In situ analysis of the strain evolution during welding using low transformation temperature filler materials

ABSTRACT

Compared to conventional welding consumables using low transformation temperature (LTT) filler materials is an innovative method to mitigate tensile residual stresses due to delayed martensite transformation of the weld. For the effective usage of LTT filler materials, a deeper understanding of the complex processes that lead to the final residual stress state during multi-pass welding is necessary. Transformation kinetics and the strain evolution of multi-pass welds during welding were investigated in situ at the beamline HEMS@PETRAIII, Germany. Compared to conventional welds, the total strain was reduced and compression strain was achieved when using LTT filler materials. For an optimal use of the LTT effect in the root of multi-pass welds, the alloying concept must be adapted taking care of dilution.     

Investigation of potential extreme load reduction for a two‐bladed upwind turbine with partial pitch

This paper presents a wind turbine concept with an innovative design combining partial pitch with a two‐bladed (PP‐2B) turbine configuration. Special emphasis is on extreme load reduction during storm situations at standstill, but operational loads are also investigated. In order to compare the loads and dynamics of the PP‐2B turbine, a partial pitch three‐bladed (PP‐3B) turbine and a normal pitch regulated three‐bladed (3B) turbine are introduced on the basis of solidity similarity scaling. From the dynamic comparisons between two‐ and three‐bladed turbines, it has been observed that the blade vibrations are transferred differently from the rotor to the tower. For a three‐bladed turbine, blade vibrations seen in a fixed frame of reference are split with ±1P only. A two‐bladed turbine has a similar split of ±1P but also includes contributions on higher harmonics (±2P, ±3P, … etc.). Further on, frequency split is also seen for the tower vibrations, where an additional ±2P contribution has been observed for the two‐bladed turbine. Regarding load comparisons, the PP‐2B turbine produces larger tower load variations because of 2P excitation during the operational cases. However, extreme loads are reduced by approximately 20% for the PP‐2B and 18% for the PP‐3B compared with the 3B turbine for the parked condition in a storm situation. Moreover, a huge potential of 60% is observed for the reduction of the extreme tower bottom bending moment for the PP‐2B turbine, when the wind direction is from ±90° to the turbine, but this also requires that the turbine is parked in a T‐configuration. © 2014 The Authors. Wind Energy published by John Wiley & Sons, Ltd.     

Activation effects during hydrogen release and uptake of MgH2

Scandium(II)hydride, ScH₂, and scandium(III)chloride, ScCl₃, are explored as additives to facilitate hydrogen release and uptake for magnesium hydride. These additives are expected to form more homogeneous composites with Mg/MgH₂ as compared to metallic scandium. However, scandium(III)chloride, reacts with MgH₂ during mechano-chemical treatment and form ScH₂ and MgCl₂ (that later crystallise during heat treatment). The composite MgH₂−ScH₂ was investigated using in-situ synchrotron radiation powder X-ray diffraction during up to five cycles of continuous release and uptake of hydrogen at isothermal conditions at 320, 400 and 450 °C and p(H₂) = 100–150 or 10⁻² bar. The data were analysed by Rietveld refinement and no reaction is observed between either MgH₂/ScH₂ or Mg/ScH₂ during cycling. The extracted sigmoidal shaped curves for formation or decomposition of Mg/MgH₂ suggest that a nucleation process is preceding the crystal growth. The reaction rate increases with increasing number of cycles of hydrogen release and uptake at isothermal conditions possibly due to activation effects. This kinetic enhancement is strongest between the first cycles and may be denoted an activation effect.     

Characterizing delamination of fibre composites by mixed mode cohesive laws

A novel method is used for the determination of mixed mode cohesive laws and bridging laws for the characterisation of crack bridging in composites. The approach is based on an application of the J integral. The obtained cohesive laws were found to possess high peak stress values. Mixed mode cohesive stresses were found to depend on both the normal and tangential crack opening displacements. The bridging laws, which are to be used together with a mode mixity dependent crack tip fracture energy, were found to possess relative low bridging stresses; the peak normal bridging stress was approximately 2 MPa during pure Mode I and the maximum shear stress during pure Mode II was about 10 MPa.     

Heavy Metal and PAH Concentrations in Highway Runoff Deposits Fractionated on Settling Velocities

The correlation between settling velocity and associated pollutant concentrations is of major importance for best management practice in designing, redesigning, or evaluation of the efficiency of existing pond facilities for retaining unwanted pollutants. The prospect of this note is to state the relationship between the settling velocity of the runoff particles and the corresponding metal and polyaromatic hydrocarbon (PAH) concentration directly instead of dealing with two unknowns—the density and the shape of a single particle fraction in a settling velocity calculations. The measurements show that the highest cadmium, chromium, zinc, and nickel concentrations is associated with the most slowly falling particles and the lowest concentration associated within the faster falling fraction. This tendency is not clear for some of the sediments due to high content of organic matter and clearly not for lead and copper and there is no significant correlation between PAH concentration and settling velocity. The largest mass of metals and PAH within each pond can be found on the particle fraction with a settling velocity of 5.5–2.5 mm/s.     

