Removal of TDS from Cooling Tower Water by Using EDTA-Modified Bagasse Fibers

Modified by ethylenediaminetetraacetic acid (EDTA) salts and unmodified bagasse fibers were tested for the removal of total dissolved solids (TDSs) from cooling tower water. Parameters such as hydrogen ion concentration (pH), particle size of bagasse fibers, and the concentrations of adsorbent and adsorbate were studied to optimize the conditions to be applied on a commercial scale for the decontamination of effluents of cooling tower water. The optimum pH for TDS removal was between 6 and 6.5. The efficiency of TDS removal increased when the size of fiber particles decreased (100?μm) and when the concentration of EDTA salt increased to reach 78 mg/g of modified bagasse fibers. The adsorption parameters were determined using both Langmuir and Freundlich isotherms. The preferential mechanisms for the retention of TDSs are a complexation process between the TDSs and chemical functions present on the surface of fibers, and the chelation process with the EDTA attached to the fibers. The results obtained could be valuable for application to cooling tower water treatment and for the softening of hard drinking water.     

Alternative for Rapid Detection and Screening of Pork,Chicken, and Beef Using Dielectric Properties in the Frequency of 0.5 to 50 GHz

Dielectric property at high microwave frequency region has been utilized for possible rapid detection and screening of different types of meat, especially for halal authentication. This investigation focused on both raw and sterilized (processed) beef, pork, and chicken samples. Dielectric response that consists of dielectric constant and dielectric loss factor was measured over the range of 0.5 to 50 GHz. All raw and sterilized meat samples could be differentiated by the dielectric values. Two distinct peaks were observed only for both raw and sterilized pork samples at the frequency around 7.43 and 31.19 GHz. These peaks can potentially be linked to compounds that exist only in pork such as DNA, microbes, enzyme, proteins, amino acids, and many others. Dielectric values for sterilized samples were lower than raw samples due to molecule structural changes that occurred in the samples. The dielectric results promise a great potential of utilizing dielectric properties as a rapid on-site detection approach prior to subsequent laborious analysis.     

Antifungal activity of chitosan against Fusarium oxysporum f. sp. cubense

The in vitro antifungal activity of chitosan against Fusarium oxysporum f. sp. cubense Race 4 (FocR4) the causal agent of banana wilt was investigated. Chitosan at all concentrations tested reduced the hyphal growth of FocR4 on potato dextrose agar media and recording maximum inhibition of 76.36% at 8 mg/mL. The inhibitory effect was found to increase as chitosan concentration increases. The 50% effective concentration value was estimated by probit analysis, and it was 1.4 mg/mL. Chitosan was more effective in potato dextrose broth where it completely inhibited the mycelial growth of FocR4 at all concentrations tested. Chitosan inhibited the sporulation of FocR4 by a maximum of 96.53% at 8 mg/mL chitosan, and 100% inhibition for spore germination was recorded at all concentrations tested. Chitosan at concentrations of more than 1.6 mg/mL was also found to induce morphological changes in FocR4 characterized by agglomeration of hyphae, abnormal shapes, vesicles, or empty cells devoid of cytoplasm in the mycelia. © 2010 Wiley Periodicals, Inc. J Appl Polym Sci, 2011     

Corrosion of high purity Mg, Mg2Zn0.2Mn, ZE41 and AZ91 in Hank’s solution at 37 °C

The CO₂ partial pressure required to maintain a synthetic body fluid (SBF) at a constant pH, based on the initial bicarbonate concentration, was evaluated to be 0.013 atm for Hank’s solution and 0.083 atm for SBF27. Corrosion of high purity Mg and three Mg alloys in Hank’s solution was studied using hydrogen evolution, weight loss and Tafel extrapolation. The solution pH was maintained constant by CO₂. There was initially an incubation period with a low corrosion rate, a period of increasing corrosion rate, and subsequently steady state corrosion. Some hydrogen dissolved in the Mg metal.     

Design of dual‐band microstrip patch antenna with right‐angle triangular aperture slot for energy transfer application

This work focusing on the dual‐band antenna design with rectifying circuit for energy transfer system technology for enhancement gain performance. The air gap technique is applied on this microstrip antenna design work to enhance the antenna gain. The work begins with designing and analyzing the antenna via the CST Microwave Studio software. After validation on acceptable performance in simulation side is obtained, the return loss, S₁₁ of the antenna is measured using vector network analyzer equipment. The rectifier circuit is used to convert the captured signal to DC voltage. This projected dual‐band antenna has successfully accomplished the target on return loss of ?44.707 dB and ?32.163 dB at dual resonant frequencies for 1.8 GHz and 2.4 GHz, respectively. This proposed antenna design benefits in low cost fabrication and has achieved high gain of 6.31 dBi and 7.82 dBi for dual‐band functioning frequencies.     

Bioresorbable and degradable behaviors of PGA: Current state and future prospects

Polyglycolic acid (PGA) is a class of semicrystalline, bioresorbable polymers that have been widely used in a number of applications. No other bioresorbable materials can fully replace PGA in tissue engineering. Understanding degradation mechanisms in PGA is important for improving the efficiency and effectiveness in various fields including implantation. This review begins with a discussion on terminology of polymer degradation and hydrolytic degradation mechanism with a delineative model. This review also focus on previous degradation studies taking advantage of its fast-degrading behavior and the mechanism behind hexafluoroisopropanol (HFIP) being the sole solvent for PGA. Finally, the merits of PGA are discussed with many potential future applications along with their associated challenges.     

Influence of Hydrogen Bonding on Low Critical Micellar Concentration Value and Formation of Giant Vesicle of Triazole-Contained Amphiphile

An amphiphile molecule consisting of triazole moiety has been thoroughly investigated using different approaches in its aqueous condition. The studies have discovered the explicit function of its heteroaromatic ability in molecular self-assembling. From the fluorescence evidence, the triazole-based amphiphile has shown that the aggregation-induced emission behavior is mainly due to the triazolyl. It suggests that the triazole is directly involved in the self-assembling mechanism through an intermolecular interaction. This interaction can be verified by the shifting of proton frequency of the triazole, which is clearly shown by the constant frequency of the proton above the critical micellar concentration (CMC) value. The frequency suggests the establishing hydrogen bond that occurred between the hydrogen and the second nitrogen of the adjacent triazole. These results are consistent with the micellization of the molecule which was determined at a very low CMC value (0.1 mM). The absorbance and optical polarizing microscopy results also support the evidence of the growth of giant vesicles produced from the neutralization of the amphiphile. The formation of stable giant vesicles at neutral pH demonstrates the immediate strong hydrogen bonding connections within the triazoles layer in the bilayer. The discovery reveals that internal hydrogen bonds formed from a heteroaromatic with the appropriate molecular arrangement can promote self-aggregation and enhance overall stability.