A fully soft-switched extended-period quasi-resonantpower-factor-correction circuit

This paper presents the design criteria, procedure, and implementation of a soft-switched power-factor-correction (PFC) circuit based on the extended-period quasi-resonant (EPQR) principles. All power electronic devices including switches and diodes in the circuit are fully soft switched. The design method is demonstrated in a prototype circuit. The operating principles are confirmed with computer simulation and experimental results. A comparison of the EP-QR operation and zero-voltage-transition (ZVT) pulse-width modulation (PWM) method     

Automatic fault detection, isolation, and recovery in transparentall-optical networks

Network fault identification is an important network management function, which is closely related to fault management and has an impact on other network management functions such as configuration management, and performance management. This paper investigates fault surveillance and fault identification mechanisms for a transparent optical network in which data travels optically from the source node to the destination node without going through any optical-to-electrical (O/E) or electrical-to-optical (E/O) conversion. Mechanisms and algorithms are proposed to detect and isolate faults such as fiber cuts, laser, receiver, or router failures. These mechanisms allow nonintrusive device monitoring without requiring any prior knowledge of the actual protocols being used in the data transmission     

Series equivalence/operation of current-controlled boost-typesingle-phase voltage source converters for bidirectional power flow

Single-phase voltage source power converters (VSCs) under consideration are AC-DC current-controlled boost-type power converters with bidirectional power-handling capability. Equivalence between two series-connected two-level power converters and a single three-level power converter is considered here. Further considered is the series operation of three-level power converters. Simulation results and experimental verification for both are provided. Economical configurations of three-level power converters leading to multilevel waveforms are presented thereafter     

Phase-only adaptive nulling with a genetic algorithm

This paper describes a new approach to adaptive phase-only nulling with phased arrays. A genetic algorithm adjusts some of the least significant bits of the beam steering phase shifters to minimize the total output power. Using small adaptive phase values results in minor deviations in the beam steering direction and small perturbations in the sidelobe level in addition to constraining the search space of the genetic algorithm. Various results are presented to show the advantages and limitations of this approach, in general, the genetic algorithm proves to be better than previous phase-only adaptive algorithms     

Quick estimation of rare events in stochastic networks

This paper presents a method for fast estimation of probabilities of rare events in stochastic networks, with a particular emphasis on coherent reliability systems. The method is based on the concepts of likelihood-ratios (LR), change of probability measure and the bottleneck-cut in the network. Both polynomial and exponential-time Monte Carlo estimators are defined, and conditions under which the time complexity of the proposed LR estimators is bounded by a polynomial are discussed. The accuracy of the method depends only on the size (cardinality) of the bottleneck-cut, not on the topology and actual size of the network. Supporting numerical results are presented, with the cardinality of the bottleneck-cut ⩽20     

Four-channel polarization-insensitive optically transparent wavelength converter

Multichannel wavelength converters may be important components in the cross-connects in future wavelength-division multiplexed (WDM) transport networks. We demonstrate a multichannel, polarization-insensitive, optically transparent wavelength converter, based on four-wave mixing in two semiconductor optical amplifiers in a polarization-diversity arrangement. Bit-error-rate (BER) measurements with four input 2.5-Gb/s WDM channels, spaced by 2 nm, show penalties for wavelength conversion less than 2.6 dB at 10/sup -9/ BER. Changes in the state of polarization of the input signals cause the output power to change by less than 1.2 dB, and the corresponding power penalties change by less than 0.9 dB.     

Wavelet packet modulation for orthogonally multiplexedcommunication

Utilizing multidimensional signaling techniques, a generalized multirate wavelet-based modulation format for orthogonally multiplexed communication systems is presented. Wavelet packet modulation (WPM) employs the basis functions from an arbitrary pruning of a dyadic tree structured filter bank as orthogonal pulse shapes for conventional quadrature amplitude modulation (QAM) symbols. This generalized framework affords an entire library of basis sets with increased flexibility in time-frequency (T-F) partitioning. The bandwidth efficiency and power spectral density figures of merit for the general signal are derived and shown to be that of standard QAM     

Wavelength selection for low-saturation pulse oximetry

Conventional pulse oximeters are accurate at high oxygen saturation under a variety of physiological conditions but show worsening accuracy at lower saturation (below 70%). Numerical modeling suggests that sensors fabricated with 735 and 890 nm emitters should read more accurately at low saturation under a variety of conditions than sensors made with conventionally used 660 and 900 nm band emitters. Recent animal testing confirms this expectation. It is postulated that the most repeatable and stable accuracy of the pulse oximeter occurs when the fractional change in photon path lengths due to perturbations in the tissue (relative to the conditions present during system calibration) is equivalent at the two wavelengths. Additionally, the penetration depth (and/or breadth) of the probing light needs to be well matched at the two wavelengths in order to minimize the effects of tissue heterogeneity. At high saturation these conditions are optimally met with 660 and 900 nm band emitters, while at low saturation 735 and 890 nm provide better performance     

Perineurioma: an unusual cause of an external auditory canal polyp

BACKGROUND: Home parenteral nutrition (HPN) is used to treat intestinal failure. A minority of HPN patients are dependent on opiates and benzodiazepines to control pain and anxiety. The aim of this study was to determine what effects such drug dependence had on patient outcomes. METHODS: Ten dependent patients were prospectively compared with 10 well-matched, nondependent HPN patients for the same 12-month period. Episodes of line sepsis and other complications were documented and the cost of treatment estimated. Health status was measured using the SF36 and EuroQol instruments. RESULTS: The dependent group had significantly more episodes of central line sepsis (p = .0007) as well as other complications (p = .0002). This led to significantly longer periods of inpatient care (p = .0004) and therefore higher costs of treatment. Health status was lower in the dependent group; they reported more pain (p = .04) and less energy (p = .04). CONCLUSIONS: The complication rate and increased cost of treatment for opiate- and sedative-dependent patients receiving HPN significantly detract from the overall outcome of this therapy.     

Estimating local mean signal strength of indoor multipathpropagation

We explore techniques for the measurement of local mean signal strength at 900 MHz and 2 GHz. In particular, we characterize the impact of transmitter and receiver antenna rotation on the estimated local mean. Then, we explore the collection of high resolution data while moving along a linear trajectory and using linear averaging techniques to estimate the local mean. With this information, the best measurement techniques can be chosen depending on the required speed versus accuracy tradeoff. Finally, we use a ray tracing propagation model to evaluate different methods of calculating the local mean signal strength for indoor environments