Fracture Assessment of Carbon Fibre/Epoxy Reinforcing Rings through a Combination of Full-Scale Testing, Small-Scale Testing and Stress Modeling

Carbon fibre/epoxy rings are used as radial reinforcement for polymer bearing elements with nominal diameter 250 mm functioning under 150 MPa. Full-scale static and dynamic testing revealed no catastrophic failure for loading to 400 MPa, although there was circumferential splitting of carbon fibres at the machined top edge causing counterface wear under sliding. A combined numerical–experimental analysis was applied for design improvement with a representative small-scale qualification test on the real ring geometry, inducing additional stress concentrations compared to ASTM standards. Full-scale modelling revealed high radial–axial shear stresses (33 MPa) in non-hydrostatically loaded zones, while it increased towards 104 MPa under hydrostatic load conditions. The former is the most critical and should be simulated either on a small-scale unidirectional compression test or on a representative short beam shear test, respectively, measuring the radial–axial or radial–tangential shear strength. A relation between both small-scale states of stress was experimentally and numerically studied, experiencing that the composite ring has lower radial–tangential shear stress compared to radial–axial shear stress as a different hydrostatic stress state is observed in the bulk of the composite ring. As a compressive test is however more difficult to perform than a short-beam-shear test, a representative design criterion for shear fracture is determined from failure at 27 kN normal load in a short-beam-shear test. Finally, fracture is avoided by optimising the cross-sectional geometry of the composite reinforcing ring and close control of the processing parameters.     

Evaluating expectations about negative emotional states of aggressive boys using Bayesian model selection.

Researchers often have expectations about the research outcomes in regard to inequality constraints between, e.g., group means. Consider the example of researchers who investigated the effects of inducing a negative emotional state in aggressive boys. It was expected that highly aggressive boys would, on average, score higher on aggressive responses toward other peers than moderately aggressive boys, who would in turn score higher than nonaggressive boys. In most cases, null hypothesis testing is used to evaluate such hypotheses. We show, however, that hypotheses formulated using inequality constraints between the group means are generally not evaluated properly. The wrong hypotheses are tested, i.e.. the null hypothesis that group means are equal. In this article, we propose an innovative solution to these above-mentioned issues using Bayesian model selection, which we illustrate using a case study. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Longitudinal spillover effects of conflict resolution styles between adolescent-parent relationships and adolescent friendships.

This study longitudinally investigated spillover effects of conflict resolution styles in adolescent-parent relationships and adolescent friendships. Questionnaires about conflict resolution styles with parents and best friends were completed by adolescents from two age cohorts: 559 early adolescents (mean age 13.4) and 327 middle adolescents (mean age 17.7). Path analyses on two waves, with a three-year interval, indicated that in the early-to-middle adolescent group positive problem solving and conflict engagement spilled over from adolescent-parent relationships to adolescent friendships and not from adolescent friendships to adolescent-parent relationships. In the middle-to-late adolescent group, we found bidirectional spillover effects for these two conflict resolution styles. For withdrawal, we found bidirectional spillover effects in both cohorts. This study showed that both parents and friends set the stage for exercising and learning conflict resolution styles and thereby shape adolescents' future conflict behavior. (PsycINFO Database Record (c) 2011 APA, all rights reserved)     

Bidirectional links and concurrent development of parent-child relationships and boys' offending behavior.

This study examined different types of longitudinal associations (i.e., directional links and overlapping developmental changes) between children's delinquency and the quality of parent–child relationships from middle childhood to late adolescence. We used 10-wave interview data of 503 boys, their primary caregivers, and their teachers. Our first aim was to unravel the direction of effects between parent–child relationships and children's offending. Cross-lagged panel models revealed bidirectional links over time between poorer quality parent–child relationships and boys' offending across late childhood (age 7–10), early adolescence (age 10–13) and middle adolescence (age 13–16). Second, we examined the associations between mean changes in delinquency, on the one hand, and mean changes in relationship quality, on the other hand. Although parent–child relationships improved during childhood, their quality decreased in early adolescence and remained stable in middle adolescence. Delinquency increased only in middle adolescence. In five out of six models, the slope factors of relationship quality and offending were strongly correlated, indicating that stronger increases in delinquency were associated with stronger decreases in parent–child relationship quality across childhood, early adolescence, and middle adolescence. The discussion focuses on the theoretical implications of these two types of longitudinal associations. (PsycINFO Database Record (c) 2011 APA, all rights reserved)     

Design and performance of biofilters for the removal of alkylbenzene vapors

Three identical biofilters, run under the same conditions but inoculated with different mixed cultures, were fed a mixture of toluene, ethylbenzene, and o-xylene (TEX) gases. Inert porous perlite was used as support material, in contrast to the more conventional biofiltration systems where natural supports are used. Biodegradation started in all three biofilters a few hours after inoculation, without previous adaptation of the inocula to the toxic mixture. Despite acidification of the systems to pH values below 4·5, the elimination capacities reached were fully satisfactory. The best performing biofilter, in which bacteria were dominant, showed an elimination capacity of 70 g TEX m⁻³ h⁻¹ with a near complete removal of the mixture up to an influent concentration of 1200 mg TEX m⁻³ at a gas residence time of 57 s. Most of the ingoing carbon was recovered as carbon dioxide in the outgoing gas. In the other biofilters fungi dominated and performance was slightly worse. With single substrates, the elimination capacity was higher for toluene and ethylbenzene than for the TEX mixture, whereas o-xylene removal was slowest in all cases. Also when feeding the mixture to the biofilters, o-xylene was removed most slowly.     

