Congenic rats reveal three independent Copenhagen alleles within the Mcs1 quantitative trait locus that confer resistance to mammary cancer

It has previously been shown that the Copenhagen (COP) rat contains several genetic loci that contribute to its mammary tumor-resistant phenotype after 7,12-dimethylbenz(a)anthracene (DMBA) administration. One of these loci, mammary carcinoma susceptibility 1 (Mcs1), is located on the centromeric end of chromosome 2 and appears to act in a semidominant fashion. To confirm the existence and independent action of this locus and also aid in the identification of the physical location of the Mcs1 gene, congenic lines were generated by transferring the Mcs1 COP allele onto a Wistar Furth (WF) genetic background. Male carriers were genotyped using microsatellite markers spanning 20-30 cM of the Mcs1 locus. One of the congenic lines minimally retained the COP allele at D2Mit29 on the centromeric end of chromosome 2 and extended distally to D2Rat201. Heterozygous Mcs1 carrier rats were interbred, and the female offspring were treated with DMBA. The female rats from the Mcs1 congenic line that carried one or two COP alleles of the Mcs1 region had a significantly reduced (65 and 85%, respectively) tumor development (P < 0.001) compared with rats carrying zero COP alleles at this locus. A WF.COP-D2Mit29/D2Rat201 homozygous congenic strain derived at the N10 generation was treated with DMBA, and the COP homozygous rats developed 1.5 +/- 0.3 carcinomas/rat versus 6.3 +/- 0.5 in WF control rats (P < 0.0001). Fine mapping of this congenic interval using several recombinant lines identified three genetic loci within the Mcs1 congenic region that independently supported a tumor resistance phenotype. These genetic loci have been termed Mcs1a, Mcs1b, and Mcs1c. In rats for which each locus was homozygous for the COP allele, tumor development was reduced by approximately 60% compared with littermate controls. The identification of these independent loci within the Mcs1 COP allele provide a model of the genetic complexity of cancer.     

Effect of thermal treatment on ZnO substrate for epitaxial growth

ZnO is a highly efficient photon emitter, and has optical and piezoelectric properties that are attractive for a variety of applications in sensors and potentially optoelectronic devices such as emitters. Due to its identical stacking order and close lattice match to GaN, it is also being developed as a substrate material for GaN epitaxy. However, the surface finish of the ZnO is such that much of the damage induced by sawing and follow up mechanical polishing remains. We developed a thermal treatment method to eliminate surface damage on the 0 face of ZnO (0 0 0 1) to prepare it for epitaxial growth. Atomic force microscopy images of ZnO (0 0 0 1) annealed at 1050 °C for 3 h etc. show that residual scratches from mechanical polishing are removed and atomically flat, terrace-like surfaces are attained. In addition, low-temperature photoluminescence and high-resolution X-ray diffraction measurements have been employed to investigate the effect of annealing on ZnO substrates.     

Analytical modeling of imperfect bond between coated fibers and matrix material

The present study is intended to find the stress intensity factors (SIF) and strain energy release rates (SERR) at the tips of an interface crack in a non-homogeneous medium. The boundary-value problem governing a three-phase concentric cylinders model is used to analyze annular interfacial crack problems with Love's strain functions. The complex form of a singular integral equation of second kind is formulated using Bessel's functions in Fourier domain. Stress intensity factors (SIF) and total strain energy release rates (SERR) are calculated using Jacoby polynomials. For validity of the equations of Stress Intensity Factors, the Singular Integral Equation (SIE) of a three concentric cylinders model is reduced to the SIE for a two concentric cylinders model and results are compared with previous results of Erdogan.     

