Two-dimensional symmetric multimode interferences in silicon square waveguides

Symmetric interference in two-dimensional multimode silicon waveguides is experimentally investigated. For a 100/spl times/100 /spl mu/m/sup 2/ cross section, 2700-/spl mu/m-long waveguide fabricated on silicon-on-insulator substrate, an 8/spl times/8 matrix of replicated images with high contrast ratio is demonstrated for 1530-1570 nm wavelength range. Symmetric interference results in reduced device length, and the actual device length is consistent with the theoretical expectation. The device also exhibits stable imaging in terms of good loss uniformity, and low wavelength and polarization dependencies among the replicated images.     

Local residence time,residence revolution,and residence volume distributions in twin‐screw extruders

This work was aimed at studying the overall, partial, and local residence time distributions (RTD); overall, partial and local residence revolution distributions (RRD) and overall, partial and local residence volume distributions (RVD) in a co‐rotating twin screw extruder, on the one hand; and establishing the relationships among them, on the other hand. Emphasis was placed on the effects of the type and geometry of mixing elements (a gear block and various types of kneading elements differing in staggering angle) and process parameters on the RTD, RRD and RVD. The overall and partial RTD were directly measured in‐line during the extrusion process and the local ones were calculated by deconvolution based on a statistical theory. The local RTD allowed comparing the mixing performance of mixing elements. Also it was confirmed both experimentally and theoretically that specific throughput, defined as a ratio of throughput (Q) over screw speed (N), controlled all the above three types of residence distributions, be they local, partial or overall. The RRD and RVD do not provide more information on an extrusion process than the corresponding RTD. Rather they are different ways of representing the same phenomena. POLYM. ENG. SCI., 48:19–28, 2008. © 2007 Society of Plastics Engineers     

状如琼，凝为脂

在我们喝的饮料粒粒橙中，为什么那些细小的橙子颗粒是悬浮在橙汁中的呢？果冻和布丁为什么是透明，且柔软有弹性的呢？去看看成分表，我们不难发现共同之处，看似不同的食品都添加了一种共同的成分——琼脂。[编者按]     

碳酸盐岩气藏加砂压裂重复改造试验效果分析

针对碳酸盐岩气藏部分气井生产效能低的状况，决定在长庆气田下古生界尝试开展加砂压裂重复改造试验，以期提高低产、低效气井的产量，延长气田稳产期。通过潜心研究、精细设计及现场质检监控，优选了4口老井进行加砂压裂重复改造现场试验。从试验结果来看，虽然只有1口井取得明显的改造效果，但4口井加砂压裂施工都是成功的，说明对碳酸盐岩气藏实施加砂压裂是可以实现的，但在选井思路和压裂工艺方面还有待探索和研究。     

Average consensus in networks of dynamic agents with switching topologies and multiple time-varying delays

In this paper, we discuss average consensus problem in undirected networks of dynamic agents with fixed and switching topologies as well as multiple time-varying communication delays. By employing a linear matrix inequality method, we prove that all the nodes in the network achieve average consensus asymptotically for appropriate communication delays if the network topology is connected. Particularly, several feasible linear matrix inequalities are established to determine the maximal allowable upper bound of time-varying communication delays. Numerical examples are given to demonstrate the effectiveness and the sharpness of the theoretical results.     

基于作业测定技术的后桥壳生产线工艺评价及优化

以某企业后桥壳生产线为研究对象,运用作业测定技术中的时间研究法,测定后桥壳各工序的标准时间,评价工艺及找到瓶颈工序;运用"5W1H"提问技术,根据"ECRS"原则,同时结合工艺设计及企业资源情况,对后桥壳生产线现有工艺进行评价及优化,改善后,使生产线的产能每天提高了10件,生产能力提高了33.57%.     

探讨某高级车库设计需要注意的几点问题

广州市现在每天增加的小汽车数量就在400辆以上，这种迅猛的增长势头除了对城市的交通运输网络造成很大的压力外，城市的停车缺口也在不断扩大，现在广州市的停车位缺口就在30万辆左右。针对这种情况，地方政府正在加大解决城市停车难问题的力度．其中一项措施就是增加建设停车库。     

从关联分析法看如何改善沥青抗老化性能

用灰色关联分析法研究了沥青抗老化性能与沥青化学组成之间的关联程度，结果表明，影响再生沥青性质的主要因素是沥青中的芳烃和胶质的含量。通过添加芳香组分能改善沥青四组分之间的配伍性，从而可以改善再生沥青的抗老化性能。并通过对再生剂进行富芳处理，验证了上述结论。     

镍氢电池负极用低成本储氢合金的研究

研究了ABS型储氢合金在低Co含量条件下，随B组元替代元素Co，Al，Si等含量的变化对合金电化学性能的影响规律，同时研究了A组元中不同La／Ce比对合金电化学性能的影响情况。结果表明，随合金中Co含量的降低，合金的活化性能和放电容量得以改善，但合金的循环寿命下降也比较明显；在试验范围内，随Al元素的加入，合金的循环寿命得以改善，但材料的放电容量和活化性能均有所下降；随合金La／Ce比的降低，合金的放电容量略有下降，但其循环寿命和放电电压平台有较大提高。     

Simulating a Smartboard by Real-Time Gesture Detection in Lecture Videos

Gesture plays an important role for recognizing lecture activities in video content analysis. In this paper, we propose a real-time gesture detection algorithm by integrating cues from visual, speech and electronic slides. In contrast to the conventional “complete gesture” recognition, we emphasize detection by the prediction from “incomplete gesture”. Specifically, intentional gestures are predicted by the modified hidden Markov model (HMM) which can recognize incomplete gestures before the whole gesture paths are observed. The multimodal correspondence between speech and gesture is exploited to increase the accuracy and responsiveness of gesture detection. In lecture presentation, this algorithm enables the on-the-fly editing of lecture slides by simulating appropriate camera motion to highlight the intention and flow of lecturing. We develop a real-time application, namely simulated smartboard, and demonstrate the feasibility of our prediction algorithm using hand gesture and laser pen with simple setup without involving expensive hardware.