中氨含量测定方法的改进

用快速测定仪测定气体中的氨含量，采气量为50ml，可准确测出高含量氨体积百分比含量为80%-100%和低含量氨体积百分比含量为1%-20%的样气，该仪器结构简单，易于制造，测定过程简单，结果准确，一目了然。     

PTC型BaTiO3陶瓷的孪晶和孪晶界

用透射电镜和高分辨电镜观察研究了PTC型BaTiO_3陶瓷的孪晶和孪晶界结构,并提出了可能的{111}孪晶及孪晶界的原子结构模型。结果表明,{111}孪晶形成氧八面体共面的共格倾斜孪晶界,在孪晶界处可能存在一定量的A空位且原子密度要低于孪晶体内。同时还发现两种其它特征的孪晶现象。     

Comments on the characterisation of oxidation catalysts using TPR/TPO

Temperature programmed reduction (TPR) and oxidation (TPO) are used extensively in catalyst characterisation. In this paper, we examine the use of TPR/TPO cycles for the characterisation of a range of molybdates and single oxides. In particular we observe that the first cycle differs from that of subsequent analyses, even when the maximum temperature is limited to that used in the catalytic reaction. The effect is independent of heating rates and cooling atmospheres and has been demonstrated using different bed configurations. This observation has significance when these oxides are used in periodic flow reactors that involve many cyclical reduction/oxidation.     

Deformation and failure study of surrounding rocks of dynamic pressure roadways in deep mines

In order to understand the change rules of stress-displacement in surrounding rocks of dynamic pressure roadways in deep mines and to obtain a theoretical basis for analyses of roadway stability and designs of support,we established a coupling equation of adjacent rock strength,mining stress and supporting resistance on the basis of an elastic-plastic theory of mechanics.We obtained an analytical solution for stress and displacement distribution of elastic and plastic regions in surrounding rock of dynamic pressure roadway..Based on this theory,we have analyzed the changes in stress-displacement in elastic and plastic regions of surrounding rocks of dynamic pressure roadways in the Haizi Coal Mine.The results show that:1) radial and tangential stress change violently within the first 4 m from the inner surface of a roadway after excavation;radial stress increases while tangential stress decreases within a range of about 6 m from the inner surface of the roadway as a function of q3;2) radial and tangential stress increase with an increase in the mining pressure coefficient k;the increase in the rate of tangential stress is greater than that of radial stress;3) the radial displacement of the inner surface of roadways decreases with an increase in q3,provided that k remains unchanged.     

Application of structural curvature of coalbed floor on CBM development in the Zaoyuan block of the southern Qinshui Basin

Based on controls of structural style and the position in coalbed methane(CBM)development,we used a method of curvatures to study its relations with CBM development parameters.We calculated structural curvatures of contours of the No.3coal seam floor of the Shanxi Formation in the Zaoyuan block of the Qinshui Basin and analyzed its relations with development parameters of coalbed methane wells.The results show that structural curvature is negatively related to coal reservoir pressure,while positively related to permeability.With an increase in structural curvature,the average production of coalbed methane wells increases at first and then decreases,reaching the highest production at 0.02 m-1 of structural curvature.Therefore,structural curvature can be an important index for potential evaluation of coalbed methane development and provide a basis for siting coalbed methane wells.     

光催化-Fenton工艺处理废纸制浆废水

为有效处理废纸制浆废水,采用氙灯照射下的光催化-Fenton技术,研究不同反应器、曝气、草酸钾、H2O2投加方式和废水质量浓度对光-Fenton工艺去除废水中TOC或吸光度的影响.结果表明,提高光照强度可提高TOC去除率;添加适量的草酸钾可提高处理效果;H2O2分两次投加可取得较好的处理效果,大大减少对催化剂的需求;在处理过程中使废水暴露于空气可提高有机物的脱氯效果,但曝气对处理效果并无益处.对于TOC为185 mg/L左右的废纸制浆废水,在[H2O2]=1000 mg/L、[Fe(Ⅱ)]=100 mg/L、pH=3.0、温度为30℃的条件下,经过30 min处理,废水的TOC可去除63%以上.     

Characterization of NOM and THM formation potential in eutrophic reservoir water

Resin adsorption technique with XAD-8 and XAD-4 was used to characterize the raw water from Erlong reservoir in Jilin province of China. The NOM chemical composition sequences of four organic fractions in the raw water,from high to low,are fulvic acid (FA) fraction,hydrophilic non-acid (HPINA) fraction,hydrophilic acid (HPIA) fraction,and humic acid (HA) fraction. Experimental results show that FA is the main precursor of THMFP among the four organic fractions. However,HA or hydrophobic acid exhibits the highest chlorination activity in forming THMs. It is also found that the value of FI/DOC or SUVA and the specific THMFP have better positive correlation. It is implied that certain source water has unique nature of NOM and DBPs.     

虚拟样机中模型库关联关系的研究

为了解决复杂产品虚拟样机模型库管理方法引起的虚拟样机间模型的可复用性低、共享性低、存储不方便等问题,提出了一种基于虚拟样机中模型库关联关系的管理方法.通过对虚拟样机协同开发过程分析,建立了基于功能级的元模型.通过研究元模型间的约束关系发现了关联关系层,并实现了基于关联关系的模型库管理系统,在一定程度上解决了以上提出的问题.     

Effects of silicone oil and polymeric modifiers on the mechanical properties of highly filled LLDPE

The effects of coupling agents, silicone oil, and three types of polymeric modifiers on the mechanical properties of linear low density polyethylene (LLDPE) composites highly filled with aluminium hydroxide [Al(OH)₃] were studied. Polymeric modifiers that contain polar groups, such as silane‐grafted polyethylene (Si‐g‐PE) and acrylic‐acid‐grafted ethylene‐vinyl acetate copolymer (AA‐g‐EVA), improve the mechanical properties dramatically, while nonpolar modifiers improve them to some extent. When Al(OH)₃ was treated using a titanate coupling agent, the silicone oil increased the impact strength and elongation at break of the LLDPE/Al(OH)₃ composites. Introduction of a polymeric modifier containing polar groups destroys the beneficial effects of silicone oil on film mechanical properties, while the introduction of a nonpolar elastomeric polymeric modifier retains the high impact strength and elongation at break. SEM analyses provide the indirect evidence of the encapsulation of silicone oil around the filler. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 83: 121–128, 2002