Properties of nylon 12 balloons after thermal and liquid carbon dioxide treatments

Critical design attributes of angioplasty balloons include the following: tear resistance, high burst pressures, controlled compliance, and high fatigue. Balloons must have tear resistance and high burst pressures because a calcified stenosis can be hard and nominal pressures of up to 16 atm can be used to expand the balloon. The inflated balloon diameter must be a function of the inflation pressure, thus compliance is predictable and controlled. Reliable compliance is necessary to prevent damage to vessel walls, which may be caused by over-inflation. Balloons are often inflated multiple times in a clinical setting and they must be highly resistant to fatigue. These design attributes are dependent on the mechanical properties and polymer morphology of the balloon. The effects of residual stresses on shrinkage, crystallite orientation, balloon compliance, and mechanical properties were studied for angioplasty nylon 12 balloons. Residual stresses of these balloons were relieved by oven heat treatment and liquid CO₂ exposure. Residual stresses were measured by quantifying shrinkage at 80 °C of excised balloon samples using a dynamic mechanical analyzer. Shrinkage was lower after oven heat treatment and liquid CO₂ exposure compared to the as-received balloons, in the axial and radial directions. As-received, oven heat treated, and liquid CO₂-exposed balloon samples exhibited similar thermal properties (T_g, T_m, X_t). Crystallite orientation was not observed in the balloon cylindrical body using X-ray scattering and polarized light microscopy, which may be due to balloon fabrication conditions. Significant differences were not observed between the stress–strain curves, balloon compliance, and average burst pressures of the as-received, oven heat treated, and liquid CO₂-exposed balloons.     

Steady-state creep of orthotropic rotating disks of variable thickness

Creep analysis of orthotropic rotating disks with variable thickness has been carried out for secondary stage of creep. Norton's power law of creep is employed to derive general expressions for stresses and strain rates in the disks. These expressions have been utilized to find stress and strain rate distributions for disks with the following types of thicknesses - (i) constant thickness, (ii) linearly varying thickness, and (iii) hyperbolically varying thickness. The numerical computations to study the effects of anisotropy and the profile of the disks on stresses and strains have been carried out employing the method of successive approximations. Five different cases of anisotropy have been considered. Selecting a certain type of material anisotropy and an optimum profile for the disk may result in a better design for the turbine disks.     

Identification of residues in the class II-associated Ii peptide (CLIP) region of invariant chain that affect efficiency of MHC class II-mediated antigen presentation in an allele-dependent manner

Invariant chain (Ii) associates with class II MHC molecules and is crucial for Ag presentation by class II molecules. A general explanation for how invariant chain (Ii) associates with polymorphic MHC class II molecules has been suggested by the crystallographic structure of CLIP (class II-associated Ii peptide) complexed with an HLA class II molecule, HLA-DR3. We show here that methionine residues at positions 93 and 99 in Ii are important in MHC class II-mediated Ag presentation, but function in an allele-dependent manner. Introduction of a Met-->Ala mutation at position 99 in Ii (M99AIi) impaired presentation of peptides derived from exogenous proteins by I-Ad and I-Au class II molecules. Mutating Met-->Ala in Ii at position 93 (M93AIi) abrogated presentation by I-Au molecules, but not by I-Ad. Impaired Ag presentation was associated with conformationally altered expression of I-A molecules on the surface of cells expressing mutated Ii. Cell surface CLIP staining and immunoprecipitation studies showed that both I-Ad and I-Au molecules were associated with an increased abundance of Ii peptides, CLIP, in cells expressing mutated Ii. These results show that methionine 93 and methionine 99 play an important physiologic role in Ii association with class II molecules by regulating release of CLIP from class II in the endocytic compartments to allow binding of cognate peptides.     

在双镶嵌铜互联中O.13微米器件生成用的基于PVD和ALD阻挡层的先进技术

1. Introduction The requirement of minimal bottom coverageand thick sidewall coverage for PVD-based films forlow via resistance and improved stress migration isnot easy to achieve with traditional depositionmethods. Modern I-PVD techniques give high bot-tom coverage, due to the ionized component of thedeposition flux. Sidewall coverage tends to be low,which is mainly due to off-normal deposition fluxand a less than unity sticking coefficient.     

Mechanistic and kinetic studies on the polymerization of styrene initiated by dimethyl sulfonium 2-pyridyl carbonyl methylide

Dimethyl sulfonium 2-pyridyl carbonyl methylide (Y_py-s) initiated radical polymerization of styrene in dimethyl sulfoxide at 85±0.1°C for 6 h under a nitrogen blanket using dilatometric techniques has been studied. The initiator and monomer exponent values were calculated to be 0.5 and 1.2, respectively. The system follows ideal radical kinetics with bimolecular termination. The higher monomer exponent value is ascribed to significant solvent effects on the initiation rate. The overall activation energy and average value of k²_p/k_t are 52.0 kJ mol^?1 and 1.0 × 10^?3 litre mol^?1 s^?1, respectively. The polymerization was retarded in the presence of hydroquinone or benzene; dimethylformamide, however, enhanced the rate of polymerization. Kinetic data and ESR studies indicate that the overall polymerization takes place via triplet carbene formation which acts as a source of free radicals.     

