Personal telecommunication radiation safety and the precautionary principle

The approach to risk management for RF and microwave radiation has been to establish guidelines for maximum permissible levels of exposure. These guidelines are based on evaluations of the relevant scientific literature and, with safety margins to account for uncertainties and gaps in scientific knowledge, offer a significant level of protection against established hazards of RF and microwave radiation for short-term exposures. One can argue, on this basis, that the precautionary principle - specifically, safety factors -have been used to guide the making and promulgation of existing permissible-exposure standards for RF and microwave radiation. Therefore, discussions on the appropriateness of the precautionary principle for RF radiation may be "much ado about nothing". Clearly, this approach to "pre caution" neither has stifled technological development, nor has it helped to enforce the acceptance of zero risk, but it provided a basis for action when science was unable to give a clear answer.     

Graph-theoretic construction of low-density parity-check codes

This article presents a graph-theoretic method for constructing low-density parity-check (LDPC) codes from connected graphs without the requirement of large girth. This method is based on finding a set of paths in a connected graph, which satisfies the constraint that any two paths in the set are either disjoint or cross each other at one and only one vertex. Two trellis-based algorithms for finding these paths are devised. Good LDPC codes of practical lengths are constructed and they perform well with iterative decoding.     

New hybrid fuzzy controller for direct torque control induction motor drives

A new hybrid fuzzy controller for direct torque control (DTC) induction motor drives is presented in this paper. The newly developed hybrid fuzzy control law consists of proportional-integral (PI) control at steady state, PI-type fuzzy logic control at transient state, and a simple switching mechanism between steady and transient states, to achieve satisfied performance under steady and transient conditions. The features of the presented new hybrid fuzzy controller are highlighted by comparing the performance of various control approaches, including PI control, PI-type fuzzy logic control (FLC), proportional-derivative (PD) type FLC, and combination of PD-type FLC and I control, for DTC-based induction motor drives. The pros and cons of these controllers are demonstrated by intensive experimental results. It is shown that the presented induction motor drive is with fast tracking capability, less steady state error, and robust to load disturbance while not resorting to complicated control method or adaptive tuning mechanism. Experimental results derived from a test system are presented confirming the above-mentioned claims.     

A new Pd-oxide-Al/sub 0.3/Ga/sub 0.7/As MOS hydrogen sensor

A new and interesting Pd-oxide-Al/sub 0.3/Ga/sub 0.7/As MOS hydrogen sensor has been fabricated and studied. The steady-state and transient responses with different hydrogen concentrations has been measured at various temperatures. Based on the large Schottky barrier height and presence of oxide layer, the studied device exhibits a high hydrogen detection sensitivity and wide temperature operating regime. The studied device exhibits the low-leakage current and obvious current changes when exposed to hydrogen-contained gas. Even at room temperature, a very high hydrogen detection sensitivity of 155.9 is obtained when a 9090 ppm H/sub 2//air gas is introduced. Furthermore, when exposed to hydrogen-contained gas at 95/spl deg/C, both the forward and reverse currents are substantially increased with increased hydrogen concentration. In other words, the studied device can be used as a hydrogen sensor under the applied bidirectional bias. Under the applied voltage of 0.35 V and 9090 ppm H/sub 2//air hydrogen ambient, a fast adsorption response time about 10 s is found. The transient and steady-state characteristics of hydrogen adsorption are also investigated.     

高压25MW背压式汽轮机振动分析与处理

厂内一台B25汽轮机,因振动超差,进行了20个月的分析、计算和试验,最后发现中心孔内有250 g左右的油水化合物,造成转子热弯曲,激发汽轮机出现振动严重超标.     

地震平衡技术及其在地震反演中的应用

地震平衡技术是一种在地震反演中改善井震关系的新技术。它通过单井对比、空间分形建模以及平衡处理的手段 ,克服地震反演中子波空变的影响 ,使得经过地震平衡技术处理的地震剖面井震关系得到较好改善 ,从而可以用统一的子波对研究区的地震资料进行反演     

从稳态到动态的空气调节

分析传统空调所提供的稳态参数微气候环境不一定能达到人的舒适和健康的要求,提出符合人本身生理习惯的空调送风方式应该是动态空气调节.认为个人可调节和适宜的环境渐变能同时保证舒适和健康两方面需要.     

协同作战能力简析

协同作战能力(CEC)是一种充分利用网络技术的新型海岸防空技术，给系统的作战能力带来了革命性的交破。本文对协同作战能力的产生、功能、组成以及未来的发展趋势作了详细的介绍，阐述了CEC系统的总体设计思想。在此基础上，将CEC系统与传统的作战系统的性能和设计思想在各方面进行了比较，交出了CEC系统各方面的优越性能。协同作战能力是现代和未来作战系统的发展方向，CEC系统的发展必将成为衡量各国国防科技现代化的重要指标。     

Data-efficient blind OFDM channel estimation using receiver diversity

We investigate non data-aided channel estimation for cyclically prefixed orthogonal frequency division multiplexing (OFDM) systems. By exploiting channel diversity using only two receive antennas, a blind deterministic algorithm is proposed. Identifiability conditions are derived that guarantee the perfect channel retrieval in the absence of noise. In the presence of noise, the proposed method has the desired property of being data efficient-only a single OFDM block is needed to achieve good estimation performance for a wide range of SNR values. The algorithm is also robust to input symbols as it does not have any restriction on the input symbols with regard to their constellation or their statistical properties. In addition, this diversity-based algorithm is computationally efficient, and its performance compares favorably to most existing blind algorithms.