Dynamic programming implementation on array processor architectures

Dynamic Programming (DP) applies to many signal and image processing applications including boundary following, the Viterbi algorithm, dynamic time warping, etc. This paper presents an array processor implementation of generic dynamic programming. Our architecture is a SIMD array attached to a host computer. The processing element of the architecture is based on an ASIC design opting for maximum speed-up. By adopting a torus interconnection network, a dual buffer structure, and a multilevel pipeline, the performance of the DP chip is expected to reach the order of several GOPS. The paper discusses both the dedicated hardware design and the data flow control of the DP chip and the total array.This work was supported in part by the NATO, Scientific and Environmental Affairs Division, Collaborative Research Grant SA.5-2-05(CRG.960201)424/96/JARC-501.     

A neural network-based power system stabilizer using power flowcharacteristics

A neural network-based power system stabilizer (neuro-PSS) is designed for a generator connected to a multi-machine power system utilizing the nonlinear power flow dynamics. The use of power flow dynamics provides a PSS for a wide range of operation with reduced size neural networks. The neuro-PSS consists of two neural networks: neuro-identifier and neuro-controller. The low-frequency oscillation is modeled by the neuro-identifier using the power flow dynamics, then a generalized backpropagation-through-time (GBTT) algorithm is developed to train the neuro-controller. The simulation results show that the neuro-PSS designed in this paper performs well with good damping in a wide operation range compared with the conventional PSS     

Ozone micro-bubble disinfection method for wastewater reuse system.

Reuse of wastewater is regarded as one important way to deal with the world's shortage of potable water. The authors focused on a disinfection system using micro-bubbles and evaluated its capability for wastewater reuse. This paper reports experimental results from examination of the basic characteristics of micro-bubbles and disinfection of secondary effluent by air or ozone micro-bubbles. The results suggest that when micro-bubbles are applied in an ozonation system it is possible to reduce the reactor size, the amount of ozone decomposition equipment needed and the ozone dose rate.     

Laser scanning path generation considering photopolymer solidification in micro-stereolithography

It is essential to automate the scanning path generation process to effectively implement the micro-stereolithography. However, a scanning path that is generated based only on a 3D CAD model introduces dimensional inaccuracies. In micro-stereolithography, the photopolymer solidification is affected by fabrication conditions, such as the optical properties (laser power, laser scanning speed, laser scanning pitch focusing condition, etc.) and material properties of the photopolymer. Thus, the photopolymer solidification phenomena must be considered when generating a laser scanning path. In this paper, a scanning path generation algorithm that uses 3D CAD data and considers the photopolymer solidification phenomena is proposed to improve the dimensional accuracy in micro-stereolithography. Multi-line photopolymer solidification experiments were performed for various laser scanning conditions to examine the photopolymer solidification phenomena. From these experiments, linear relations between the solidification length (width) and scanning length (width) were acquired and stored in a database. Subsequently, these data were utilized to compensate the scanning path of the laser beam. In addition, experiments for determining the layer thickness in the z-direction were performed and these results were also used in the scanning path generation algorithm.This research was supported by the Highly Advanced National Project (http://www.most.go.kr), which performs some of the National R&D Program, and sponsored by the Korean Ministry of Science and Technology under the contract project code M10214000116-02B1500-02010.     

Removal of E. coli and helminth eggs in UASB: Polishing pond systems in Brazil.

Ponds following anaerobic reactors, such as Upflow Anaerobic Sludge Blanket (UASB) reactors, have been termed polishing ponds in the literature. The present paper analyses the removal of E. coli and helminth eggs in five UASB-polishing pond systems in Brazil. Since there were ponds in series, the total number of ponds was 10. The ponds had average retention times varying from 2 to 21 days, and depths ranging from 0.40 to 2.00 m. The shallow ponds in series, even with low retention times, were able to produce effluents complying with the coliform WHO guidelines for unrestricted irrigation (< or = 1000 MPN/100 ml). An equation for the coliform decay coefficient was proposed: Kb (dispersed flow) = 0.710H(-0955) (20 degrees C). The equation highlights the inverse relationship between the pond depth and the decay coefficient. All polishing pond systems were able to produce effluents with helminth eggs concentrations predominantly equal to zero, and satisfying the WHO guidelines for unrestricted and restricted irrigation (< or = 1 egg/L, arithmetic mean). The approximate range of helminth eggs removal efficiency was predicted satisfactorily.     

