Preparation of Co-N films by rf-sputtering

Co-N films in the wide compositional range can be prepared by reactive sputtering. Co-N sputtered films consist of one or two phases, such as CoN, Co₂N, Co₃N, Co₄N and -Co. Co₄N phase with a cubic unit cell is observed, and its lattice constant isa = 0.3586 nm. The preferred orientation is observed on the Co-N films, CoN (200) plane, Co₄N (1 1 1) plane and -Co (002) plane parallel to the film surface, respectively. Saturation magnetization _s of Co-N sputtered film decreases from 160 to 1.7 e.m.u. g^–1 with increasing content of N from 0 to 21.7 at%, and coercive force_I H _c is the range of 43 to 5000e at room temperature.     

Taxonomy for protective ability of rust layer using its composition formed on weathering steel bridge

For a quantitative evaluation of the protectiveness of a rust layer formed on a weathering steel bridge, the relationship between the corrosion rate of the bridge and the composition of the rust layers formed on the girders was first investigated. These corrosion rates were clearly classified by the protective ability index (PAI) of α/γ^∗ and (β + s)/γ^∗, where α, γ^∗, β and s are the mass ratio of crystalline α-FeOOH, the total of γ-FeOOH, β-FeOOH and the spinel-type iron oxide (mainly Fe₃O₄), β-FeOOH and spinel-type iron oxide, analyzed by XRD, respectively. The inequality of the former index α/γ^∗ > 1 expressed the protectiveness criterion of the rust layer, while that of the latter index, (β + s)/γ^∗< 0.5 or > 0.5, classified the corrosion rate of the non-protective rust layer. The PAI is useful for a quantitative evaluation of the protectiveness of a rust layer formed on a weathering steel bridge and is an important item for the corrosion assessment of the bridge.     

Application of the solid polymer electrolyte (SPE) method to organic electrochemistry—III. Kolbe type reactions on Pt-SPE

The feasibility of a solid polymer electrolyte (SPE) method for Kolbe type reactions was investigated by using Pt-SPE composed with Nafion 415 and platinum. The Kolbe reaction of acetic acid proceeded effectively on one side and both sides Pt-SPE composites. The lower current efficiency was observed on the latter than on the former. Neat acetic acid could also be electrolysed on both sides SPE though the cell voltage was fairly high.A methanolic solution of monomethyl adipate was electrolysed to give dimethyl sebacate on both sides Pt-SPE according to the Brown-Walker reaction. The current efficiency and the terminal voltage increased with the concentration of monomethyl adipate. Pt-SPE behaved as an active electrode of a high roughness factor, eg about 6, for the Kolbe reaction of acetate.     

Junction properties of polypyrrole containing a small amount of poly(ethylene oxide) with indium

A method to generate a porous region near the surface of a polymer is suggested. In this method the region near the surface is swollen by immersing the polymer for a short time in a solvent. Subsequently, the polymer is introduced in a nonsolvent (for the polymer) that is, however, miscible with the solvent. The formation of the porous region is a result of (1) the swelling accompanied by the disentanglement of the surface molecular chains, and the dissolution of some of them during the immersion in the solvent, and (2) the rapid extraction of the solvent from the swollen region by the nonsolvent. The porous surface provides a matrix into which a second incompatible monomer can be polymerized so that the two otherwise incompatible polymers can adhere to one another.     

Effects of bile acid feeding on hepatic deoxycholate 7α-hydroxylase activity in the hamster

In order to investigate the effects of bile acid feeding on hepatic microsomal deoxycholate 7α-hydroxylase activity, three different bile acids were administered (0.2% w/w in chow) to hamsters for two weeks. Deoxycholate 7α-hydroxylase activity was increased markedly by feeding of cholic acid (CA) and slightly by deoxycholic acid (DCA) Chenodeoxycholic acid (CDCA) had little effect on the enzyme activity. Feeding each of the bile acids significantly inhibited the activity of cholesterol 7α-hydroxylase in the order CDCA≥ DCA>CA. There was no correlation between deoxycholate 7α-hydroxylase activity and cholesterol 7α-hydroxylase activity. It is concluded that the activity of deoxycholate 7α-hydroxylase is up-regulated by feeding DCA and CA and that the mechanism seems to be different from that of cholesterol 7α-hydroxylase. The increased activity of hepatic deoxycholate 7α-hydroxylase by CA and DCA should be beneficial in minimizing the toxic effects of DCA in the hamster.     

