Wave propagation by the passage of two high-speed trains in a tunnel

A numerical simulation of unsteady compressible flow induced by two high-speed trains in oncoming traffic within a tunnel is presented. The computations were carried out by means of a second-order accurate Harten-Yee type upwind TVD scheme. In order to take the effect of friction into account, a source term is included in the governing flow equations. In the computation, moving boundary configurations were used to simulate the two trains passing through the tunnel. As geometrical configuration, the Einmalberg tunnel, where experimental data are available, was selected. The computational results agree reasonably well with their experimental counter-part. The waves interaction and the waves propagation process at the tunnel entrance and exit as well as within the tunnel are addressed. Finally, the influence on the transmitted waves at the tunnel exit portal and the variation of the negative pressure drop during the passage of the two trains are discussed.     

液相添加剂对PTCR陶瓷电性能的影响

液相添加剂ＡＳＴ（Ａｌ２Ｏ３＋ＳｉＯ２＋ＴｉＯ２）对ＢａＴｉＯ３陶瓷材料电性能的影响很大，随着Ａｌ２Ｏ３含量的增加，材料的电性能降低；ＳｉＯ２、ＴｉＯ２的物理特性对材料电性能影响较大；过量ＴｉＯ２对材料ＰＴＣ效应有重要影响，适当过量ＴｉＯ２含量，可得到性能优良的ＰＴＣＲ陶瓷。     

制革用水乳型聚氨酯涂饰剂行业标准的制定

本文概述了制定该标准的背景，对标准的主要内容加以科学的阐述。     

石材成型爆破开采方法简介

本文介绍了一些国内原有的及近年来发展的用于石材开采的成型爆破方法,简单扼要地阐明了这些方法的原理、装药结构及主要特点,对全面认识及合理选择这些方法有一定帮助。     

Multiple respiratory gas monitoring causes changes of inspired oxygen concentration in closed anesthesia system

This case report describes an accessory hepatic duct (AHD) identified by intraoperative cholangiography during excisional surgery of a choledochal cyst (CC). The accessory duct was divided and reconstructed successfully to the Roux-en-Y jejunal loop. The postoperative course was uneventful, and follow-up abdominal sonography revealed neither evidence of biliary tract obstruction nor atrophic changes of the liver. It is advocated that an AHD should be meticulously reconstructed if it is divided during excisional surgery of a CC.     

机械合金化Fe50Ti50非晶的形成及球磨强度对它的影响

本文通过电子扫描和Ｘ衍射对机械合金人Ｆｅ５０Ｔｉ５０非晶粉末形成做了研究。研究发现：机械合金非晶形成可以大致地分为二个阶段－粉末的破碎阶段和非晶的形成阶段。另外，对球磨强度对非晶形成的影响进行了研究。结果表明：强度低时粉末需要较长的时间才能形成非晶，强度高时粉末形成非晶的时间大大缩短，但在随后的球磨中，粉末会重新晶化形成新相。     

杭-宁输气管道工程定向钻穿越设计浅析

杭州-宁波天然气输气管道工程（简称杭-宁输气管道工程）是浙江省天然气长输管网主干线之一，根据工程河流穿越众多、渠塘穿越频繁的特点，对杭-宁输气管道工程水域穿越的特点和穿越方式作了总结；重点分析了水域定向钻穿越设计及需要注意的问题，为今后浙江省天然气管网建设的水域穿越设计作了探讨。     

基于本地缓存的弹性分组环保护机制

本文提出一种基于本地缓存的弹性分组环保护倒换机制(WrapProtectionBasedOnLocalBuffers,简称WP-LB)。其主要思想是当环路上任何位于源节点和故障区域之间的中间节点接收到含有故障信息的控制信令后,就不再向下游转发数据分组,而是在本地缓存这些数据。等到保护通路建立好之后,再把缓存的数据分组经过保护通路发送给目的节点。分析计算表明,与原有的保护倒换(WrapProtection,简称WP)机制相比,WP-LB机制不仅提高带宽利用率,减少平均时延,并且还能避免数据包的丢失和失序。     

聚合反应器制造质量控制要点探讨

聚合反应器是无法检修设备,不允许打开,所以聚合反应器的制造质量必须严格控制,在设备制造过程中,严格按照设计图纸、技术要求及国家现行标准,进行控制设备制造、检验和验收,使制造质量达到规定要求。