Conversion of carbon into CF4 for SI-traceable measurements of absolute carbon isotope amount ratios: a feasibility study

The feasibility of performing SI-traceable carbon isotope amount ratio measurements following conversion of carbon into CF4 was studied. A procedure for the direct fluorination of carbon with elemental fluorine was developed, and the conversion step was checked for losses, blank contributions, and the absence of systematic isotope effects. Gas chromatography was used to identify and quantify the gaseous fluorination products and to isolate CF4 from byproducts. After fluorination of graphite carbon, CF4 and perfluoroalkanes with up to six carbon atoms were observed as reaction products. Within an uncertainty of 10%, the graphite carbon was fully recovered in the gaseous carbon fluorides, with the main product being CF4 (80-90%) and C2F6 as the major byproduct. The fluorination and GC procedures were found to introduce an alteration not bigger than 0.03 +/- 0.04/1000 on the isotopic composition of CF4. Carbon blank contributions introduced during the fluorination procedure were below 0.5% relative to a typical sample of 4 mg of carbon. For two of the materials investigated, the carbon isotope ratios measured on a differential mass spectrometer were reproducible within a standard deviation of approximately 0.1/1000 for several individual fluorinations. For these materials, the developed fluorination procedure is a straightforward process, which can be used as a foundation to establish SI-traceable measurements of carbon isotope amount ratios. However, for the third graphite material the formation of byproducts (C2F6-C6F14) was found to induce significant isotopic fractionation.     

Oxygen isotopic measurements by secondary ion mass spectrometry in uranium oxide microparticles: a nuclear forensic diagnostic

To exploit oxygen isotopic measurement by SIMS as a diagnostic tool in nuclear forensics, the magnitude and reproducibility of 0-isotope instrumental mass discrimination for O-isotope standards in the SIMS laboratory at the Institute for Transuranium Elements has been evaluated. Tests for matrix-dependent discrimination effects on three different O-isotope standards with substantially different matrix compositions have been performed. The results were checked by an interlaboratory comparison of O-isotope discrimination with those obtained in the SIMS laboratory at the Lawrence Livermore National Laboratory on two standards. The results from the two laboratories are in very good agreement, indicating statistically indistinguishable instrumental mass discrimination factors for 180/160 ratios on the Cameca 6f and 3f, when the analyses are performed under the experimental conditions described. The 2sigma(mean) uncertainties of these factors are in the range of 0.3-0.9%. In accordance with the tested methodology, 0-isotope compositions were measured in three particulate uranium oxide samples of nuclear forensics interest.     

Ground-based full-sky imaging polarimetry of rapidly changing skies and its use for polarimetric cloud detection

For elimination of the shortcomings of imaging polarimeters that take the necessary three pictures sequentially through linear-polarization filters, a three-lens, three-camera, full-sky imaging polarimeter was designed that takes the required pictures simultaneously. With this polarimeter, celestial polarization patterns can be measured even if rapid temporal changes occur in the sky: under cloudy sky conditions, or immediately after sunrise or prior to sunset. One of the possible applications of our polarimeter is the ground-based detection of clouds. With use of the additional information of the degree and the angle of polarization patterns of cloudy skies measured in the red (650 nm), green (550 nm), and blue (450 nm) spectral ranges, improved algorithms of radiometric cloud detection can be offered. We present a combined radiometric and polarimetric algorithm that performs the detection of clouds more efficiently and reliably as compared with an exclusively radiometric cloud-detection algorithm. The advantages and the limits of three-lens, three-camera, full-sky imaging polarimeters as well as the possibilities of improving our polarimetric cloud detection method are discussed briefly.     

Advances in space technology: the NSBRI Technology Development Team

As evidenced from Mir and other long-duration space missions, the space environment can cause significant alterations in the human physiology that could prove dangerous for astronauts. The NASA programme to develop countermeasures for these deleterious human health effects is being carried out by the National Space Biomedical Research Institute (NSBRI). The NSBRI has 12 research teams, ten of which are primarily physiology based, one addresses on-board medical care, and the twelfth focuses on technology development in support of the other research teams. This Technology Development (TD) Team initially supported four instrumentation developments: (1) an advanced, multiple projection, dual energy X ray absorptiometry (AMPDXA) scanning system: (2) a portable neutron spectrometer; (3) a miniature time-of-flight mass spectrometer: and (4) a cardiovascular identification system. Technical highlights of the original projects are presented along with an introduction to the five new TD Team projects being funded by the NSBRI.     