Development of reel-to-reel microchip mounting system for fabrication of meter-long LED lighting tapes

We have developed a reel-to-reel microchip mounting system that continuously mounts LED chips and other microchips on meter-long flexible printed circuit board (PCB) tape for 1.2-m-long standard LED light tubes. Mounting microchips on meter-long PCBs is difficult because a large chip mounter is expensive and the chip positioning stage is difficult to move in a meter-wide area with an accuracy of hundreds of micrometers. Hence, we developed a new microchip mounting system that utilizes a small chip mounter and reel winding machines. The system repeatedly moves the long PCB tape by a certain length with the reel winding machines and mounts the chips on it. The PCB tape (which is 5 mm wide) is made by fabricating long PCB tapes which are 25 cm × 26.6 m through a roll-to-roll PCB process and slitting them into meter-long tapes. The reel-to-reel system repeatedly mounts chips by adjusting their positions through image processing of the copper wiring pattern on the PCBs. Our constructed system mounted 24 LED chips with a pitch of 5 cm with an accuracy of 0.082 mm to form a 1.2-m-long LED tape. The luminance of the tape is 12.4 lx at a distance of 1 m, which is the luminance of outdoor corridor lighting. Therefore, this system can be used for meter-long tape lighting.     

Chemospecific ring-opening polymerization of α-methylenemacrolides

α-Methylenemacrolides having various groups, such as aromatic, ether, and amine, were enzymatically, anionically, and radically polymerized. The polymerization with the lipase catalyst successfully afforded polymers only through the ring-opening process, whereas the vinyl polymerizations selectively proceeded by using anionic and radical initiators. The polyesters obtained by the enzymatic polymerization have a polymerizable methacrylic methylene group in the main-chain, in addition to the aromatic and polar groups, and were further radically polymerized to quantitatively produce a cross-linked polymer gel.     

Alteration of substrate specificity of cholesterol oxidase from Streptomyces sp. by site-directed mutagenesis

Despite the structural similarities between cholesterol oxidasefrom Streptomyces and that from Brevibacterium, both enzymesexhibit different characteristics, such as catalytic activity,optimum pH and temperature. In attempts to define the molecularbasis of differences in catalytic activity or stability, substitutionsat six amino acid residues were introduced into cholesteroloxidase using site-directed mutagenesis of its gene. The aminoacid substitutions chosen were based on structural comparisonsof cholesterol oxidases from Streptomyces and Brevibacterium.Seven mutant enzymes were constructed with the following aminoacid substitutions: L117P, L119A, L119F, V145Q, Q286R, P357Nand S379T. All the mutant enzymes exhibited activity with theexception of that with the L117P mutation. The resulting V145Qmutant enzyme has low activities for all substrates examinedand the S379T mutant enzyme showed markedly altered substratespecificity compared with the wild-type enzyme. To evaluatethe role of V145 and S379 residues in the reaction, mutantswith two additional substitutions in V145 and four in S379 wereconstructed. The mutant enzymes created by the replacement ofV145 by Asp and Glu had much lower catalytic efficiency forcholesterol and pregnenolone as substrates than the wild-typeenzyme. From previous studies and this study, the V145 residueseems to be important for the stability and substrate bindingof the cholesterol oxidase. In contrast, the catalytic efficiencies(k_cat/K_m) of the S379T mutant enzyme for cholesterol and pregnenolonewere 1.8- and 6.0-fold higher, respectively, than those of thewild-type enzyme. The enhanced catalytic efficiency of the S379Tmutant enzyme for pregnenolone was due to a slightly high k_catvalue and a low K_m value. These findings will provide severalideas for the design of more powerful enzymes that can be appliedto clinical determination of serum cholesterol levels and assterol probes.     

Charged ultrafiltration membrane for permeation of proteins

Polyacrylonitrile-g-poly(N,N-dimethylaminoethyl methacrylate) was synthesized photochemically and quaternized. The positively charged membranes made from the quaternized graftcopolymer showed high ultrafiltration rate for water by adding poly(vinyl alcohol) to casting solution and washing it out after the casting. In buffered saline solution, the permeability of the membranes was very small at pH below isoelectric point of albumin but increased markedly at higher pH. On the other hand, the permeability for γ-globulin was very small and did not show any pH dependence.