The femur-tibia control system of stick insects--a model system for the study of the neural basis of joint control

In a form of top-down analysis, the femur-tibia control system of stick insects is investigated. Open-loop experiments show that it is mainly velocity-sensitive with an extremely low velocity-threshold, that it possesses a very high gain and that it has only a very small phase reserve and thus works close to instability. The closed-loop system generates catalepsy. The system consists of a single sense organ with approximately 80 sense cells with known characteristics, a small number of interneurones (mainly non-spiking ones) and a small number of motor neurones. The characteristics of the whole system can quantitatively be attributed to the characteristics of its elements. The gain of the loop is state-dependent and the system is 'switched off' during active movements and replaced by a control system with different attributes. It is discussed that most of the characteristics of this system are, at least qualitatively, similar to joint control systems in other animals. Because the described system can be more easily investigated than other systems (especially in vertebrates) it can serve as a model against which more complicated joint control loops may be compared.     

Nontuberculous mycobacteriosis as a complication of the Swyer-James syndrome

The chest radiograph of a 35-year-old man with fatigue, exertional dyspnoea and haemoptyses revealed a cavity in the left upper lobe and a shrunken left lung with radiolucency greater than that on the right. Acid-fast rods in sputum were identified as Mycobacterium kansasii on culture. Scintigraphy showed a 9% residual perfusion on the left and abnormal ventilation, compatible with Swyer-James syndrome. This had favoured the development of a mycobacterial infection. There was also a decrease in ciliary function (rate of 4-7 Hz, normal: 10-11). Treatment, begun when tuberculosis had been suspected, was after sensitivity tests changed to a combination of rifampicin (600 mg), ethambutol (1600 mg) and protionamide (500 mg) daily. There was marked regression of the findings within 4 weeks, but treatment was prematurely stopped after 11 months. Two years later there was a recurrence which again responded well to the same drug regimen with additional sulphamethoxazole (1600 mg/d).     

Characterisation of sub-100 nm-MOS-transistors processed by optical lithography and a sidewall-etchback technique

This paper describes the fabrication of NMOS-transistors with a geometric gate length of down to 50 nm using conventional optical lithography and a modified sidewall-etchback process. Based on measurements the transistors are characterised and their device parameters are compared to simulations. Finally the procedures for further optimisation of the process will be explained.     

Nature of terpenoids of aTaxodioxylon gypsaceum from the fossil forest of Dunarobba (Italy)

A specimen fromt he fossil forest of Dunarobba (Central Italy) attributed toTaxodioxylon gypsaceum was chemically analyzed particularly for its terpene content. Main chemical constituents show variations related to ageing and carbonization process, while terpene content exhibits a drop of mono- and sesquiterpenes in favour of diterpenes and higher MW compounds. All components are exclusively hydrocarbons and represent alicyclic or partially aromatic structures. The identified families include abietane, phyllocladane, norabietane and norpimarane among diterpenes and traces of cadinane and selinane among sesquiterpenes.     

On the hot-carrier-induced post-stress interface trap generation inn-channel MOS transistors

A continued fast interface trap generation is observed in n-channel MOS transistors after termination of the hot-carrier stress. The magnitude of this post-stress effect is strongly dependent on the conditions of the preceding stress, on the post-stress conditions and on the process parameters. For measurements at 293 K, a simple model is proposed which is based on the release of hydrogen by the thermal detrapping of holes, and which can explain the observed dependencies. The importance of the post-stress D_it-generation is illustrated for the case of dynamic stress conditions where it can lead to an apparently deviating degradation behavior     

A 20-Gb/s silicon bipolar 1:4-demultiplexer IC

This paper presents a 20-Gb/s 1:4-demultiplexer for future fiber-optic transmission systems. It uses an 0.4-μm emitter double polysilicon 21-GHz f_T Si bipolar foundry process. This is the highest data rate of a 1:4-DEMUX reported so far in any technology. The 1:4-DEMUX features a tree-type architecture with one frequency divider and a channel switch circuit. The circuit design was carefully optimized to achieve high speed and moderate power dissipation. It consumes 1.4 W with a single -4.5-V supply     

High-power passively mode-locked semiconductor lasers

We have developed optically pumped passively mode-locked vertical-external-cavity surface-emitting lasers. We achieved as much as 950 mW of mode-locked average power in chirped 15-ps pulses, or 530 mW in 3.9-ps pulses with moderate chirp. Both lasers operate at a repetition rate of 6 GHz and have a diffraction-limited output beam near 950 nm. In continuous-wave operation, we demonstrate an average output power as high as 2.2 W. Device designs with a low thermal impedance and a smooth gain spectrum are the key to such performance. We discuss design and fabrication of the gain structures and, particularly, their thermal properties     

Impurity Distribution Behavior in Caprolactam Extraction with Environmentally Benign Mixed Solvents

In a previous study a solvent mixture of heptane containing 40 mass % heptanol was selected as an alternative in the industrial extraction of caprolactam to replace benzene, toluene, or chlorinated hydrocarbons. This work reports the equilibrium distribution ratio of caprolactam and four model impurities of organic nature, namely, cyclohexanone, aniline, n‐methylcaprolactam, and cyclohexane‐carboxamide, comparing the mixed solvents with toluene as a reference. The resulting phase equilibria were interpreted using the equilibrium stage model. Based on these calculations it was found that, compared to toluene, the co‐extracted fraction of cyclohexanone and aniline was higher, that of n‐methylcaprolactam was comparable, and that of cyclohexane‐carboxamide was lower using the mixed solvent. Overall, the mixed solvent reduced the fraction of co‐extracted impurities by almost 10 %.     

Screening of supports for the immobilization of pectinmethylesterase from acerola (Malpighia glabra L)

A partially purified extract of pectinmethylesterase (PME) from acerola fruit was immobilized on various supports: glass, celite, chrysotile, agarose, concanavalin A Sepharose 4B, egg shell, polyacrylamide and gelatin. In addition, reticulation with glutaraldehyde was assessed, as well as the use of gelatin in the presence of celite, glass and silica. The highest immobilization yields were obtained when the pectinmethylesterase was immobilized in concanavalin A Sepharose 4B (81.7%) and in gelatin‐water (78.0%). Copyright © 2004 Society of Chemical Industry