Neutron Stress Measurement of W‐Fiber Reinforced Cu Composite

Stress measurement methods using neutron and X‐ray diffraction were examined by comparing the surface stresses with internal stresses in the continuous tungsten‐fiber reinforced copper‐matrix composite. Surface stresses were measured by X‐ray stress measurement with the sin²ψ method. Furthermore, the sin²ψ method and the most common triaxal measurement method using Hooke's equation were employed for internal stress measurement by neutron diffraction. On the other hand, microstress distributions developed by the difference in the thermal expansion coefficients between these two phases were calculated by FEM. The weighted average strains and stresses were compared with the experimental results. The FEM results agreed with the experimental results qualitatively and confirmed the importance of the triaxial stress analysis in the neutron stress measurement.     

Numerical simulation of brittle fracture of thin-walled structures1

The model of brittle material, allowing for the determination of initiation and growth of cracks in thin-walled structures up to their destruction, is offered. Solutions of some problems are submitted: destruction of a plate at a homogeneous stress state; destruction of a beam at a pure bending; dynamic deformation and destruction of a plate with the concentrated mass having various initial speeds. Destruction of part of the material of the plate is shown to result in dynamic loss of stability of the solution.     

Design of radiation-emission measurements of an air-traffic surveillance radar

The current work presents the procedure of designing and carrying out measurements of radiation emission from an air-traffic surveillance radar. The system requirements are first given, and then the equipment used is described. The steps to determine the operating characteristics of the radar are specified in detail. The necessary methods for manual power measurements and calculations are next explained. Since the final measurement system was fully automated, its main features (topology, protocol of operation) are also given. Finally, some measurement results taken during the initial phase of system operation are presented and discussed.     

Phase Separation in Ternary Liquid Systems Tetradecane-n-Octanol (or Cyclohexanone)-Lanthanide(III) Nitrate Solvates with Tri-n-Butyl Phosphate

The phase diagrams of ternary liquid systems tetradecane-n-octanol (or cyclohexanone)-lanthanide(III) nitrate solvates with tri-n-butyl phosphate [Ln(NO₃)₃(TBP)₃, Ln = La, Ce, Pr, or Sm] at T = 298.15 K were studied. These diagrams contain areas of homogeneous solutions and an area of separation into two liquid phases (I, II). Phases I and II are enriched in tetradecane and Ln(NO₃)₃(TBP)₃, respectively. n-Octanol and cyclohexanone mainly pass into phase II.     

The Effect of Moisture Content on the Conversion of Ergosterol to Vitamin D in Shiitake Mushrooms

The distribution of ergosterol in different parts of shiitake mushrooms was studied in order to optimize the conversion of ergosterol to vitamin D₂ during drying. The effect of moisture on the conversion of ergosterol to vitamin D₂ was also investigated by adjusting the moisture content of fresh mushrooms to different levels in a large vacuum desiccator and subjecting them to UV irradiation at 290-320 nm wavelength, for 2 h. The moisture, ergosterol and vitamin D₂ contents were determined using standard procedures. It was found that the ergosterol content on a dry matter basis of fresh shiitake mushroom was highest in the gills (10.6 ± 0.99 mg/g DM), followed by the cap or pileus (5.34 ± 0.64 mg/g DM) and was least in the stalk or stipe (2.97 ± 0.56). The moisture content had a marked influence on the conversion of ergosterol to vitamin D₂, the best conversion taking place at a moisture content of about 70% on a wet basis.     

Optoviscosimetry of a Liquid Film by the Method of a Dispersed Magnetic Sublayer

A magnetooptical method of measurement of viscosity, which is based on recording the optical response (induced by the magnetic-field pulses) of a two-layer system resulting from the sedimentation of ferroparticles dispersed in the liquid under study, has been proposed. The procedure has been described and the results of measurement of the rheokinetics of a number of media, including polymer compositions formed into a thin film, in heating, evaporation, and polymerization have been presented.     

Algorithms for qualitative analysis of complex systems

Algorithms are proposed that construct first integrals and Lyapunov functions for stability analysis of stationary solutions of differential equations describing mechanical systems of linked bodies.Translated from Kibernetika i Sistemnyi Analiz, No. 1, pp. 138–148, January–February, 1992.