Acidogenic fermentation of blended food‐waste in combination with primary sludge for the production of volatile fatty acids

The performance of a laboratory‐scale anaerobic acidogenic fermenter fed with a mixture of blended kitchen food‐waste and primary sludge from a sewage treatment plant was investigated for the production of volatile fatty acids (VFA). The operating variables for acidogenic fermentation were kitchen food‐waste content (10 and 25 wt %), hydraulic retention time (HRT: 1, 3 and 5 days), temperature (ambient: 18 ± 2 °C, and mesophilic: 35 ± 2 °C) and pH (varied from 5.2 to 6.7). The experimental results indicated that effluent VFA concentrations and VFA production rates were higher at ambient temperature than at mesophilic conditions. The net amount of VFA with 10 wt % food‐waste increased up to 920 mg dm^?3 with an increase of HRT, but contrasting results (a decrease of 2610 mg dm^?3) were found due to the conversion of VFA into biogas in the case of 25 wt % food‐waste, which increased significantly at HRT of 3–5 days. In terms of biogas composition (CO₂ and CH₄), the organic matter was converted into CO₂ through the oxidative pathway by facultative species at low temperature while mesophilic temperature and optimum pH (6.3–7.8) played a pivotal role in increasing rate of conversion of VFA into biogas by methanogenesis. Rates of VFA production and their conversion are dependent on the food‐waste content in the mixture. Yet, the higher concentration of food‐waste (25% compared with 10%) did not produce VFA proportionally due to the increased rate of conversion of VFA into gaseous products. The maximum VFA production rate (0.318 g VFA_produced g^?1 VS_fed day^?1) was achieved in the 10 wt % food‐waste at ambient temperature and at a 5‐day HRT. Copyright © 2005 Society of Chemical Industry     

Intraoperative neurological monitoring

Intraoperative neurological monitoring (INM) is the evaluation of the nervous system within the operating room (OR) environment. In this paper, the INM system is tested in a clinical setting in comparison with conventional somatosensory evoked potential (SEP) monitoring. The study results demonstrate the capability of the INM system in extracting clearer and more stable SEP signals. The high SNR of SEP signals collected in various clinical environments, including the OR, makes the INM system a robust platform for continuous monitoring. While the current use of EP monitoring is limited to intermittent analysis by a highly trained clinical neurophysiologist, the authors believe in changing this paradigm by developing continuous monitoring systems, such as the INM system, capable of automated quantitative EP analysis. This noninvasive monitoring modality will allow for a wider range of use in clinical practice. Based on volunteer and clinical patient studies, the INM monitoring system demonstrates much greater reliability and accuracy via the artifact rejection and denoising strategies. It provides more strategic filtering options for different situations under which the clinical SEP response signal could be greatly contaminated and distorted. Furthermore, the INM system offers a promising approach to signal extraction in real-time monitoring during SEP research.     

Effects of solid retention time on the performance of submerged anoxic/oxic membrane bioreactor.

In this study, four similar bench-scale submerged Anoxic/Oxic Membrane Bioreactors (MBR) were used simultaneously to investigate the effects of solids retention time (SRT) on organic and nitrogen removal in MBR for treating domestic wastewater. COD removal efficiencies in all reactors were consistently above 94% under steady state conditions. Complete conversion of NH(4+)-N to NO(3-)-N was readily achieved over a feed NH(4+)-N concentration range of 30 to 50 mg/L. It was also observed that SRT did not significantly affect the nitrification in the MBR systems investigated. The average denitrification efficiencies for the 3, 5, 10 and 20 days SRT operations were 43.9, 32.6, 47.5 and 66.5%, respectively. In general, the average effluent nitrogen concentrations, which were mainly nitrate, were about 22.2, 27.6, 21.7 and 13.9 mg/L for the 3, 5, 10 and 20 days SRT systems, respectively. The rate of membrane fouling at 3 days SRT operation was more rapid than that observed at 5 days SRT. No fouling was noted in the 10 days and 20 days SRT systems during the entire period of study.     

Rapid and comprehensive indicator for evaluation of performance of treatment processes and of river waters.

Naturally occurring UV active compounds, commonly present in almost all source waters, can be rapidly monitored by their ultraviolet absorbance at 260 nm (E260). Herein, the extent of correlation between the E260 and the removal efficiency of the hazardous contaminants, endocrine disrupters and dioxins, were investigated using various treatment and river source waters. The detection of various types of hazardous contaminants using sophisticated analytical methods, such as high resolution gas chromatography (HRGC)/high resolution mass spectrometry (HRMS) and high performance liquid chromatography (HPLC)/inductively coupled plasma (ICP)/mass spectrometry (MS), as well as various short-term bioassays, can require hours or even days for results to be obtained. The removal of the E260 correlated well with those of individual contaminants, such as endocrine disruptor chemicals and dioxins, with the various treatment processes employed. In the plots of the endocrine disrupters against the DOC/E260, a correlation was found with the endocrine activity of the Korean/Japanese river waters employed in this study.