Thermo-economic optimization of hot water piping systems: A comparison study

Four different thermo-economic techniques for optimum design of hot water piping systems are presented. They are as follows: the first one is a sequential optimization of pipe diameter based on minimization of total cost without considering heat losses and then of insulation thickness based on minimization of cost of insulation and heat losses. The second is simultaneous optimization of pipe diameter and insulation thickness based on the first law of thermodynamics and cost. The third is simultaneous determination of pipe diameter and insulation thickness based on maximization of exergy efficiency without considering cost. Finally, the fourth is simultaneous determination of pipe diameter and insulation thickness based on maximization of exergy efficiency and cost minimization. A case study is carried out for a hot water pipe segment, and the differences and merits of each method are discussed.     

Energy policies of Turkey during the period 1923–2003

Turkey has been developing since the foundation of the Republic of Turkey in 1923. Turkish Government played a leading role in energy production and in energy use, as well as in other fields, and implemented several policies to increase electricity production. By 1950s, thermal power plants were used commonly in electricity production. In the following years, hydroelectric power plants were put into operation in order to use the considerable amount of water resources of the country. Coal-fired power plants using national resources accounted for 70–80% of the thermal electricity production. After 1960s, oil, an imported resource, was replaced with national resources due to two petroleum crises. Therefore, the proportion of use of lignite in the energy field increased. By 1980s, energy production lead by the government went on. Afterwards, applications of liberal economy policies resulted in implementation of different energy production methods, and the country had a increasing tendency to meet energy demand by imports as a result of improvement in international economic relations. Natural gas became prevalent in the country as well as all over the world and accounted for 45% of the electricity production in 2003. In this paper, implemented policies in the energy field during different periods since the foundation of the Republic of Turkey in 1923 was investigated.     

Radiation protection for accompanying person and radiation workers in PET/CT

The purposes of the present study are to measure the total radiation doses for the radiation workers and for the accompanying person to the patients in positron emission tomography (PET)/computed tomography (CT) imaging. Urines samples from the patients were collected at 43, 62, 87, 117, 238, 362 min after the 555-MBq (18)flour-fluorodeoxyglucose ((18)F-FDG) injection and activities were measured. Dose rates were recorded using a Geiger-Muller counter and the total radiation doses were measured with using an electronic personnel dosemeter. According to the results here, 18.4 % of (18)F-FDG was excreted in the urine in 117 min after injection. At 117th min after injection, dose rates were determined as 345, 220, 140, 50 and 15 μSv h(-1), at proposed distances. The radiation doses after 117 min were measured as 3.92 mSv at 0.1 m, 2.11 mSv at 0.25 m and 1.08 mSv at 0.5 m. In conclusion, radiation protection will be sufficient within 2 h after (18)F-FDG injection for PET/CT imaging in daily practice.     

On the mechanism of current-transport in Cu/CdS/SnO2/In-Ga structures

The structural and optical properties of CdS films deposited by evaporation were investigated. X-ray diffraction study showed that CdS films were polycrystalline in nature with zinc-blende structure and a strong (1 1 1) texture. The study has been made on the behavior of Cu/n-CdS thin film junction on SnO₂ coated glass substrate grown using thermal evaporation method. The forward bias current-voltage (I-V) characteristics of Cu/CdS/SnO₂/In-Ga structures have been investigated in the temperature range of 130-325 K. The semi-logarithmic lnI-V characteristics based on the Thermionic emission (TE) mechanism showed a decrease in the ideality factor (n) and an increase in the zero-bias barrier height (Φ_Bo) with the increasing temperature. The values of n and Φ_Bo change from 8.98 and 0.29 eV (at 130 K) to 3.42 and 0.72 eV (at 325 K), respectively. The conventional Richardson plot of the ln(I_o/T²) vs q/kT shows nonlinear behavior. The forward bias current I is found to be proportional to I_o(T)exp(AV), where A is the slope of ln(I)-V plot and almost independent of the applied bias voltage and temperature, and I_o(T) is relatively a weak function of temperature. These results indicate that the mechanism of charge transport in the SnO₂/CdS/Cu structure in the whole temperature range is performed by tunneling among interface states/traps or dislocations intersecting the space-charge region. In addition, voltage dependent values of resistance (R_i) were obtained from forward and reverse bias I-V characteristics by using Ohm's law for each temperature level.     

