甲状腺素T4免疫传感器的研究

报道以甲基丙烯酸羟乙酯与甲基丙烯酸甲酯的共聚物为载体膜材料，研制成非酶标记的Ｔ４免疫传感器，并对载体膜材料的共聚方法及共聚物共聚比与传感器灵敏度的关系进行了探讨。     

Ultrasonic thin-walled tube wave structure for sensing devices

Theoretical and experimental investigations of thin-walled tube acoustic wave devices for gravimetric sensing applications are presented. Integrated sensor configurations have been demonstrated by employing a sol-gel processed thin piezoelectric lead zirconate titanate (PZT) film. This was coated coaxially on stainless steel tubes and interdigital transducers (IDT) fabricated as the transmitter and receiver on the curved tube surfaces. We have observed tube waves along both the axial and circumferential directions between 1 and 6.6 MHz. We have also analyzed the mass sensitivities of different modes propagating along the tubes and shown that high mass sensitivity can be achieved by keeping the tube wall thin     

加强行业技术管理推动材料技术进步

论述了制定《航空工业材料及热工艺技术工作规定》的必要性和航空材料及热工艺的内涵及其重要性，提出确保航空产品质量是航空材料及热工艺技术管理工作的永恒主题，而加强和健全航空材料及热工艺技术管理机构，完善其规章制度则是保证航空产品质量的重要措施，该机构的主要职责是技术立法、技术发展和技术归口。     

Stabilization of wave equations coupled in parallel by viscous damping

In this article, we consider stabilization of two wave equations coupled in parallel by viscous damping. Uniform exponential stabilization can be achieved when damping is presented in two equations. In general only strong stabilization can be achieved when damping is present in one equation, while uniform exponential stabilization is still possible for some special cases.     

飞行人员骨密度与内分泌调节关系的探讨

对37名骨密度(BD)低下的飞行员(实验组)和BD正常的48名飞行员、100名地面人员(正常对照组)进行了BD和血清TT_3、TT_4、TSH IRMA、CT、PTH、E_2和T放射免疫测定。结果显示,实验组BD均值明显低于对照组(p<0.01),血清TT_3、TT_4、CT、E_2(女性)和T(男性)均值与对照组比较,大多数年龄存在着显著或非常显著差异(p<0.05或p<0.01)。同时对飞行人员BD与几种内分泌激素关系进行了探讨。     

Stability of Mixtoxantrone Hydrochloride in Solution

A stability-indicating reversed-phase high performance liquid chromatographic method was developed for the detection of mitoxantrone HC1 and its degradation products under accelerated degradation conditions. The degradation kinetics of mitoxantrone HC1 in aqueous solution over a pH range of 1.18 to 7.20 and its stability in propylene glycol-or polyethylene glycol 400-based solutions were investigated. The observed rate constants were shown to follow apparent first-order kinetics in all cases. The pH-rate profile shows that maximum stability of mitoxantrone HC1 was obtained at pH 4.01. No general acid or base catalysis from acetate or phosphate buffer species was observed. The catalysis rate constants on the protonated mitoxantrone imposed by hydrogen ion water and hydroxy ion were determined to be 3.72 × 10 min^-1 5.64 × 10-min^-1 and 1.108 × 10^-2min^-1, respectively. The degradation rate constants of mitoxantrone affected by different ionic strength systems. Irradiation with 254 nm UV light at 25±0.5°C was found when canpared with the light-protected controls. Incorporation of nonaqueous propylene glycol or polyethylene glycol in the pH 4.01 mitoxantrone solution shows an increase in its stability at 502±0.5°C.     

用热分析法研究硝化棉的熔化过程

用ＭＤＳＣ，显微镜温台熔点测定仪和固体原位反应池／快速扫描傅立叶变换红外光谱联用装置考察了硝化棉的熔化过程。ＭＤＳＣ曲线表明吸热过程是可逆的，它系由ＮＣ和部分分解凝聚相产物的混合物的固液相变所引起。由ＮＣ的ＭＤＳＣ曲线得到的熔点，熔化含，熔化熵，分解含和分解反应热温熵分别为４７６．８４Ｋ，２０５．６Ｊ．ｇ＾－１，０．４３１２Ｊ．ｇ＾－１．Ｋ＾－１，－２４７５．０Ｊ．ｇ＾－１，－５．２４２Ｊ．ｇ＾－     

新型聚丙烯酸(934P、980)树脂的制备

详细研究了以乙酸乙酯和环己烷为溶剂，丙烯酸为单体，BPO，LPO，AIBN为引发剂，聚烯基多醚为交联剂，合成增稠能力强、透明度高的聚丙烯酸树脂。于混和溶剂存在下制得的聚合物，消除了以往由二氯甲烷为溶剂的反应介质中所得产品的毒性，可广泛应用于医药及日用化工等行业。     

化学镀Ni—P镀层的X射线衍射研究

根据X射线衍射分析结果,对化学镀高P(含P>11wt％或19at％)Ni-P镀层加热时效时,镀层成分和加热温度对结构转变的影响作了研究,结果表明,高P共晶、过共晶(含P>11wt％或19at％)合金的结构转变有如下特征:(1)相同加热时效条件下,Ni-P合金的结构转变与成分有密切关系:(2)对同一成分的过共晶合金,Ni-P合金的结构转变与时效温度密切相关;(3)过共晶合金在290～360℃温度范围内时效处理,出现Ni_xP_y介稳相,X射线衍射分析认为Ni_xP_y为Ni_(12)P_5。