我国建筑石油沥青标准的沿革及现状

论述了我国建筑沥青标准的变化历程及现状,对我国建筑沥青的生产、产品质量情况及现行国家标准GB/T 494-1998《建筑石油沥青》的不足之处进行了分析。提出了今后应生产的建筑沥青品种及应参照美国材料与试验协会标准ASTM D312《屋顶用沥青的标准规格》、我国石化行业标准SH/T0002-1990(1998)《防水防潮石油沥青》,修订GB/T494- 1998的建议。以进一步达到增加建筑沥青牌号,提高建筑沥青质量和使用性能的目的,满足建筑工业的发展对沥青多牌号、高质量、使用性能好的要求。     

三重介质油藏干扰试井压力动态特征

在建立三重介质油藏试井解释模型的基础上，对该类油藏的干扰试井压力动态变化进行了研究；分析了井筒储存、表皮系数、窜流系数以及弹性储容比对观测井井底压力的影响。结果表明，表皮系数对观测井的井底压力没有影响，而井筒储存是否会对观测井井底压力造成影响取决于井筒储存系数的大小以及激动井和观测井之间的距离，窜流系数和弹性储容比对观测井井底压力的影响与单井试井的结果相类似。     

Cu基络合物催化甲醇液相氧化羰化反应

针对甲醇液相氧化羰基化法合成碳酸二甲酯(DMC)工艺,开发了新型Cu基络合催化剂(CuB rnLm)。对CuB rnLm催化剂的活性及其稳定性进行了研究。实验结果表明,采用该催化剂,甲醇转化率和DMC选择性较高;元素价态和物质结构分析表明,CuB rnLm催化剂循环使用5次后仍保持较好的稳定性。采用正交设计和中心响应曲面法设计实验,并使用S tatistica软件进行统计分析,寻求出反应的主要影响因素,并得到优化的工艺条件:反应温度100~110℃、反应压力3.0~3.5M Pa、反应时间4~6h、CuB rnLm催化剂质量浓度(以甲醇的体积计)0.15~0.20g/mL。在此工艺条件下,甲醇转化率可达23%以上,DMC的选择性为96%~98%。     

Applications and Technologies of All-Solid State Blue Laser

1 Introduction Along with the matureness of laser diode (LD) manufacturing technology, the performance of LD has been improved greatly since 1980s, so various kinds of laser devices based on LD have been developed rapidly, especially the all-solid state lasers. After early experiments and researches, the all-solid state lasers have been commercialized successfully.     

A refined algorithm for multisensor image registration based on pixel migration.

Multimodality image registration via pixel migration is a powerful approach. However, it suffers from a serious problem--the global maximum on the sum of squared gradient magnitude (SSG) surface does not correspond to the correct solution of registration. To solve the problem, we partition the search space into feasible and infeasible regions. The genetic algorithm (global optimizer) is used to obtain a good initial estimate of registration parameters and followed by a fast refining with Powell's approach (local optimizer). The experimental results demonstrate that the use of this modified pixel migration algorithm on multisensor image registration is very effective.     

Reduced-rate retransmissions for spread-spectrum packet radio multimedia networks

A reduced-rate retransmission (RRR) scheme is proposed for improving the throughput performance of spread-spectrum packet radio networks. The scheme takes advantages of the available multi-rate scalable source coding techniques. It assumes that several versions of a data packet with different sizes (number of information bits) are available. The transmission of a packet starts from its full-size version. If the full-size version is not correctly received, its half-size version is used in the retransmission. If further retransmissions are needed, the quarter-size version and so on are used. The shrunk packets are transmitted either in a minislot if the processing gain is kept the same, or occupying a slot duration by increasing the processing gain proportionally. In both cases, the effective signal to interference ratio for a packet is increased. As a result, the system throughput is improved. Theoretical and numerical results are provided in this paper which illustrate the throughput improvement. Another advantage of the proposed RRR scheme is that the packet-size reduction provides finer granules for link adaptation. Therefore, it is especially suitable for multimedia applications for which codes of variable rate for the source data are available and which can tolerate gracefully degraded quality of service. The performance of the proposed scheme in fading channels is also addressed.     

移动自组网地址配置问题的研究

MANET（Mobile Ad hoc Network）中没有一个永久的中心机构，其网络拓扑结构不断变化，所以必须有一种能够对网络主机地址动态自配置和管理的协议。给出了在MANET中动态地址自配置与管理的方法，不同方案的特点及适应情况，最后对目前Ad hoc网络地址配置研究进行总结和展望。     

数字电视用中分辨率74cm纯平彩色显像管BC配列不良的分析与对策

通过对74cm中分辨率纯平彩色显像管BC配列局部严重群散不良的调查分析,确定荫罩受力塌陷是主要原因,通过改良设计、工艺优化及其它方面的综合对策,使以上技术难题得到满意的解决,整管不良率由4.78%下降到0.172%。     

电磁发射兵器用电容器的选取

本文首先从理论上论述了膜电容器的储能密度与寿命之间的关系，对国际电容器制造水平和趋势进行了分析，提出采用干式金属化膜电容器作为储能元件。最后，根据电磁发射兵器整体寿命配合原则，提出高储能密度脉冲电容器的合理寿命指标。     

基于FPGA的ASI信号接收与发送的实现

提出了一种用FPGA芯片代替Cypress公司的CY78933和CY78923芯片来实现ASI信号接收与发送的方案，详细阐述了DVB—ASI接口的硬件组成与FPGA实现，该接口符合DVB—ASI的接口规范，可实现270Mbps的信号传输，已经得到实际运用。