一种基于复数域网络编码的双层卫星通信系统

针对卫星通信网络吞吐量不足、可靠性不高的问题,提出一种基于复数域网络编码(Complex Field Network Coding,CFNC)的卫星通信方案。该方案在信号发送前对源信息作预编码处理,即在复数域上选取一个大小合适的参数化空时码与源信号相乘,编码后的信号与源信号在复数域上有着一一映射关系。对该方案的吞吐量和成对差错概率(Pairwise Error Probability,PEP)做了详尽的理论分析,结果表明,采用该编码方案的卫星通信系统在终端发射功率不变的情况下,吞吐量比路由模式提高了100%以上,比传统的CFNC方式至少可提高75%。该方案还可以扩展至更多的地面源节点,从而支持多用户网络通信。最后,仿真实验表明,在较高的信噪比下,PEP仿真值逼近于渐近值,验证了理论分析的正确性。     

Power system transient stability analysis: Formulation as nearly Hamiltonian systems

In this paper we formulate power systems as nonlinear nearly Hamiltonian systems. Using the invariance principle for ordinary differential equations, necessary and sufficient conditions for asymptotic stability are established and a new method of estimating the domain of attraction of the stable equilibrium point is developed. The present results constitute a novel approach to stability analysis and involve the following three steps:

1. Given a system with dissipation, the stability of its equilibrium is ascertained by determining the stability of the associated conservative system.
2. Attractivity of the stable equilibrium of the entire system (with dissipation) is determined from the system topology.
3. An estimate of the domain of attraction of the asymptotically stable equilibrium is obtained by making use of results obtained in (a) and (b).

The stability criterion developed in this paper sheds new light on the mechanism of instability in power systems and it provides analytical verification to the concept of the potential-energy boundary surface (PEBS). The PEBS is a hypersurface which makes up a part of the boundary of the domain of attraction of the stable equilibrium in a power system. The existence and properties of the PEBS have thus far been deduced primarily via simulations and heuristic methods.     

Optical parameter studies of thermally evaporated As-Se-Sn glassy system

The optical properties of As₃₀Se_70-xSn_x with (x = 0, 1, 2 and 3 at Sn %) thin films have been investigated. The films used in these studies were thermally evaporated. The structural characterization revealed that the as-deposited films were amorphous in nature. The spectral and optical parameters have been investigated using spectrophotometric measurements of transmittance in the wavelength range (200–1100 nm). The optical constants were determined from the interference maxima and minima using the Swanepole method. The dispersion of the refractive index is discussed in terms of the single-oscillator Wemple-Didomenico model. The optical-absorption edge and the optical band gap are calculated from the absorption coefficient values using the non direct transition model proposed by Tauc’s extrapolation procedure. The relation between the optical gap and chemical composition in As-Se-Sn glassy system is discussed in terms of the average heat of atomization H_s and the average coordination number N_c.     

Sludge Production and Settleability in Biofilm-Activated Sludge Process

The sludge production and settleability have been estimated experimentally in a completely mixed biofilm-activated sludge reactor (hybrid reactor). A steady-state hybrid reactor was run at different stages of suspended biomass concentration (X) under constant values of influent substrate concentration (So) and hydraulic retention time (HRT). The values of X were gradually decreased in these stages until the system completely washed out of the suspended biomass and converted to pure biofilm reactor. As a result, the role of biofilm in the treatment gradually increased with an increase in the effluent substrate concentration (S). The experiment was supported by a mathematical expression for describing the sludge yield in the system under the previous conditions. The experimental and theoretical studies in the present work reveal that there is a critical phase of the hybrid system at which the system produces a high rate of excess sludge. That critical phase is found at a specific ratio between the suspended and the attached growth. Avoiding that critical phase enables the sludge production in the hybrid reactor to be reduced and optimized. Further, the minimum sludge production was found when the biofilm is theoretically inactive for chemical oxygen demand (COD) removal (S相似文献   

Hierarchical Reliable Multicast: Performance Analysis and Optimal Placement of Proxies

This paper studies the use of multicast together with proxy nodes for reliably disseminating data from a single source to a large number of receivers. In order to achieve reliability, data must be retransmitted in case of loss either by the source or by special network nodes, called proxies. Each proxy is responsible for reliably delivering the data to a subgroup it is assigned. The multicast tree is partitioned into subgroups that form a hierarchy rooted at the source, hence the term hierarchical reliable multicast. The performance of this approach strongly depends on the topology and the loss characteristics of the underlying tree and the location of proxies. In the first part of the paper, we study the processing and bandwidth performance of such a reliable multicast dissemination given the tree and the placement of proxies. In the second part of the paper, we develop dynamic programming algorithms that give a placement of a fixed number of proxies on an arbitrary tree that minimizes the bandwidth used for reliable transfer. The first algorithm provides an optimal solution to the multicast proxies location problem in polynomial time, in the number of nodes and proxies. The second is an approximation algorithm that gives a solution with cost within a chosen precision from the optimal, in an improved running time. An optimal and an approximate solution are also provided for the proxies location problem if unicast is used for transmissions. Applications of this dynamic programming approach to related problems are discussed.     