Current distribution, resistance, and inductance forsuperconducting strip transmission lines

A method for the calculation of the current distribution, resistance, and inductance matrices for a system of coupled superconducting transmission lines having finite rectangular cross-section is presented. These calculations allow accurate characterization of both high-T_c and low-T _c superconducting strip transmission lines. For a single stripline geometry with finite ground planes, the current distribution, resistance, inductance, and kinetic inductance are calculated as functions of the penetration depth for various film thicknesses. These calculations are then used to determine the penetration depth for Nb, NbN, and YBa₂Cu₃O_7-x superconducting thin films from the measured temperature dependence of the resonant frequency of a stripline resonator. The calculations are also used to convert measured temperature dependence of the quality factor to the intrinsic surface resistance as a function of temperature for an Nb stripline resonator     

Maximum power density for an endoreversible carnot heat engine

An analysis using maximum power-density criteria has been carried out for an endoreversible Carnot heat engine. The results have been compared with known results on maximum power analysis. The design parameters at maximum power density lead to smaller and more efficient endoreversible Carnot heat engines than those working at maximum power output.     

Selective monitoring of peptidase activities with synthetic polypeptide substrates and polyion-sensitive membrane electrode detection

A novel method to monitor specific peptidase activities in biological samples as complex as undiluted plasma/blood is described. The approach is based on the design of synthetic polypeptide substrates in which di- or triarginine sequences are linked to each other via one or more other amino acids recognized specifically by the peptidase to be determined. Detection of chymotrypsin and renin activities using synthetic substrates P4 (F-R-R-R-F-V-R-R-F-NH2) and P5 (R-R-R-L-L-R-R-L-L-R-R-R), respectively, serves to demonstrate the principles of this new assay system. A polyion-sensitive membrane electrode, prepared by doping polymer films with dinonylnaphthalene-sulfonate (DNNS), is shown to exhibit significant nonequilibrium electromotive force (EMF) responses toward these and other polycationic substrates at microgram/milliliter levels under physiological conditions. The same electrode, however, exhibits much smaller total EMF response toward the shorter fragments of the synthetic peptides generated by peptidase activity; hence, the addition of peptidase to a solution containing the synthetic substrate yields a change in electrode EMF response, the rate of which is proportional to the activity of peptidase present. Other synthetic polycationic peptides as well as natural polycationic peptides (e.g., protamine) that lack specific cleavage sites for chymotrypsin and renin, yet are detected by the DNNS-based membrane electrode, do not elicit any significant change in EMF response in the presence of the peptidases, confirming the feasibility and utility of the proposed bioanalytical method.     

Platinum concentrations in urban road dust and soil, and in blood and urine in the United Kingdom

Increasing Pt concentrations from vehicle catalysts have been reported from a number of countries. Analysis of Pt and Pd in soils and road dusts taken from areas of high and low traffic flows in SE England show concentrations of Pt in the range < 0.30-40.1 ng g-1 and Pd in the range < 2.1-57.9 ng g-1. Higher concentrations of Pt are associated with high traffic densities. Samples taken from streets of lower traffic flows were found to contain the lower concentrations of the ranges. Pilot studies of Pt concentrations in blood and urine using ICP-MS have been carried out. Platinum concentrations in whole blood were: precious metal workers, 780-2170, mean 1263 pmol l-1 (0.152-0.423, mean 0.246 microgram l-1); motorway maintenance workers, 645-810, mean 744 pmol l-1 (0.126-0.158, mean 0.145 microgram l-1); Imperial College staff, 590-713, mean 660 pmol l-1 (0.115-0.139, mean 0.129 microgram l-1). Platinum concentrations in urine in pmol Pt per mmol creatinine were: precious metal workers, 122-682, mean 273 [0.21-1.18, mean 0.47 microgram Pt (g creatinine)-1]; motorway maintenance workers, 13-78, mean 33.7 [0.022-0.135, mean 0.058 microgram Pt (g creatinine)-1]; Imperial College staff, 28-130, mean 65.6 [0.048-0.224, mean 0.113 microgram Pt (g creatinine)-1]. Detection limits were 0.03 microgram l-1 for both blood and urine. The possible health effects of increasing Pt in the environment are discussed. Platinum provides an excellent example of the significance of speciation in metal toxicity. Platinum allergy is confined to a small group of charged compounds that contain reactive ligand systems, the most effective of which are chloride ligand systems. Metallic Pt is considered to be biologically inert and non allergenic and since the emitted Pt is probably in the metallic or oxide form, the sensitising potential is probably very low. Platinum from road dusts, however, can be solubilised, and enter waters, sediments, soils and the food chain. There is at present no evidence for any adverse health effects from Pt in the general environment, particularly allergic reactions.     

