Towards a continuous microfluidic rheometer

In a previous paper we presented a way to measure the rheological properties of complex fluids on a microfluidic chip (Guillot et al., Langmuir 22:6438, 2006). The principle of our method is to use parallel flows between two immiscible fluids as a pressure sensor. In fact, in a such flow, both fluids flow side by side and the size occupied by each fluid stream depends only on both flow rates and on both viscosities. We use this property to measure the viscosity of one fluid knowing the viscosity of the other one, both flow rates and the relative size of both streams in a cross-section. We showed that using a less viscous fluid as a reference fluid allows to define a mean shear rate with a low standard deviation in the other fluid. This method allows us to measure the flow curve of a fluid with less than 250 μL of fluid. In this paper we implement this principle in a fully automated set up which controls the flow rate, analyzes the picture and calculates the mean shear rate and the viscosity of the studied fluid. We present results obtained for Newtonian fluids and complex fluids using this set up and we compare our data with cone and plate rheometer measurements. By adding a mixing stage in the fluidic network we show how this set up can be used to characterize in a continuous way the evolution of the rheological properties as a function of the formulation composition. We illustrate this by measuring the rheological curve of four formulations of polyethylene oxide solution with only 1.3 mL of concentrated polyethylene oxide solution. This method could be very useful in screening processes where the viscosity range and the behavior of the fluid to an applied stress must be evaluated.     

Comparative morphology of leaf epidermis in eight populations of Atlas Pistachio (Pistacia atlantica Desf., Anacardiaceae)

A comparative analysis was undertaken to conduct a micromorphological study of Pistacia atlantica leaves by comparing different populations grown under different climatic conditions. Leaf epidermis of eight wild populations was investigated under scanning electron microscope. Micromorphological characteristics (epidermis ornament, stomata type, waxes as well as trichomes) of the adaxial and abaxial leaf surfaces were examined. The epidermis ornament varied among populations and leaf surface, the abaxial leaf surface is reticulate with a striate surface. Messaad site shows a smooth uneven surface. The adaxial leaf surface is smooth but several ornamentations can be seen. The leaflet is amphistomatic; the stomata appeared to be slightly sunken. A variety of stomatal types were recorded; actinocytic and anomocytic types are the most frequent. The indumentum consisted of glandular and nonglandular trichomes. Unicellular glandular trichomes are recorded for P. atlantica leaves in this study. Their density is higher in Oued safene site, located at the highest altitude in comparison with the other populations. The wax occurred in all the sites and its pattern varied according to the populations studied, particularly between Berriane and Messaad. The morphological variability exhibited by the eight populations of P. atlantica may be interpreted as relevant to the ecological plasticity and the physiological mechanisms involved are discussed in this report.     

How to take into account general and contextual knowledge for interactive aiding design: Towards the coupling of CSP and CBR approaches

The goal of this paper is to show how it is possible to support design decisions with two different tools relying on two kinds of knowledge: case-based reasoning operating with contextual knowledge embodied in past cases and constraint filtering that operates with general knowledge formalized using constraints. Our goals are, firstly to make an overview of existing works that analyses the various ways to associate these two kinds of aiding tools essentially in a sequential way. Secondly, we propose an approach that allows us to use them simultaneously in order to assist design decisions with these two kinds of knowledge. The paper is organized as follows. In the first section, we define the goal of the paper and recall the background of case-based reasoning and constraint filtering. In the second section, the industrial problem which led us to consider these two kinds of knowledge is presented. In the third section, an overview of the various possibilities of using these two aiding decision tools in a sequential way is drawn up. In the fourth section, we propose an approach that allows us to use both aiding decision tools in a simultaneous and iterative way according to the availability of knowledge. An example dealing with helicopter maintenance illustrates our proposals.     