A Multi-objective Optimization for Sizing and Placement of Voltage-controlled Distributed Generation Using Supervised Big Bang–Big Crunch Method

Abstract—This article presents an efficient multi-objective optimization approach based on the supervised big bang–big crunch method for optimal planning of dispatchable distributed generator. The proposed approach aims to enhance the system performance indices by optimal sizing and placement of distributed generators connected to balanced/unbalanced distribution networks. The distributed generation units in the proposed algorithms are modeled as a voltage-controlled node with the flexibility to be converted to a constant power node in the case of reactive power limit violation. The proposed algorithm is implemented in the MATLAB (The MathWorks, Natick, Massachusetts, USA) environment, and the simulation studies are performed on IEEE 69-bus and IEEE 123-node distribution test systems. Validation of the proposed method is done by comparing the results with published results obtained from other competing methods, and the consequent discussions prove the effectiveness of the proposed approach.     

The role of advertisements in the marketing of gated communities as a new Western suburban lifestyle: a case study of the Greater Cairo Region, Egypt

This paper examines the advertising themes and rhetoric that have been assembled in the marketing of the Greater Cairo Region’s (GCR) newly built gated communities. We demonstrate how place-marketing strategies, in this case, selling the Egyptian dream home, draws upon specific landscape offerings and values. It shows how aspects of globalization interact with processes of urbanization in the GCR to create new landscapes of housing consumption. The globalization of mass media has influenced consumption preferences and brought new consumption choices to the GCR’s residents. This study concludes that the demand for gated communities in the GCR, in large part, has been created by developers who foster an image of these areas as symbols of ‘modernism’ and Western lifestyles. Underlying these sales efforts is the common assumption held by developers, potential buyers and segments of the larger society that the lifestyles of Western urbanization should naturally emerge as the result of economic development.     

Application of nanostructured titanium dioxide pigments in paper coating: a comparison between prepared and commercially available ones

Nano-TiO₂ pigments in pure crystallographic anatase and rutile phases have been successfully prepared by hydrothermal at 120°C and hydrolysis methods, respectively. The laboratory-prepared pigments were characterized parallel to two commercial pigments of the same crystal structure. All pigments were applied in paper coating mixtures, and their influence on coated paper properties was systematically investigated. X-ray diffraction investigation showed that the laboratory-prepared pigments using the hydrothermal method at 120°C were pure anatase, whereas hydrolysis method produced pure rutile phase pigment. The application of the prepared nanopigments and the corresponding commercial TiO₂ phases in paper coating revealed that clay/rutile nano-TiO₂ pigments in paper coating mixture decreased coated paper roughness more than blending clay with anatase nano-TiO₂ pigments. Commercial nano-TiO₂ pigments increased porosity of coated paper at both the 30% and 50% addition of nano-TiO₂ pigments to clay, while laboratory-prepared nano-TiO₂ pigments highly decreased it at 30% addition of nano-TiO₂ to clay, compared to clay only. Blending of clay/nano-TiO₂ pigments improved both brightness and opacity of the coated paper where commercial pigments are more effective. Burst, tensile strength, stretching, and TEA were improved in the case of all pigments. The 50% addition of the prepared and commercial nanopigments in conjunction with clay improved the mechanical coated paper properties more than 30% addition (except the cases of stretching and TEA of the commercial pigments). The coated paper samples were offset printed. It was found that blending of clay/nano-TiO₂ pigments improved print density. Commercial nano-TiO₂ pigments improved print gloss more than the laboratory-prepared ones. This result was found consistent with the results of coated paper roughness.     

Quartz Ore Beneficiation by Reverse Flotation for Silicon Production

Silicon - In this work the reverse flotation as beneficiation process for high-purity silica valorization from Draissa quartz deposits (Algeria) is studied as a potential raw material for...     

Characterization of rheological and thermophysical properties of HDPE–wood composite

The objective of this study is to develop a new biocomposite material with high deformation ability. In this regard, the thermal, rheological, and thermophysical properties of this new composite were characterized as a function of temperature and filler concentration. High density polyethylene (HDPE) was the matrix of this new composite which was reinforced with six sawdust concentrations 0%, 20%, 30%, 40%, 50%, and 60%. Maleic anhydride grafted polyethylene (PE‐g‐MA) was used as coupling agent. Addition of sawdust with PE‐g‐MA increased significantly the complex viscosity, the storage modulus (G′), and loss modulus (G″) of the matrix. The superposition of the complex viscosity curves using temperature dependent shift factor, allowed the construction of a viscosity master curve covering a wide range of temperatures. Arrhenius law was used for the relationship of the shift factor to temperature. Furthermore, method of Van Gurp and Palmen (tan delta vs. G*) is also used to control the time–temperature superposition. The experimental results can be well fitted with the cross rheological model which allowed the prediction of the thermorheological properties of the composites over a broad frequency range. By increasing wood concentration, both the activation energy and relaxation time for the biocomposites determined using, respectively, the Arrhenius law and the cole–cole rule increased. By contrast, specific heat of the matrix decreased with sawdust addition while its dimensional stability improved. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2014 , 131, 40495.