高纯Fe中氢损伤规律的研究

本文采用正电子湮没技术研究了高纯Fe中的氢损伤规律,实验结果表明,在0.5mol/L H_2SO_4溶液中不加毒化剂电解充氢时,产生氢损伤的临界电流密度为20 mA/cm~2;而在0.5mol/L H_2SO_4溶液中加少量As_2O_3作为毒化剂电解充氢时,即使很小的电流密度也会产生氢损伤,配合慢拉伸试验,还发现试样内部产生氢损伤以后,它将控制随后的形变和断裂过程     

EFFECT OF ALLOY ELEMENTS ON QUASIEQUILIBRIUM MICROSTRUCTURE IN Fe-Mn-Ni-Cr STEELS

The microstructures of Fe-Mn-Ni-Cr steels with medium carbon and the effect of alloy ele-ments on them have been investigated by means of X-ray diffraction quantitative phase ana-lyses,metallography and hardness tests.The volume fraction of martensite in steels quenchedat 1100℃ can be expressed as:f_M~(1100)=162.643-15.482Mn-7.36Ni-4.286(Cr+Mo+V)Based on this expression,the quasi-equilibrium microstructure diagram has been obtained.Itis shown that the effect of Mn on the austenite stability is greater than that of Ni.The equiva-lent [Ni]=2.104Mn+Ni and equivalent [Cr]=Cr+Mo+V.The driving force for martensite transformation at M_s point has been calculated to hedrastically decreased by element Mn.     

QUASI-EQUILIBRIUM MICROSTRUCTURES AND EFFECT OF ALLOY ELEMENTS IN Fe-Mn-Ni-Cr STEELS

本文利用X射线定量相分析及金相观察和硬度测试,考察了中碳Fe-Mn-Ni-Cr钢的组织及合金元素的作用。建立了经1100℃淬火后的马氏体体积分数与合金成分的定量关系式; f_M~(1100)=162.643-15.482Mn-7.36Ni-4.286(Cr+Mo+V)并在此基础上给出了亚平衡组织图。结果表明,Mn稳定奥氏体的作用大于Ni的作用。Ni和Cr当量分别以[Ni]=2.104Mn+Ni,[Cr]=Cr+Mo+V表示。计算了M_S点处的马氏体相变驱动力,指出Mn具有强烈降低相变驱动力的作用。     

共晶自生复合材料的晶形转变

自生复合材料的晶形转变受到成分过冷与曲面过冷两个因素的控制.非金属相具有较大的熔化熵且易形成小平面是改变领先相的因素,而领先相的改变则可能是晶形转变的根本原因.     

SIMULATION OF HEAT TRANSFER BY WATER SPRAY COOLING DURING CONTINUOUS CASTING OF LOW CARBON STEEL

本文研究了喷雾水滴与高温物体表面之间的传热。试验测定了锥形喷嘴的冷态特性和水滴与高温表面的传热系数,讨论了影响传热系数因素,并得出了h∝W关系式。     

PREDICTION OF THE PROBABILITY OF SPHEROIDIZATION IN NODULAR CAST IRON BY PARAMETRIC DIAGRAM OF CHEMICAL BOND

<正> 本文试图从化学键理论出发,探讨石墨球化的规律。鉴于用键参数图法总结与化学键有关的规律性往往见效,故本文从球化剂元素和反球化元素在键参数图中的分布规律入手进行研究。 球化剂元素(或反球化元素)对石墨球化的影响应与该元素和C_(石墨)间的相互作用有关,其键参数函数写成如下形式:     

CERTAIN CRITERION FOR THE FORMATION OF AMORPHOUS SOLIDS

<正> 根据成核理论,当仅考虑均匀核化时,在过冷熔体中结晶成核率可用下式表示: I=N_v~°kT/(3πα_°~3η)exp(-16πα~3β/3T_rΔT_r~2) (1)其中α=(N_v~°)~(1/3)σ/ΔH_m,β=1ΔH_m/RT_m=T/T_m, ΔT_r=T_m-T/T_m.各参量分别表示:I,成核率(cm~(-3)·s~(-1);N_v~°单位体积中的分子数(cm~(-3);η,粘滞系数(P);σ,比表面能(cal·cm~(-2));ΔH_m,熔化时的焓变(cal·mol~(-1));N,阿佛加德罗常数;v,克分子体积;T,熔体温度(K);T_m,熔点(K);k,玻尔兹曼常数;R,气体常数;α_0,分子直径。     

深冲汽车簿钢板织构的表述方法

利用晶体学性质,将深冲汽车薄板的两种主要特征织构表述于反极图之中,再利用织构定量技术便能简捷地分析深冲钢板的织构与深冲性能的关系。经验证,此法与ODF定量分析所得的结果一致。     

Extraction of Metal(Ti,V,Mo)-oxyl Cations by Monoacidic Phosphates and Phosphonates

The extraction of TiO~(2+),VO~(2+),VO_2~+ and MoO_2~(2+)by HDEHP,HEHEHP and HDTMPP was studiedrespectively.The orders of extraction ability for the three extractant systems are as follows:for TiO~(2+),VO~(2+):HDEHP>HEHEHP>HDTMPP;for VO_2~+, MoO_2~(2+):HDEHP< HEHEHP< HDTMPP.The experimental results were discussed from the point of view of extractant structures.     

预应变对16MnR钢断裂韧性的影响SCIEI

本文实验发现预应变对16MnR钢的断裂韧性具有显著的影响,断裂过程中裂尖区域材料的组织结构发生了变化,裂纹在二次珠光体组织上扩展。16MnR钢断裂韧性的大小取决于碳原子的扩散及二次珠光体组织生成的难易程度。