Climate-change impacts on hydrology and nutrients in a Danish lowland river basin

The Mike 11-TRANS modelling system was applied to the lowland Gjern river basin in Denmark to assess climate-change impacts on hydrology and nitrogen retention processes in watercourses, lakes and riparian wetlands. Nutrient losses from land to surface waters were assessed using statistical models incorporating the effect of changed hydrology. Climate-change was predicted by the ECHAM4/OPYC General Circulation Model (IPCC A2 scenario) dynamically downscaled by the Danish HIRHAM regional climate model (25 km grid) for two time slices: 1961-1990 (control) and 2071-2100 (scenario). HIRHAM predicts an increase in mean annual precipitation of 47 mm (5%) and an increase in mean annual air temperature of 3.2 degrees C (43%). The HIRHAM predictions were used as external forcings to the rainfall-runoff model NAM, which was set up and run for 6 subcatchments within and for the entire, Gjern river basin. Mean annual runoff from the river basin increases 27 mm (7.5%, p<0.05) when comparing the scenario to the control. Larger changes, however, were found regarding the extremes; runoff during the wettest year in the 30-year period increased by 58 mm (12.3%). The seasonal pattern is expected to change with significantly higher runoff during winter. Summer runoff is expected to increase in predominantly groundwater fed streams and decrease in streams with a low base-flow index. The modelled change in the seasonal hydrological pattern is most pronounced in first- or second-order streams draining loamy catchments, which currently have a low base-flow during the summer period. Reductions of 40-70% in summer runoff are predicted for this stream type. A statistical nutrient loss model was developed for simulating the impact of changed hydrology on diffuse nutrient losses (i.e. losses from land to surface waters) and applied to the river basin. The simulated mean annual changes in TN loads in a loamy and a sandy subcatchment were, respectively, +2.3 kg N ha(-1) (8.5%) and +1.6 kg N ha(-1) (6.9%). The rainfall-runoff model and the nutrient loss model were chained with Mike 11-TRANS to simulate the combined effects of climate-change on hydrology, nutrient losses and nitrogen retention processes at the scale of the river basin. The mean annual TN export from the river basin increased from the control to the scenario period by 7.7%. Even though an increase in nitrogen retention in the river system of 4.2% was simulated in the scenario period, an increased in-stream TN export resulted because of the simulated increase in the diffuse TN transfer from the land to the surface-waters.     

Acute health effects from exposure to indoor ultrafine particles—A randomized controlled crossover study among young mild asthmatics

Particulate matter is linked to adverse health effects, however, little is known about health effects of particles emitted from typical indoor sources. We examined acute health effects of short-term exposure to emissions from cooking and candles among asthmatics. In a randomized controlled double-blinded crossover study, 36 young non-smoking asthmatics attended three exposure sessions lasting 5 h: (a) air mixed with emissions from cooking (fine particle mass concentration): (PM_2.5: 96.1 μg/m³), (b) air mixed with emissions from candles (PM_2.5: 89.8 μg/m³), and c) clean filtered air (PM_2.5: 5.8 μg/m³). Health effects (spirometry, fractional exhaled Nitric Oxide [FeNO], nasal volume and self-reported symptoms) were evaluated before exposure start, then 5 and 24 h after. During exposures volatile organic compounds (VOCs), particle size distributions, number concentrations and optical properties were measured. Generally, no statistically significant changes were observed in spirometry, FeNO, or nasal volume comparing cooking and candle exposures to clean air. In males, nasal volume and FeNO decreased after exposure to cooking and candles, respectively. Participants reported additional and more pronounced symptoms during exposure to cooking and candles compared to clean air. The results indicate that emissions from cooking and candles exert mild inflammation in asthmatic males and decrease comfort among asthmatic males and females.     

On the existence of statistically hiding bit commitment schemes and fail-stop signatures

We show that the existence of a statistically hiding bit commitment scheme with noninteractive opening and public verifiability implies the existence of fail-stop signatures. Therefore such signatures can now be based on any one-way permutation. We also show that genuinely practical fail-stop signatures follow from the existence of any collision-intractable hash function. These are the weakest assumptions known to be sufficient for fail-stop signatures. Conversely, we show that any fail-stop signature scheme with a property we call thealmost unique secret key property can be transformed into a statistically hiding bit commitment scheme. All previously known fail-stop signature schemes have this property. We even obtain an equivalence, because we can modify the construction of fail-stop signatures from bit commitments such that it has this property.     

The dispersion model for hydration of portland cement I. General concepts

This paper introduces an analytical mathematical model for development of the hydration of Portland cement: t₀ + t₁A + t₂A² = t t is time, and t₀, t₁ and t₂ are time-constants depending on temperature, cement type, admixtures etc. A is the hydration ratio, i.e. the ratio of hydrated to unhydrated cement. The dispersion model has been derived on basis of the typical particle size distribution for tube-milled products. Earlier findings by us have proven the particle size distribution to be a dominant factor in the correct modelling of cement hydration. The parameterization of hydration curves, which is easily performed with this dispersion model, gives a sufficient characterization of these for purposes of practical interpretations of the effects of factors decisive for the development of hydration.