Cold forging and chemical heat treatment of the casing of the internal joint for VAZ cars

The technological process of cold forging applied for the first time in the production of the casing of the internal joint with races is described. The process operations of cold forging and the annealing and carburizing regimes for this part me described.     

Nitric oxide reduction and carbon monoxide oxidation over carbon-supported copper-chromium catalysts

Carbon supported copper-chromium catalysts are shown to be very active for both the reduction of nitric oxide with carbon monoxide and the oxidation of carbon monoxide with oxygen. Mixed copper-chromium oxide active phases have good activity in the simultaneous removal of nitric oxide and carbon monoxide from exhaust gases. The influence of several catalyst variables has been investigated. The activity per volume of catalyst increases with increasing loading, while the intrinsic activity shows a maximum around C/M=100−50. An optimum catalyst for nitric oxide reduction and carbon monoxide oxidation has a copper/chromium ratio of 2/1. The apparent activation energy for the carbon monoxide oxidation over carbon supported copper-chromium catalysts is 77 kJ/mol, suggesting that the Cu---O bond rupture is the rate-limiting process. The reduction of nitric oxide takes place at higher temperatures. Since all catalysts have a low selectivity for molecular nitrogen formation at lower temperatures, the dissociation of nitric oxide is probably rate determining, resulting in a slightly reduced catalyst system. In an excess of carbon monoxide the reaction is first-order in nitric oxide and zero-order in carbon monoxide. Moisture inhibits the reaction by reversible competitive adsorption, whereas carbon dioxide does not. Oxygen completely inhibits the reduction of nitric oxide due to the more rapid reoxidation of the catalytic sites compared to nitric oxide. Therefore, the reduction of nitric oxide takes place only when all oxygen has been converted and, hence, is shifted to higher temperatures. As a possible consequence, the production of nitrous oxide is reduced. Nitric oxide and molecular oxygen react preferentially with carbon monoxide, so, in an excess of oxidizing component, gasification of the carbon support occurs at higher temperatures after carbon monoxide has been completely consumed.     

Afterburner [network-independent card for protocols]

Many current implementations of protocols such as the Transmission Control Protocol/Internet Protocol (TCP/IP) are inefficient because data are often accessed more frequently than necessary. Three techniques that reduce the need for memory bandwidth are proposed. The techniques are copy-on-write, page remapping, and single-copy. Afterburner, a network-independent card that provides the services that are necessary for a single-copy protocol stack, is described. The card has 1 MByte of local buffers and provides a simple interface to a variety of network link adapters, including HIPPI and asynchronous transfer mode (ATM). Afterburner can support transfers to and from the link adapter card at rates up to 1 Gbit/s. An implementation of TCP/IP that uses the features provided by Afterburner to reduce the movement of data to a single copy is discussed. Measurements of the end-to-end performance of Afterburner and the single-copy implementation of TCP/IP are presented     

Dynamic and equilibrium swelling of DVB-crosslinked polystyrene particles

The dynamic and equilibrium swelling behavior of polystyrene microparticles crosslinked with divinyl benzene was investigated in methyl ethyl ketone and cyclohexane. The dynamic studies gave new information about the mechanism of penetrant transport in this polymer. The equilibrium studies were used to determine important parameters of the crosslinked structure of these systems, including the average molecular weight between crosslinks, M?_c     

Neutron-activation determination of elements with overlapping resonances in neutron-absorption cross sections

Translated from Atomnaya Énergiya, Vol. 66, No. 6, pp. 423–424, June, 1989.     

Use of166mHo for calibration of gamma-ray spectrometers with semiconductor detectors

Translated from Atomnaya Énergiya, Vol. 67, No. 3, pp. 215–216, September, 1989.     

Changes in Lake Ontario Total Phosphorus Concentrations 1976–1978

An apparent decrease in total phosphorus concentrations of approximately 4.l μgP/L has been reported recently for the spring values of 1977 and 1978 in Lake Ontario. Investigation of the loading reduction for this period independent of sedimentation factors can account for only 10% of the change. The results indicate that changes in the sedimentation rate of total phosphorus during this period offer an explanation for the majority of the change in concentration.     

Molecular correlations in sheared thermotropic copolyesters showing banded textures

Banded textures produced in a thermotropic liquid crystal polymer by shearing between glass slides are examined by using both transmission electron and polarized light microscopy. The periodic variation in director orientation about the shear axis, as measured by light microscopy, is shown to be distinctly different from that indicated by electron diffraction. Measurements of birefringence and observation of Zernicke phase contrast indicate periodic variations in optical properties of the polymer, in step with the bands. Such effects are accounted for in terms of a synchronous rotation of the planar aromatic groups about the molecular chain axes. Evidence for an out-of-plane component of molecular orientation is also presented.     

Constant stretching rate experiments on low density polyethylene

A simple apparatus for elongational test of molten polymers is presented. Its realiability is demonstrated by means of stress growth in constant stretching rate experiments and relaxation test on a low density polyethylene sample.     

Fast algorithms for estimating the correlation functions of large signals

A fast algorithm is proposed for estimating the auto- and cross-correlation functions of a large signal. The algorithm is based on the sectioning method by the fast Fourier transform. We determine the optimal length of the portion of data read from external memory into RAM which achieves T_min—a minimum processing time. An estimate of T_min is obtained.Translated from Kibernetika, No. 3, pp. 78–81, May–June, 1991.