Self-organization in the basal ganglia with modulation of reinforcement signals

Self-organization is one of fundamental brain computations for forming efficient representations of information. Experimental support for this idea has been largely limited to the developmental and reorganizational formation of neural circuits in the sensory cortices. We now propose that self-organization may also play an important role in short-term synaptic changes in reward-driven voluntary behaviors. It has recently been shown that many neurons in the basal ganglia change their sensory responses flexibly in relation to rewards. Our computational model proposes that the rapid changes in striatal projection neurons depend on the subtle balance between the Hebb-type mechanisms of excitation and inhibition, which are modulated by reinforcement signals. Simulations based on the model are shown to produce various types of neural activity similar to those found in experiments.     

高温栅偏压和高温反偏压应力对PT-IGBT性能的影响

本文阐述了在高温栅偏压（HTGB）和高温反偏压（HTRB）应力条件下对穿通型（PT）IGBT性能的影响。在140℃、经历1200小时完成应力试验。获得了在上述两种不同应力下，有关开关型工作参数和测量结果的定量变化。由于IGBT的老化，定性分析了开关时间漂移对PWM逆变器运作的影响。     

Performances of OsO(4) stabilized CO(2) lasers as optical frequency standards near 29 THz

In this paper, we report on the metrological capabilities of CO (2)/OsO(4) optical frequency standards operating around 29 THz. Those frequency standards are currently involved in various fields, such as frequency metrology, high resolution spectroscopy, and Rydberg constant measurements. The most impressive features of the standards lies in the 10(-15) level frequency stability allied to a long-term reproducibility (1 yr) of 1.3x10 (-13).     

Thermal emission from dielectric beam splitters in michelson interferometers: a schematic analysis

Thermal emission from beam splitters in Fourier transform infrared spectrometers causes spectral amplitudes that are in quadrature to those of radiation from the field of view or from the detector port. Beam-splitter emission is described as a superposition of radiation of electromagnetic dipoles with angular polarization correlation taken into account for the real refractive index. Surface emission shows characteristic differences compared with volume emission. Numerical data are given for experimental conditions adapted to those of the airborne limb sounder MIPAS-FT.     

Purification and characterization of sea squirt alpha-N-acetylgalactosaminidase

Sea squirt alpha-N-acetylgalactosaminidase was purified to homogeneity. Its molecular weight was estimated to be approximately 160,000 by gel filtration and 40,000 by SDS-polyacrylamide gel electrophoresis (SDS-PAGE) under reducing condition. The chromatographic and electrophoretic behaviors indicated that the enzyme was composed of four subunits. The optimum pH of the enzyme reaction was about 4.0 at 37 degrees C, while the enzyme was stable in the range of pH 5.0 to 6.0 during 4 h preincubation at 37 degrees C. Although the enzyme (0.1 unit) was stable at 0 degrees C for 30 min in the presence of 7.5 mM metal ions (Al3+, Ba2+, Ca2+, K+, Mn2+, Pb2+, Sr2+, and Zn2+), almost 40% of the enzyme activity was lost in the presence of Cu2+, Hg2+, monoiodoacetic acid, and EDTA. The enzyme hydrolyzed aryl N-acetyl-alpha-D-galactosaminide as well as GalNAcalpha1(-->4GalNAcalpha1-->)n 4GalNAc-p-aminobenzoic acid ethyl ester (ABEE) (n = 1-4), but GalNAcalpha1-->4GalNAc-ABEE only scarcely. Furthermore, an allergenic pentasaccharitol ABEE derivative, GalNAcalpha1-->2Fucalpha1-->3(GalNAcbeta1-->4) GlcNAcbeta1-->2(3-acetoamido-3-deoxy)L-threose-ABEE, the minimum structural unit for the sea squirt allergenicity was hydrolyzed to 95 mol% for 72 h incubation with the enzyme. The enzyme could be utilized as a powerful tool for the structural analyses of the carbohydrate epitopes of the sea squirt allergen molecules.