我国建筑涂料技术进步简评

从以下诸方面简述我国建筑涂料的技术进步:⑴新品种涂料的研制开发;⑵加强对配套材料及施工技术的研究;⑶超细填料在涂料中的应用;⑷计算机自动配色技术;⑸产品标准的修订;⑹建筑涂料的实用范围扩大。     

转移法色交换

将图Ｇ的着色由一种变为中一种，通常用Ｋｅｍｐｅ法以交换。但是，对于某些情况，用此法无效。针对这个问题，本文提出了一种转移法色交换，它适用于平面图着色，方法直观，清晰且有效。     

~（60）Co辐照对聚四氟乙烯表面润湿性的影响

研究了具有低表面能的氟聚合物聚四氟乙烯（ＰＴＦＥ），经６０Ｃｏγ射线辐照后表面状态的变化，以及其对液体介质蒸馏水的润湿性。较详细地论述了辐照后表面粗糙度、结晶度以及表面化学基因等不同因素对ＰＴＦＥ表面润湿性的影响。通过对ＰＴＦＥ及其表面的红外、Ｘ光衍射，表面粗糙度的分析，弄清了辐照后ＰＴＦＥ表面化学基团的改变对有机氟聚合物表加的润湿性影响很大，而粗糙度和结晶度的变化对润湿性影响较小。     

Mechanism analysis of gate-induced drain leakage in off-state n-MOSFET

An analytical expression for both band-to-band and band-trap-band indirect tunnelings is used to study the gate-induced drain leakage (GIDL) current of MOSFETs measured before and after hot-carrier stress. The voltage and temperature dependence of GIDL are characterized. Both results show that interface traps situated near the midgap participate in the conduction of GIDL, and band-trap-band indirect tunneling could be the major mechanism. This is further supported by the fact that the percentage increase in GIDL induced by hot-carrier stress is about the same as the corresponding increase in interface-trap density. On the other hand, under low-field conditions, trap-assisted Poole–Frenkle emission dominates over tunneling for temperatures even well below room temperature.     

Effects of thymectomy and glucocorticoid therapy on peripheral lymphocytes in myasthenia gravis

Clinical manifestations and peripheral blood lymphocyte subset changes were studied in patients with myasthenia gravis (MG) to elucidate the mechanism of clinical improvement following treatment, with thymectomy (Tx) or glucocorticoid (GC) therapy. The changes found were: 1. There was a significant increase in percentages of CD3+, CD29+ CD4+ cells and CD4/CD8 ratio and a significant decrease in percentages of CD8+ and CD16,56+ cells in patients who had never been treated with any immune therapy. 2. After Tx or GC therapy, CD3+ and CD4+, CD29+ cells were decreased, but the number CD19+ and CD16, CD56 cells did not change. 3. Tx had a special effect on CD8+ cells. In most of the patients who showed clinical improvement after Tx, CD8+ cells were increased and CD4/CD8 ratio wad decreased. 4. Anti-acetylcholine receptor (AChRAb) titers were markedly decreased after GC therapy. These results indicate that there were obvious abnormalities in cell-mediated immunity in addition to those in humoral immunity in myasthenia gravis. These abnormalities tended to be normalized after Tx or GC therapy.     

Error monitoring issues for common channel signaling

Motivated by field data which showed a large number of link changeovers and incidences of link oscillations between in-service and out-of-service states in common channel signalling (CCS) networks, a number of analyses of the link error monitoring procedures in the SS7 protocol were performed by the authors. This paper summarizes the results obtained thus far and include the following: (a) results of an exact analysis of the performance of the error monitoring procedures under both random and bursty errors; (b) a demonstration that there exists a range of error rates within which the error monitoring procedures of SS7 may induce frequent changeovers and changebacks; (c) an analysis of the performance of the SS7 level-2 transmission protocol to determine the tolerable error rates within which the delay requirements can be met; (d) a demonstration that the tolerable error rate depends strongly on various link and traffic characteristics, thereby implying that a single set of error monitor parameters will not work well in all situations; and (e) some recommendations on a customizable/adaptable scheme of error monitoring with a discussion on their implementability. These issues may be particularly relevant in the presence of anticipated increases in SS7 traffic due to widespread deployment of advanced intelligent network (AIN) and personal communications service (PCS) as well as for developing procedures for high-speed SS7 links currently under consideration by standards bodies     

Fabrication of optical fibre nanowires and their optical and mechanical characterisation

It is demonstrated for the first time that long nanowires with radii as small as 30 nm can be manufactured with a conventional coupler fabrication rig. The temporal deterioration of nanowire optical properties has been studied and correlated with its mechanical behaviour. The original transmission properties have been restored by a post-fabrication treatment.