A finite macro-element for corroded reinforced concrete

This paper proposes a model of the mechanical behaviour of corroded reinforced concrete members subjected to bending under service load. The model is based on the formulation of a macro-element to be used in FEM analysis, having a length equal to the distance between two consecutive flexural cracks and a cross-section equal to the member cross-section. The mechanical formulation is directly written in generalized variables (bending moment and curvature) and is based on the concept of the transfer length necessary for the transmission of tensile load from re-bar to tensile concrete thanks to the bond. It is thus possible to take into account the effect of reinforcement corrosion on the bond between re-bar and concrete, by increasing the transfer length versus intensity of corrosion. The variation of the transfer length versus corrosion is expressed using a scalar damage parameter. A first experimental validation is performed on a 17-year-old beam kept in a chloride environment under its service load.     

Sequential Compatibility Effects and Cognitive Control: Does Conflict Really Matter?

Although it is widely accepted that control mechanisms are necessary for human behavior to be adapted, very little is known about how such mechanisms are recruited. A suggestion to fill the gap was put forward by M. M. Botvinick, T. S. Braver, C. S. Carter, D. M. Barch, and J. D. Cohen (2001), who proposed the conflict-loop theory. This theory has been successful in accounting for the reduction of compatibility effects after an incompatible trial: The level of conflict being, on average, higher during an incompatible trial, more control occurs after such a trial. The authors have tested this prediction by sorting the trials on the basis of amount of conflict (quantified by the electromyographic activity) they presented. A reduction of the compatibility effect was observed after incompatible trials, but it was independent of the level of conflict on previous trials, suggesting that the conflict does not trigger changes in executive control. Consequences for the conflict monitoring model are discussed. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Unsupervised writer adaptation applied to handwritten text recognition

This paper deals with the problem of off-line handwritten text recognition. It presents a system of text recognition that exploits an original principle of adaptation to the handwriting to be recognized. The adaptation principle is based on the automatic learning, during the recognition, of the graphical characteristics of the handwriting. This on-line adaptation of the recognition system relies on the iteration of two steps: a word recognition step that allows to label the writer's representations (allographs) on the whole text and a re-evaluation step of character models. Tests carried out on a sample of 15 writers, all unknown by the system, show the interest of the proposed adaptation scheme since we obtain during iterations an improvement of recognition rates both at the letter and the word levels.     

American = White?

Six studies investigated the extent to which American ethnic groups (African, Asian, and White) are associated with the category "American." Although strong explicit commitments to egalitarian principles were expressed in Study 1, Studies 2-6 consistently revealed that both African and Asian Americans as groups are less associated with the national category "American" than are White Americans. Under some circumstances, a dissociation between mean levels of explicit beliefs and implicit responses emerged such that an ethnic minority was explicitly regarded to be more American than were White Americans, but implicit measures showed the reverse pattern (Studies 3 and 4). In addition, Asian American participants themselves showed the American = White effect, although African Americans did not (Study 5). The American = White association was positively correlated with the strength of national identity in White Americans. Together, these studies provide evidence that to be American is implicitly synonymous with being White. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

非整数阶系统连续时间域的模拟

提出了一种致力于非整数阶系统连续时间域的模拟方法.这种特殊系统的仿真建立在有限频率区间非整数阶积分算子的基础上,其非整数阶作用仅限于有限频率区域.然后,可以定义非整数阶模型的状态方程实现,它允许近似理想非整数阶系统的连续时间响应.最后,通过两个数字仿真例子来验证这种模拟方法.     

Length of Dialysis Session Is More Important Than Large Kt/V in Hemodialysis

Long, slow hemodialysis (3 × 8 hours/week) has been used without significant modification in Tassin, France, for 30 years with excellent morbidity and mortality rates. A long dialysis session easily provides high Kt/V_urea and allows for good control of nutrition and correction of anemia with a limited need for erythropoietin (EPO). Control of serum phosphate and potassium is usually achieved with low-dose medication. The good survival achieved by long hemodialysis sessions is essentially due to lower cardiovascular morbidity and mortality than in short dialysis sessions. This, in turn, is mainly explained by good blood pressure (BP) control without the need for antihypertensive medication. Normotension in this setting is due to the gentle but powerful ultrafiltration provided by the long sessions, associated with a low salt diet and moderate interdialytic weight gains. These allow for adequate control of extracellular volume (dry weight) in most patients without important intradialytic morbidity. Therefore, increasing the length of the dialysis session seems to be the best way of achieving satisfactory long-term clinical results.