Duplex SiCN/DLC coating as a solution to improve fretting—Corrosion resistance of steel

Fretting corrosion damages are commonly observed when two metallic bodies, which are in contact with each other, are subjected to oscillatory motions of low amplitude. Such kind of degradation mode is often responsible for limited durability of aeronautical joints. In the present paper, a multifunctional duplex coating based on Si–C–N and diamond-like carbon (DLC) materials, combining corrosion resistance and good tribological properties is described. Amorphous hydrogenated SiC, SiCN, SiC/DLC and SiCN/DLC were deposited on steel substrates by a plasma assisted chemical vapour deposition (PACVD) technique, using tetramethylsilane (TMS), ammonia (NH₃) or acetylene (C₂H₂) as gas precursors. Nitrogen incorporation has shown to improve the corrosion protection ability of SiC coatings. The corrosion behaviour and the tribological performance in aqueous media of SiCN/DLC coating have therefore been investigated. A test rig has been designed to validate the fretting resistance of this duplex coating for aeronautic applications. It was found that the combination of a SiCN-based PACVD sublayer with a DLC topcoat could provide an enhanced solution to withstand both fretting and corrosion.     

MEMS based hair flow-sensors as model systems for acoustic perception studies

Arrays of MEMS fabricated flow sensors inspired by the acoustic flow-sensitive hairs found on the cerci of crickets have been designed, fabricated and characterized. The hairs consist of up to 1?mm long SU-8 structures mounted on suspended membranes with normal translational and rotational degrees of freedom. Electrodes on the membrane and on the substrate form variable capacitors, allowing for capacitive read-out. Capacitance versus voltage, frequency dependence and directional sensitivity measurements have been successfully carried out on fabricated sensor arrays, showing the viability of the concept. The sensors form a model system allowing for investigations on sensory acoustics by their arrayed nature, their adaptivity via electrostatic interaction (frequency tuning and parametric amplification) and their susceptibility to noise (stochastic resonance).     

Evaluation of the Antimicrobial Potential of Alginate and Alginate/Chitosan Films Containing Potassium Sorbate and Natamycin

The antimicrobial potential of alginate films (AFs) and alginate/chitosan composite films with two different mass proportions of the biopolymers, 82.5:17.5 (CF1) and 65:35 (CF2), containing potassium sorbate (KS) or natamycin was evaluated. At the practical limit of KS addition (0.17 g KS per gram of alginate) for pure AFs, no inhibition zones were observed against Debaromyces hansenii, Penicillium commune and Penicillium roqueforti by the agar diffusion test. Above this concentration, films became opaque, brittle and showed a whitish precipitate over their surface, making them not suitable for use. However, alginate and alginate/chitosan composite films containing natamycin were able to inhibit the growth of the three microorganisms listed above. Natamycin was effective at concentrations as low as 0.005 g per gram of biopolymer for AF and 0.01 g per gram of biopolymer for both composite films, alginate/chitosan 65:35 (CF1) and alginate/chitosan 82.5:17.5 (CF2) against all microorganisms tested. The inhibitory zone diameter increased as concentration of natamycin increased. Active films containing 0.04 g natamycin per gram of biopolymer obtained in the present study exhibited suitable functional attributes and showed excellent perspectives as active antimicrobial films intended for food protection applications. Copyright © 2012 John Wiley & Sons, Ltd.     

APPLICATIONS OF AN EXPONENTIAL FINITE-DIFFERENCE TECHNIQUE

ABSTRACT

In this paper an expontial finite-difference scheme, first presented by Bhattacharya for one-dimensional, unsteady heat conduction problems in a plane wail, is used to solve various partial differential equations. Solutions of the unsteady diffusion equation in three dimensions and of the viscous form of Burgers’ equation ere used to illustrate the method. Predicted results are compared with exact solutions or with results obtained by other numerical methods.     

A stability analysis for a hydrodynamic three-wave journal bearing

The influence of the wave amplitude and oil supply pressure on the dynamic behavior of a hydrodynamic three-wave journal bearing is presented. Both, a transient and a small perturbation technique, were used to predict the threshold to fractional frequency whirl (FFW). In addition, the behavior of the rotor after FFW appeared was determined from the transient analysis. The turbulent effects were also included in the computations.Bearings having a diameter of 30 mm, a length of 27.5 mm, and a clearance of 35 μm were analyzed. Numerical results were compared to experimental results obtained at the NASA GRC. Numerical and experimental results showed that the above-mentioned wave bearing with a wave amplitude ratio of 0.305 operates stably at rotational speeds up to 60,000 rpm, regardless of the oil supply pressure. For smaller wave amplitude ratios, a threshold of stability was found. It was observed that the threshold of stability for lower wave amplitude strongly depends on the oil supply pressure and on the wave amplitude.When the FFW occurs, the journal center maintains its trajectory inside the bearing clearance and therefore the rotor can be run safely without damaging the bearing surfaces.     

Reorganization of perylene bisimide J-aggregates: from delocalized collective to localized individual excitations

Water-induced reorganization of individual one-dimensional J-aggregates of perylene bisimide (PBI) dyes was observed by fluorescence microscopy. Fluorescence spectra and decay kinetics of individual J-aggregates immobilized on glass surfaces were measured under a dry nitrogen atmosphere and under humid conditions. The fluorescence properties of PBI J-aggregates arisen from collective excitons under dry nitrogen atmosphere were changed to those of non-interacting dye monomers when water vapor was introduced into the environment (sample chamber). Time-dependent changes of the fluorescence spectra and lifetimes upon exposure to water vapor suggest an initial coordination of water molecules at defect sites leading to the formation of H-type dimer units that act as exciton quenchers, and a subsequent slower disintegration of the hydrogen-bonded J-aggregate into monomers that lack resonance coupling. Our present studies resulted in a direct demonstration of how drastically the optical properties of molecular ensembles and characteristics of their excited states can be changed by delicate reorganization of dye molecules at nanometre scales.     

固执追求 让完美视觉与高科技双结合

2012年4月6日,由北京时尚家影音科技有限公司主办,科普兰德公司《、家饰》杂志、《中国建筑装饰装修》杂志、科普兰德设计师俱乐部承办的"2012时尚家国际顶尖私人影院设计论坛"在北京海航大厦万豪酒店成功举行。中国首家国际顶级私人影院专业设计机构"时尚家—TK国际私人影院设计事务所"成立。     

Measurements of normal boiling points of fatty acid ethyl esters and triacylglycerols by thermogravimetric analysis

At present, a large number of studies of biodiesel production process using simulation packages are being developed. In these studies, vegetable oils and biodiesels are characterized in the software through representative compounds because of they are not in the compounds database of commercial simulators. With the aim to achieve a successfully characterization in these kinds of software, some properties of the substances must be available. The normal boiling point (NBP) is the most important property due to the fact that this property along with group contribution methods allows other properties calculation such as, e.g., critical properties and temperature dependency properties. In this work, a thermogravimetric analysis (TGA) method for rapid measurement of normal boiling points of two triacylglycerols and four ethyl esters, i.e., triolein, tripalmitin, ethyl oleate, ethyl palmitate, ethyl linoleate and ethyl ricinoleate, was used. Nowadays, in the open literature exists few data available about ethyl esters properties; hence, the results obtained here will contribute in the proposal, analysis, and evaluation of ethyl esters (biodiesel) virtual plants using reliable simulation packages. In addition, a more accurate characterization of compounds and therefore more accurate simulation results can be obtained when they are used.