Environmental management of acid water problems in mining areas

Acid Mine Drainage (AMD) originates from the oxidation and leaching of sulphide minerals present in coal and metalliferrous ore bodies and gives rise to several environmental degradation problems. An investigation has been carried out to combat the acidic water problems. Results of this investigation indicate that application of anionic surfactant (sodium lauryl sulphate) and food preservatives (sodium benzoate and potassium sorbate) effectively abate the acid formation at low concentration levels (15–40 ppm) as tested in laboratory as well as at pilot-scale levels. Acidity, sulphate and iron concentrations are found to reduce by over 70 percent and remained low for more than three months after treatment. Thus this investigation demonstrates the management of these problems in an environmentally safe manner by controlling acid formation at its source.     

An animal model of Peyronie's-like condition associated with an increase of transforming growth factor beta mRNA and protein expression

PURPOSE: Transforming growth factor beta (TGF-beta) is involved in numerous vital processes including tissue fibrosis. Our objective was to study the role of TGF-beta in the induction of a Peyronie's-like condition and to produce an animal model for the further study of Peyronie's disease. MATERIALS AND METHODS: Twenty-four adult male Sprague-Dawley rats were divided into two groups. Different concentrations of cytomodulin, a synthetic heptopeptide with TGF-beta-like activity, were injected into the tunica of each rat from the first group (n = 18). Rats in the second group (n = 6) received saline injections as a control. The tunical tissues were taken after 3 days, 2 weeks, and 6 weeks and were examined using Hart and Trichrome stains. In the same tissue samples, TGF-beta mRNA and protein expression were studied. RESULTS: Histological alterations were observed in 15 out of 18 cytomodulin-injected rats, especially in tissue examined after 6 weeks. The most prominent changes were chronic cellular infiltration, focal and diffuse elastosis, thickening, disorganization and clumping of the collagen bundles. Results from immunoblot revealed remarkable TGF-beta1 protein expression in all the cytomodulin-injected rats only after 2 and 6 weeks. No remarkable TGF-beta2 or TGF-beta3 protein expression was observed. TGF-beta1 mRNA expression in the cytomodulin-injected rats was noticed in rats injected with higher concentrations after 3 days, while it was expressed in all rats after 2 weeks. There was no expression in the control group after either 3 days or 2 weeks. CONCLUSIONS: Cytomodulin can induce Peyronie's-like condition in the rat penis, which may explain the role of TGF-beta in the pathogenesis of Peyronie's disease.     

Spatial distribution of biomass consumption as energy in rural areas of the Indo-Gangetic plain

Biomass is widely used as energy source in rural households in India. Biomass samples and socio-economic data have been collected at district level in the rural areas of Indo-Gangetic plain (IGP), India to determine the emissions of trace gases and aerosols from domestic fuels. Dung cake, fuelwood and crop residue are main sources of energy in rural areas of the IGP. Dung cake is the major domestic fuel (80-90%) in the rural areas of Delhi, Punjab, Haryana, Uttar Pradesh, Bihar and West Bengal, whereas, 99% of rural households in Uttarakhand use wood as the main energy source. Using crop production data and usage of crop residues as energy, new consumption values have been estimated (21.13 Mt). Present information on the domestic fuel usage would be helpful in determining budgets estimates of trace gases and aerosols for India.     

Merox and Related Metal Phthalocyanine Catalyzed Oxidation Processes

Alkyl and aromatic mercaptans are among important organic sulfur compounds distributed in petroleum products. The mercaptans cause foul odor and are corrosive toward metals. In addition, mercaptans may cause oxidative deterioration as well as inhibit the performance of various additives (TEL, antioxidants) in finished products. Therefore, it is necessary to remove them, either by extractive processes or by converting them into innocuous disulfides. Such processes are usually referred to as “sweetening.”     

Gastric pneumatosis associated with preduodenal portal vein, duodenal atresia, and asplenia

An 8-day-old newborn presented with non-bilious vomiting, upper abdominal fullness, and failure to pass meconium. Plain radiographs revealed gastric pneumatosis (GP). At operation, he was found to have a non-obstructive preduodenal portal vein, preampullary duodenal atresia, asplenia, and malrotation. The baby was treated by duodeno-duodenostomy without mobilizing the portal vein and correction of the malrotation according to Ladd's procedure. He made an uneventful recovery and the GP resolved spontaneously. The malformative process was believed to have occurred at or soon after the 5th week of gestation, and the GP probably resulted from intramural air tracking through mucosal tears caused by high intragastric pressure.