Histamine H3 receptors contribute to drinking elicited by eating in rats

A role for endogenous histamine and its H3 receptor subtype for mediating drinking elicited by eating was examined in adult male Sprague-Dawley rats. The i.p. injection of the H3 agonist R-alpha-methylhistamine (Ramh, 2.5 mg/kg) shortened the latency to initiate drinking and increased 1-h water intake in nondeprived rats freely eating pellets and drinking water. The ICV injection (through a surgically implanted chronic cannula) of 10 micrograms Ramh increased water intake; this Ramh-induced drinking was abolished by previous ICV injection of the H3 antagonist thioperamide (Th, 60 micrograms). For rats drinking and eating after 24-h food deprivation, s.c. Th inhibited drinking behavior: for example, 10 mg/kg Th s.c. delayed the latency to initiate drinking and inhibited 1-h water intake without inhibition of food intake. In contrast, 60 micrograms Th ICV failed to inhibit food-related drinking in rats eating after food deprivation. For nondeprived rats eating a small cracker, 10 mg/kg Th s.c. delayed the latency to initiate drinking and abolished water intake without effect of eating, and 60 micrograms Th ICV had similar effects upon drinking elicited by ingestion of cracker. The IG infusion (through a surgically implanted gastric catheter) of 2 ml 600 or 900 mOsm/kg NaCl, a treatment that is subthreshold for increase in systemic plasma osmolality at the initiation of drinking, elicited drinking that was abolished by 10 mg/kg Th s.c. and attenuated by 60 micrograms Th ICV. The IG infusion of 2 ml 1800 mOsm/kg NaCl, a treatment that is above threshold for increase in systemic plasma osmolality, elicited drinking that was attenuated by 10 mg/kg s.c. or 60 micrograms Th ICV. These results demonstrate that peripheral and central H3 receptors for histamine have a role in drinking elicited by eating and the postprandial gastrointestinal osmotic consequences of eating. These findings extend the evidence demonstrating a histaminergic contribution to food-related drinking in rats.     

Structures stabilizing the dimer interface on human 11 beta-hydroxysteroid dehydrogenase types 1 and 2 and human 15-hydroxyprostaglandin dehydrogenase and their homologs

Human 11 beta-hydroxysteroid dehydrogenase-types 1 and 2 and human 15-hydroxyprostaglandin dehydrogenase belong to a large family of oxidoreductases that includes human dihydropteridine reductase and Streptomyces hydrogenans 20 beta-hydroxysteroid dehydrogenase, for which 3D structures are available. Almost all of these enzymes are either dimers or tetramers. The dimer interface of rat dihydropteridine reductase consists of alpha-helices E and F from each monomer arranged in a four alpha-helix bundle [Varughese et al. (1992) Proc. Natl. Acad. Sci. USA 89, 6080-6084]. Alpha-helix F contains tyrosine-146 and lysine-150, residues that are highly conserved in this protein superfamily and have been proposed to be at the catalytic site. We have examined the dimer interface between alpha-helix F in human and rat dihydropteridine reductase and Streptomyces hydrogenans 20 beta-hydroxysteroid dehydrogenase as well as modeled 3D structures of steroid and prostaglandin dehydrogenases and homologs for stabilizing interactions. We find a site in the middle of alpha-helix F that stabilizes the dimer. This anchor is adjacent to conserved lysine on alpha-helix F. Our analysis suggests that sequence variation in the anchor may be important in substrate specificity.