Optical fiber solitons, their properties and uses

The history and mathematical formulation of solutions are briefly reviewed. Solitons of the nonlinear Schrodinger equation are studied in greater detail because they describe nonlinear pulse propagation on dispersive optical fibers. The proposal by A. Hasegawa and the experiments of L.F. Mollenauer on long distance soliton propagation for use in repeaterless transoceanic fiber transmission cables are described. In 1986, limitations on the distance that can be spanned by a repeaterless link for a given bit rate were shown to exist. It has been shown recently that by proper design these limitations can be overcome, so that newer transoceanic cable designs are likely to utilize solitons. The special properties of solitons make them particularly suited for all optical switching and logic operations. Some recent experiments with such switches are described     

Component-relevancy and characterization results in multistatesystems

Two new versions of component relevancy for multistate structure functions are introduced. They are compared with some existing component-relevance conditions and their general properties are investigated. Based on the two relevance conditions, two component-importance measures for multistate systems are defined; they are most appropriate for comparing components when a certain type of system improvement is considered. Series and parallel structures are characterized within the L-superadditive and L-subadditive structure functions by imposing the two new relevance conditions     

p53 oncogene in the laryngeal cancer

The effect of a novel flavonoid, venoruton (a mixture of mono-, di-, tri- and tetrahydroxyethylrutosides) has been investigated in healthy rat lenses and compared with diabetic cataract modelled in vitro. One mM venoruton was added to medium simulating healthy and diabetic conditions for the incubated lenses; damage was followed by either stereoscopic photography of the lenses under a Cooperative Cataract Research Group operating microscope or with our recently developed method: the leakage of lactate dehydrogenase (LDH) into the lens culture media. The increased LDH activity in the medium and observable development of the opacity were correlated with cell damage, which has been found to be associated with globular degeneration and cataract formation. The extent of opacification and LDH release is reduced if 1 mM venoruton is included in the medium. The protective effect may be related to antioxidant activity against reactive oxygen species: decreased luminol luminescence was shown after venoruton addition to either superoxide-generating hypoxanthine plus xanthine oxidase, or hydrogen peroxide.     

Comment and discussion on digital processing of PD pulses

Some of the more salient aspects of the digital processing technology of PD signals are examined. Most of the efforts in this field are concentrated on the application of digital analyzers for pulse height analysis, pattern recognition and identification of the physical phenomena. It is demonstrated that errors in the signal processing unit can lead to dominant mistakes in the interpretation of the test results     

Solving ML equations for 2-parameter Poisson-process models forungrouped software-failure data

Existence conditions are given for maximum likelihood (ML) parameter estimates for several families of 2-parameter software-reliability Poisson-process models. For each such model, the ML equations can be expressed in terms of one equation in one unknown. Bounds are given on solutions to these one equation problems to serve as initial intervals for search algorithms like bisection. Uniqueness of the solutions is established in some cases. Solutions are also tabulated for certain simple cases. Results are given for ungrouped failure data (exact times are available for all failures). ML estimation problems for such a situation are treated as limiting cases of problems based on failure times grouped into intervals of decreasing mesh     

Magnetometer spacing criterion for biomagnetic source currentimaging

A criterion for determining the maximum spacing between magnetometers for measuring the magnetic field is derived. A two-dimensional (2-D) filter model is employed to determine the maximum spatial frequency component present in the magnetic field that is above the spectral noise level. This maximum frequency component is then sampled at a rate greater than twice per period as indicated by the Nyquist criterion, yielding the required magnetometer spacing. It is shown that the rule-of-thumb employed in current clinical biomagnetic array systems, that the spacing between the coils should be approximately equal to the depth of the source, is adequate when the signal-to-noise power ratio is less than 28.4 (14.5 dB). The analysis also quantitatively demonstrates that reducing the separation between the measurement and source planes has a greater effect on the resolution than decreasing the noise level by the same factor. This result is important for employing high T_c superconductor magnetometers that allow thinner thermal insulating layers at the cost of higher thermal noise     

Longitudinal diffusion and resistance to mass transfer as causes of nonideality in chromatography : J. J. van Deemter, F. J. Zuiderweg and A. Klinkenberg, Chem. Engng Sci. 5 271–289, 1956

The sharpness of separation in a gas-liquid chromatographic column is effected by longitudinal molecular diffusion, slowness to reach absorption equilibrium, and by flow irregularities in channels and across the column. The total effect of all these causes can be described by a simple equation which can be derived from the rigorous mathematical solution by introducing reasonable simplifying assumptions.     

Modeling of Diffusion in Capillary Porous Materials During the Drying Process

This paper presents a model of heterogenous diffusion in capillary porous materials during the process of drying. The governing heat and mass transfer equations have been established using the liquid as well as vapor flow. Two models have been presented. Model 1 does not consider the heat conduction while the model 2 has been established by considering the conduction. The developed models and the numerical solutions of the resulting differential equations can take into account the moisture and temperature dependent thermophysical properties of the product. All equations have been established in spherical coordinates but the programme written for the purpose of calculations can be used for other geometries also. Numerical calculations have been performed for gas concrete and tiles using model 1, while model 2 has been used for gas concrete only because of the lack of data for thermophysical properties of the tile. For gas concrete it was seen that conduction has only marginal effect on the drying process and the numerical predictions of the drying process were reasonably accurate.     

Polymer networks based on α,ω-methacrylate-terminated poly(1,3-dioxolane)

α,ω-Methacrylate-terminated poly(1,3-dioxolane)s (polyDXL) were synthesized by cationic ring-opening polymerization of DXL in the presence of methylene-bis(oxyethylmethacrylate) as transfer agent. If the initiator concentration is small compared with the transfer agent concentration, the molecular weights of the polymers are governed by the ratio of the reacted monomer to the reacted transfer agent. The α,ω-methacrylate-terminated polyDXLs obtained undergo free radical polymerization with formation of polyacetal networks. The properties of the networks as function of the molecular weight of the corresponding prepolymers are reported.     

Recombination-induced variants of Clostridium acetobutylicum ATCC 824 with increased solvent production

Three sporulation-specific genes (orfA, sigE, sigG) from clostridium acetobutylicum ATCC 824 are arranged in a cluster, encoding the putative sigma E-processing enzyme, sigma E, and sigma sigma G respectively. When they were transformed into Clostridium acetobutylicum while on a plasmid functional in this organism, transformants did not survive. Three kinds of recombinations were then attempted with nonreplicative plasmids: duplication of orfA and sigE, replacement of all of the three genes, and inactivation of orfA. While the wild-type strain ceased to grow and produce solvents in batch cultures after approximately 24 h, mutant strains were isolated that showed sustained growth for a much longer time and produced a threefold increase in acetone and butanol in test tube cultures. In addition, one of the derived strains showed a significantly higher growth rate. Features of the restriction maps of the recombinants did not correlate with expected maps, indicating possible complications occurring during the recombination events.