一种有效的振动信号分离算法

振动信号包含随机成分与周期成分 ,其中的随机成分占据了很宽的频域 ,其能量极易引起其它设备特别是电子设备的共振 ,从而导致设备失效。为评估随机成分对设备的影响 ,需要将周期成分从振动信号中去除。为此 ,首先使用ARMA建模法对振动信号中周期成分出现的频率位置进行估计 ,然后设计阻带带宽极窄 (小于 0 .5Hz)的V型滤波器来完成相应的滤波。实验表明本文中的方法能有效地去除振动信号中的周期成分 ,而完整地保留随机成分     

砖烟囱集团装药定向爆破拆除

对一座 40 m 高的砖烟囱,采用TNT集团装药实施定向倒塌拆除爆破.介绍了该烟囱拆除爆破工艺技术,爆破参数和施工方法.     

Preparation and optical properties of CdxHg1-xTe doped silica glass

In this paper, the Cd_xHg_1-xTe (x=1-0.7) doped silica glass was prepared through two step sol-gel process and in-situ growth technique from tetraethoxysilane (TEOS), cadmium acetate, mercury acetate and telluric acid. The influence of various factors on the glass was studied. The structure of the microcrystals was investigated by XRD. The absorption and transmittance spectrum of the composite showed that the shift of absorption edge was in conformity with the quantum size effect. The third-order nonlinear optical susceptibility χ⁽³⁾ was measured by the degenerate four wave mixing (DFWM). The values of χ⁽³⁾ was in the range of 10^-11-10^-12 MO esu at wavelength of 1.06 μm.     

南水北调中线总干渠水头优化分配

南水北调中线总干渠渠道线路长,建筑物数量大、类型多,进行水头优化分配对于节省工程投资,合理的进行总干渠工程布置有着重要的意义.通过优化计算,提出了总干渠水头优化分配方案,确定了3个渠段之间的水头分配值以及各段内分段渠道和各个建筑物的水头分配值,并对方案进行了验证.     

苦味酸钾点火药在电点火头中的应用

通过理论分析和试验,从机械感度、燃烧精度、热安定性、性能、长贮等方面,对比分析了苦味酸钾点火药与DDNP点火药.结果表明:在电点火头制造中,采用苦味酸钾作为点火药的主要组分,具有热稳定性好、药头机械强度高、生产过程废品少、无环境污染等优点,尤其有利于提高电雷管的发火可靠性和一致性.     

电子电气设备的熔断器、断路器保护

熔断器、断路器是电子电气设备最常用的保护电器,熔断器可以实现过载、短路保护,断路器除具上述功能外,还能实行失压保护.根据线路特点和所保护的设备,采取相应的保护设施,确保用电安全.     

尿素对以硝酸铝和葡萄糖为原料合成氮化铝粉末反应过程中相变及反应速率的影响

以硝酸铝(Al(NO3)3·9H2O)和葡萄糖(C6H12O6·H2O)为原料,利用碳热还原法制备氮化铝粉末,研究了尿素对前驱物的制备及前驱物氮化反应的影响,研究发现添加尿素合成的前驱物和未添加尿素合成的前驱物在氮化反应过程中相变和反应速率存在较大差异。在没有添加尿素合成的前驱物的氮化反应过程中,出现了γ-Al2O3、α-Al2O3、AlON和AIN相,该前驱物的反应速率慢,完全氮化需要在1600℃下才能完成。对于添加尿素合成的前驱物而言,在其氮化反应过程中仅出现了γ-Al2O3和AIN相,没有α-Al2O3和AlON的生成,AIN直接由γ-Al2O3氮化生成,该前驱物的氮化反应速率快,氮化反应温度低,在1400℃下即可实现完全氮化。分析讨论了两种前驱物的氮化反应速率不同的主要原因,并利用XRD、SEM等分析方法对粉末进行了表征。     

FBOLES—outline of a frequency-based on-line expert system approach for fault diagnoses in nuclear power plants

The basic concept of a novel frequency-based on-line expert system (FBOLES) approach for on-line fault diagnoses in nuclear power plants has been presented previously. This paper reports further progress, and includes how to express the uncertainties of expert opinion in knowledge-bases and propagate then in inferences, and how to deal with imperfect knowledge-bases. It also describes the main elements of FBOLES and outlines how the system works under complex conditions including the dynamic behavior of signals during accidents, multiple failures, and on-line changes of plant operation mode. Its ability to diagnose root causes of accidents has been tested using the main steam and feedwater condensate systems of a full-scale, three-loop, 950 MW nuclear power plant simulated by the Tsinghua simulator. So far the results seem good.     

Using thermally stimulated currents to find defective capacitors

BaTiO₃ multilayer capacitors with a nominal capacitance of 3.5nF have been carefully measured using the thermally stimulated current (TSC) technique. When a 300V polarization voltage is applied at room temperature, a new TSC peak appeared in defective sample A after it has been immersed in water. No new peak was found in good-quality sample B after a similar treatment. The accelerated life test shows that sample A hasa much shorter life than sample B in terms of insulation resistance.     

胶溶法合成 TiO_2超微粒子

用胶溶法合成了 TiO_2超微粒子。研究了反应物浓度、胶溶剂用量、胶溶温度对胶溶过程的影响,以及表面活性剂 DBS 的量与 Ti 萃取率的关系。探讨了合成超微粒子 TiO_2的最佳条件,分析了产品的特性。200℃热处理得到的产品为非晶型圆球状,粒度均匀,平均6.0nm,在许多有机溶剂中具有良好的分散性和透明性。550℃得到晶态锐钛矿型超微粒子 TiO_2,粒度为8.5nm。700℃热处理得到金红石型TiO_2,粒度为33.2nm。