乙烯基三甲基硅烷等离子体聚合反应历程

应用色谱—质谱(GC-MS)及裂解色谱-质谱(PGC-MS)测定了乙烯基三甲基硅烷等离子体聚合反应中的气体冷凝物及聚合物,研究推导了等离子体聚合反应历程。单体在气相中被电子撞击,然后扩散到基底,在基底发生链增长和链终止反应。     

On-line multiversion database concurrency control

This paper presents a new model for studying the concurrency vs. computation time tradeoffs involved in on-line multiversion database concurrency control. The basic problem that is studied in our model is the following: Given:a current database system state which includes information such as which transaction previously read a version from which other transaction; which transaction has written which versions into the database; and the ordering of versions previously written; anda set of read and write requests of requesting transactions. Question: Does there exist a new database system state in which the requesting transactions can be immediately put into execution (their read and write requests satisfied, or in the case of predeclared writeset transactions, write requests are guaranteed to be satisfied) while preserving consistency under a given set of additional constraints? (The amount of concurrency achieved is defined by the set of additional constraints). In this paper we derive “limits” of performance achievable by polynomial time concurrency control algorithms. Each limit is characterized by a minimal set of constraints that allow the on-line scheduling problem to be solved in polynomial time. If any one constraint in that minimal set is omitted, although it could increase the amount of concurrency, it would also have the dramatic negative effect of making the scheduling problem NP-complete; whereas if we do not omit any constraint in the minimal set, then the scheduling problem can be solved in polynomial time. With each of these limits, one can construct an efficient scheduling algorithm that achieves an optimal level of concurrency in polynomial computation time according to the constraints defined in the minimal set.     

单片机的显示接口电路设计

介绍了利用单片机的串、并行接口和专用显示接口 IC 设计显示接口电路的方法,并提供了4种动态和静态显示的硬件接口电路。     

The investigation of 32P wire for catheter-based endovascular irradiation

The dose distribution from a 32P source has been measured and calculated in order to evaluate its application in endovascular irradiation. The source dimension was 27 mm in length and 0.3 mm in diameter and was embedded in the end of a Ni-Ti wire. Dose measurements were performed using radiochromic film in several specially designed tissue equivalent phantoms. Loevinger's point dose kernel was used for the calculation. The approximate dose rate at a radial distance of 1.5 mm from the center of the source was found to be 6.75 cGy/s per GBq (0.25 cGy/s per mCi), which allows the delivery of a therapeutic dose in a short time interval with a satisfactory homogeneity without stepping the source. However, the dose rate falls off almost exponentially along the radial distance. Therefore it may not be suitable for treating large diameter vessel from a centrally located source. The effect of a curved 32P wire source on the radial dose distribution was also investigated. The results showed that for a maximum bend of 180 degrees the dose rate was increased by as much as 20% along the inner radial distance but decreased by as much as 20% along the outer radial distance compared to the dose along a straight wire. However, for curvatures normally encountered in a clinical situation, the dose rate was changed less than 5%.     

Influence of Lanthanum on Fluorescence Properties of Ag-BaO Thin Films

Ag-BaO thin films doped with lanthanum were prepared by vacuum deposition. Compared with the normal Ag-BaO thin film, there is almost no change with the shape and the peak site of the fluorescence spectrum; however, fluores-cence emission strength of the whole observation band(325 -600 nm)increases about 40%, and the increase of short wavelength range is more remarkable than that of long wavelength range, which we named “blue-stronger“ phenomenon. Analytic results show that, with the forming of intermetallic compounds between silver and lanthanum, the 4f-state energy levels lie just below the Fermi level within 5 eV. It is the energy exchange between the 4f energy levels and the conduction band that causes the increase effect of fluorescence emission, and it is the optical absorption cross section of 4f electron, which increases with the increase of energy of incidence photon, that gives rise to the “blue-stronger“ phenomenon.     

用数采器对空压机进行状态监测预报

通过几个典型事例的分析、判断和处理，介绍了该厂怎样利用９１ｌ型数采器对２Ｄ１２—１００／８型空压机运行状态进行监测，以预报早期故障，为设备检修提供指导．     

基于Lotus Notes软件平台创建江铜办公自动化系统

本文介绍利用LotusNotes软件平台的电子邮件、复合文档数据库、工作流和完全的Client/Server技术 ,建立一个以开放、先进的Intranet/web及消息传递和工作流管理技术为核心的新一代全方位网络办公自动化系统。     

我国建筑涂料技术进步简评

从以下诸方面简述我国建筑涂料的技术进步:⑴新品种涂料的研制开发;⑵加强对配套材料及施工技术的研究;⑶超细填料在涂料中的应用;⑷计算机自动配色技术;⑸产品标准的修订;⑹建筑涂料的实用范围扩大。     

关于非线性浅水波理论中的孤立波解

本文在[1]的基础上,详尽地得到了Boussinesq方程和KdV方程的孤立波解,并对波高和波形进行了细致的分析。为了更好地比较,本文还给出了高阶摄动的孤立波解。     

Turbo Pascal在网络数据库图形处理中的应用

本文介绍用Turbo Pascal 5.0在3~+网上运行的DBASEⅢplus网络数据库中进行图形处理的技术.