Flavin adenine dinucleotide binding is the crucial step in alcohol oxidase assembly in the yeast Hansenula polymorpha

We have studied the role of flavin adenine dinucleotide (FAD) in the in vivo assembly of peroxisomal alcohol oxidase (AO) in the yeast Hansenula polymorpha. In previous studies, using a riboflavin (Rf) autotrophic mutant, an unequivocal judgement could not be made, since Rf-limitation led to a partial block of AO import in this mutant. This resulted in the accumulation of AO precursors in the cytosol where they remained separated from the putative peroxisomal AO assembly factors. In order to circumvent the peroxisomal membrane barrier, we have now studied AO assembly in a peroxisome-deficient/Rf-autotrophic double mutant (Δper1.rif1) of H. polymorpha. By sucrose density centrifugation and native gel electrophoresis, three conformations of AO were detected in crude extracts of Δper1.rif1 cells grown under Rf-limitation, namely active octameric AO and two inactive, monomeric forms. One of the latter forms lacked FAD; this form was barely detectable in extracts wild-type and Δper1 cells, but had accumulated in the cytosol of rif1 cells. The second form of monomeric AO contained FAD; this form was also present in Δper1 cells but absent/very low in wild-type and rif1 cells. In vivo only these FAD-containing monomers associate into the active, octameric protein. We conclude that in H. polymorpha FAD binding to the AO monomer is mediated by a yet unknown peroxisomal factor and represents the crucial and essential step to enable AO oligomerization; the actual octamerization and the eventual crystallization in peroxisomes most probably occurs spontaneously.     

Native Liquid Chromatography and Mass Spectrometry to Structurally and Functionally Characterize Endo-Xylanase Proteoforms

Xylanases are of great value in various industries, including paper, food, and biorefinery. Due to their biotechnological production, these enzymes can contain a variety of post-translational modifications, which may have a profound effect on protein function. Understanding the structure–function relationship can guide the development of products with optimal performance. We have developed a workflow for the structural and functional characterization of an endo-1,4-β-xylanase (ENDO-I) produced by Aspergillus niger with and without applying thermal stress. This workflow relies on orthogonal native separation techniques to resolve proteoforms. Mass spectrometry and activity assays of separated proteoforms permitted the establishment of structure–function relationships. The separation conditions were focus on balancing efficient separation and protein functionality. We employed size exclusion chromatography (SEC) to separate ENDO-I from other co-expressed proteins. Charge variants were investigated with ion exchange chromatography (IEX) and revealed the presence of low abundant glycated variants in the temperature-stressed material. To obtain better insights into the effect on glycation on function, we enriched for these species using boronate affinity chromatography (BAC). The activity measurements showed lower activity of glycated species compared to the non-modified enzyme. Altogether, this workflow allowed in-depth structural and functional characterization of ENDO-I proteoforms.     

A fuzzy logic approach to reliable real-time recognition of facial emotions

Multimedia Tools and Applications - This paper represents our newly developed software for emotion recognition from facial expressions. Besides allowing emotion recognition from image files and...     

Pressure-driven reverse-phase liquid chromatography separations in ordered nonporous pillar array columns

Building upon the micromachined column idea proposed by the group of Regnier in 1998, we report on the first high-resolution reversed-phase separations in micromachined pillar array columns under pressure-driven LC conditions. A three component mixture could be separated in 3 s using arrays of nonporous silicon pillars with a diameter of approximately 4.3 microm and an external porosity of 55%. Under slightly retained component conditions (retention factor k' = 0.65-1.2), plate heights of about H = 4 microm were obtained at a mobile phase velocity around u = 0.5 mm/s. In reduced terms, such plate heights are as low as hmin = 1. Also, since the flow resistance of the column is much smaller than in a packed column (mainly because of the higher external porosity of the pillar array), the separation impedance of the array was as small as E = 150, i.e., of the same order as the best currently existing monolithic columns. At pH = 3, yielding very low retention factors (k' = 0.13 and 0.23), plate heights as low as H = 2 microm were realized, yielding a separation of the three component mixture with an efficiency of N = 4000-5000 plates over a column length of 1 cm. At higher retention factors, significantly larger plate heights were obtained. More experimental work is needed to investigate this more in depth. The study is completed with a discussion of the performance limits of the pillar array column concept in the frame of the current state-of-the-art in microfabrication precision.