Preparation and optical properties of CdxHg1-xTe doped silica glass

In this paper, the Cd_xHg_1-xTe (x=1-0.7) doped silica glass was prepared through two step sol-gel process and in-situ growth technique from tetraethoxysilane (TEOS), cadmium acetate, mercury acetate and telluric acid. The influence of various factors on the glass was studied. The structure of the microcrystals was investigated by XRD. The absorption and transmittance spectrum of the composite showed that the shift of absorption edge was in conformity with the quantum size effect. The third-order nonlinear optical susceptibility χ⁽³⁾ was measured by the degenerate four wave mixing (DFWM). The values of χ⁽³⁾ was in the range of 10^-11-10^-12 MO esu at wavelength of 1.06 μm.     

FBOLES—outline of a frequency-based on-line expert system approach for fault diagnoses in nuclear power plants

The basic concept of a novel frequency-based on-line expert system (FBOLES) approach for on-line fault diagnoses in nuclear power plants has been presented previously. This paper reports further progress, and includes how to express the uncertainties of expert opinion in knowledge-bases and propagate then in inferences, and how to deal with imperfect knowledge-bases. It also describes the main elements of FBOLES and outlines how the system works under complex conditions including the dynamic behavior of signals during accidents, multiple failures, and on-line changes of plant operation mode. Its ability to diagnose root causes of accidents has been tested using the main steam and feedwater condensate systems of a full-scale, three-loop, 950 MW nuclear power plant simulated by the Tsinghua simulator. So far the results seem good.     

Using thermally stimulated currents to find defective capacitors

BaTiO₃ multilayer capacitors with a nominal capacitance of 3.5nF have been carefully measured using the thermally stimulated current (TSC) technique. When a 300V polarization voltage is applied at room temperature, a new TSC peak appeared in defective sample A after it has been immersed in water. No new peak was found in good-quality sample B after a similar treatment. The accelerated life test shows that sample A hasa much shorter life than sample B in terms of insulation resistance.     

覆膜滤料的滤尘性能测试方法研究

由于覆膜滤料的结构和性能有别于普通滤料，因而普通滤料的滤尘性能测试方法不完全适用于覆滤料。本文作者在总结实践经验的基础上，提出了在覆膜滤料的滤尘性能测试中应注意的一些问题和应增加的测试项目。     

Adaptive output-feedback tracking of stochastic nonlinear systems

We address the adaptive stabilization and tracking problems for a class of output feedback canonical systems driven by Wiener noises of unknown covariance. Filtered transformation and backstepping techniques are employed in the stochastic control design. We obtain two adaptive controllers that guarantee the global stability in probability for vanishing perturbations or the input-to-state stability in probability for nonvanishing perturbations respectively. The tracking error can converge to a small residual set around the origin in the sense of mean quartic value.     

Novel blood-compatible waterborne polyurethane using chitosan as an extender

A series of novel block polymers of polyurethane (PU) and chitosan have been prepared in two steps. The first step is the preparation of PU prepolymer, obtained from polytetramethylene oxide glycol (PTMO, M_n = 1000), isophrone diisocyanate (IPDI), and 2,2′-dimethylol propionic acid (DMPA), followed by ionizing PU prepolymer with triethylamine (TEA). The second step involves PU chain-extended by water-soluble chitosan of low molecular weight (M_n = 5000) by self-emulsion polymerization method. The sizes of the latex particles, morphology, and copolymer architecture have been characterized by dynamic light scattering (DLS), general tensile test, infrared spectroscopy (IR), surface contact angle measurement, and transmission electron microscopy (TEM). Furthermore, it shows that the addition of chitosan remarkably increases anticoagulative property of PU elastomers confirmed by the recalcification time. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

奇异值分解压制随机噪声的方法及应用

针对随机噪声压制问题，通过对多项式确定的同相轴形状重新选取数据矩阵，再对新选取的数据矩阵进行SVD滤波，从而压制随机噪声。通过对矩阵奇异值分解的研究，揭示了奇异值分解的原理和SVD滤波原理，将一个多道地震记录看作一个图，它可分解为由一系列正交的子图，通过对子图适当选择并结合其它手段，从而达到提高信噪比的目的，为奇异值分解在地球物理中的进一步应用提供了理论依据。实际数据应用表明，该方法去噪手段灵活、保真性好、分辨率高，对一些突然的脉冲干扰、侧反射、以及其他的反向干扰有明显效果。     

Preparation and Characterization of Carboxymethyl Chitosan and β-Cyclodextrin Microspheres by Spray Drying

Three kinds of carboxymethyl chitosan/β-cyclodextrin microspheres loaded with theophylline were prepared by spray drying intended for pulmonary delivery. Mucociliotoxicity, permeation rate, and drug release characteristics of the product were investigated. The microspheres obtained by spray drying were found to be spherical with smooth or wrinkled surfaces. The mean particle size was between 3.39 and 6.06 µm. The microspheres demonstrated high product yield (43.7-50.2%), high drug loading (13.7-38.1%), and high encapsulation efficiency (86.9-92.8%). FT-IR indicated that there were interactions of theophylline with carboxymethyl chitosan matrix. Further studies on mucociliotoxicity and permeation confirmed that microspheres had better adaptability and high permeation rate. In vitro drug release from the microspheres was not related to the drug/polymer ratios.     

基于LabWindows/CVI的多线程测控软件设计技术

多线程技术是W in32操作系统的一项重要软件技术。CVI 6.0及其以后版本提供了线程池和异步定时器两种多线程运行机制,为测控软件的设计开发带来了一次技术飞跃。文中结合测控软件设计实例,详细介绍了在CVI平台下多线程编程技术的应用方法。