The illumination intensity and applied bias voltage on dielectric properties of au/polyvinyl alcohol (Co,Zn‐doped)/n‐Si Schottky barrier diodes

The Au/polyvinyl alcohol (PVA) (Co, Zn‐doped)/n‐Si Schottky barrier diodes (SBDs) were exposed to various illumination intensities. Illumination effect on the dielectric properties has been investigated by using capacitance–voltage (C–V) and conductance–voltage (G/ω–V) characteristics at 1 MHz and room temperature. The values of dielectric constant (ε′), dielectric loss (ε″), loss tangent (tanδ), electric modulus (M′ and M″), and AC electrical conductivity (σ_AC) were found strongly intensity dependent on both the illumination levels and applied bias voltage especially in depletion and accumulation regions. Such bias and illumination dependency of these parameters can be explained on the basis of Maxwell–Wagner interfacial polarization and restructuring and reordering of charges at interface states. In addition, the ε′–V plots also show an intersection feature at ～ 2.8 V and such behavior of the ε′–V plots appears as an abnormality compared with the conventional behavior of an ideal SBD. The obtained results revealed that illumination intensity enhances the conductivity of Au/PVA(Co, Zn‐doped)/n‐Si SBD. © 2010 Wiley Periodicals, Inc. J Appl Polym Sci, 2011     

A detailed comparative study on the main electrical parameters of Au/n-Si and Au/PVA:Zn/n-Si Schottky barrier diodes

We have fabricated Au/n-Si and Au/PVA:Zn/n-Si Schottky barrier diodes (SBDs) to investigate the effect of organic interfacial layer on the main electrical characteristics. Zn doped poly(vinyl alcohol) (PVA:Zn) was successfully deposited on n-Si substrate by using the electrospinning system and surface morphology of PVA:Zn was presented by SEM images. The current–voltage (I–V) characteristics of these SBDs have been investigated at room temperature. The experimental results show that interfacial layer enhances the device performance in terms of ideality factor (n), zero-bias barrier height (Φ_B0), series resistance (R_s), and shunt resistance (R_sh) with values of 1.38, 0.75 eV, 97.64 Ω, and 203 MΩ whereas those of Au/n-Si SBD are found as 1.65, 0.62 eV, 164.15 Ω and 0.597 MΩ, respectively. Also, this interfacial layer at metal/semiconductor (M/S) interface leads to a decrease in the magnitude of leakage current and density of interface states (N_ss). The values of N_ss range from 1.36×10¹² at E_c—0.569 eV to 1.35×10¹³ eV^?1 cm^?2 at E_c—0.387 eV for Au/PVA:Zn/n-Si SBD and 3.34×10¹² at E_c—0.560 eV to 1.35×10¹³ eV^?1 cm^?2 at E_c—0.424 eV for Au/n-Si SBD. The analysis of experimental results reveals that the existence of PVA:Zn interfacial layer improves the performance of such devices.     

Petroleum Source Rock Assessments of the Upper Permian Strata in the Central Taurus Region of Turkey

This study presents the hydrocarbon source rock potential and organic maturity of the Upper Permian Tozara Formation in the Gazipa?a-Sugözü area in the central Taurus region. The Tozara Formation deposited oxic to dysoxic shelf conditions consists of algal limestone and organic matter-rich shales. In order to assess the hydrocarbon source rock potential of the Upper Permian lithologies, two different stratigraphic sections described and sampled for organic geochemical analyses and determination of mineralogical composition.     

Exact elasticity solutions to rotating pressurized axisymmetric vessels made of functionally graded materials (FGM)

In this study the plane elasticity equations of pressurized and rotating structures, generalized analytical closed-form solutions are presented for hollow cylinders, spheres and thin disks. Three well known material pairs are graded in radial direction by using the power rule for various boundary and load conditions. Stress and displacement solutions are obtained. The effect of a constant rotational velocity is also investigated separately in absence of the internal and external pressures. Crucial results are also presented in tabular form.