High‐Performance,Monolithic Polyaniline Electrochemical Actuators

New polyaniline (PANI) asymmetric membranes were fabricated using a phase‐inversion technique with hexane as the coagulation bath. These membranes exhibit a dense structure with macrovoids distributed asymmetrically throughout the cross‐section. A stress–strain study demonstrated that the Young's modulus (1.421 GPa) and strain at break (7.6 %) of the new PANI asymmetric membranes prepared from hexane are approximately 12 and 4 times higher, respectively, than the values reported previously for the PANI integrally skinned asymmetric membranes (ISAMs) (123 MPa Young's modulus and 1.8 % strain at break). Furthermore, monolithic electrochemical actuators based on a single PANI asymmetric membrane were constructed, and a bending movement of up to 20 Hz was experimentally recorded in a hydrochloric acid aqueous solution. A lifetime of over 329 500 cycles was determined for these actuators at a ± 2° angular displacement (5 Hz). The lifetime is limited by a bending fatigue that creates a transversal crack on the PANI membrane at the air–water interface. Control over the actuator movement is also manifested by the linear dependences of the bending angle on the charge and of the angular velocity on the current. These relationships are independent of both the kind of applied electric signal and the frequency used.     

Possibilities and extension of XRD material response analysis in failure research for the advanced evaluation of the damage level of Hertzian loaded components

Due to clearly distinguishable damage symptoms, it is differentiated between the surface and sub‐surface failure mode of rolling bearings. Material states red out by X‐ray diffraction (XRD) residual stress measurements point to a variety of loading conditions especially at raceway surfaces that are associated with several competing failure mechanisms. The corresponding lifetime reduction can range from the lower fatigue strength region to material ratcheting in extreme cases. Relevant position of the microstructural changes and nature of the failure mechanisms are characterized. The time alteration of the XRD material parameters measured at or near the surface and at the depth of the maximum equivalent stress correlates, in a different manner, with the statistical parameter of the 10 % bearing life. Both failure modes are illustrated by concrete examples. Contaminated lubricant and boundary lubrication, which represent practically important surface‐induced failures, are discussed in more detail. Gray staining, i.e. shallow pitting, often occurs without distinct indication of global material aging by means of XRD characteristics. Here, scanning electron microscopy observations and electron microprobe analyses point to corrosion fatigue as acting surface failure mechanism. The interaction between material and lubricant under complex loading regimes particularly of mixed friction and corrosion opens further failure research areas in the field of tribology.     

Hierarchical Self‐Assembly of Peptide‐Coated Carbon Nanotubes

Numerous applications, from molecular electronics to super‐strong composites, have been suggested for carbon nanotubes. Despite this promise, difficulty in assembling raw carbon nanotubes into functional structures is a deterrent for applications. In contrast, biological materials have evolved to self‐assemble, and the lessons of their self‐assembly can be applied to synthetic materials such as carbon nanotubes. Here we show that single‐walled carbon nanotubes, coated with a designed amphiphilic peptide, can be assembled into ordered hierarchical structures. This novel methodology offers a new route for controlling the physical properties of nanotube systems at all length scales from the nano‐ to the macroscale. Moreover, this technique is not limited to assembling carbon nanotubes, and could be modified to serve as a general procedure for controllably assembling other nanostructures into functional materials.     

Lipase‐catalyzed dynamic kinetic resolution of (R,S)‐fenoprofen thioester in isooctane

A lipase‐catalyzed enantioselective hydrolysis process under in situ racemization of the remaining (R)‐thioetser substrate with trioctylamine as the catalyst was developed for the production of (S)‐fenoprofen from (R,S)‐fenoprofen 2,2,2‐trifluoroethyl thioester in isooctane. Detailed investigations of trioctylamine concentration on the enzyme activation and the kinetic behavior of the thioester in racemization and enzymatic reactions were conducted, in which good agreement between the experimental data and theoretical results was observed. © 2002 Society of Chemical Industry     

Experimental results of a solar assisted heat pump rice drying system

In the last rice harvest season, experimental results have been obtained on the efficiency and drying quality of a solar assisted heat pump drying prototype system. The system has been operated as a solar and heat pump system and drying curves for the different options have been obtained. The advantage of the low temperature and better control in the drier shows that the heat pump assisted solar drying system is an excellent alternative to traditional drying systems.     

Extrusion-rotomolding of plasticized PVC formulations

In this work, we present a novel process to produce plasticized PVC articles. Plasticized PVC dispersion resin (dry blend) was extruded and poured into a hot mold. The mold was transferred to a rotomolding machine, where the final geometry was obtained. Formulations using commercial PVC suspension resin and three different types of plasticizers were prepared under different processing conditions. The physical appearance of the articles and the tensile properties of the materials were evaluated.     

Determination of assimilable organic carbon (aoc) in ozonated water with acinetobacter calcoaceticus

The effect of ozone application in drinking water on the production of assimilable organic carbon (AOC) was evaluated. The typical procedure to determine AOC is suggested by van der Kooij, which is the method of bacterial growth measurement by colony‐forming units using the strain P17 and/or NOX. The bacterial indicator species used for this study is Acinetobacter calcoaceticus which was isolated and identified while ozonating Nakdong river water. This strain could never be isolated from the raw water, but this strain was the predominant isolate in the ozonated water. Within a short incubation time, this organism was found to replicate well on acetate and oxalate as the sole carbon sources. The yield coefficients of this organism for acetate and oxalate are the same order of magnitude as the value of P17 and NOX. With full‐scale experiments, A. calcoaceticus concentration was found to increase after ozonation, but did not decrease upon chlorination. In laboratory‐scale experiments with Yongsan river water, aldehyes were found to be produced in proportion to the ozone dose. The raw water contains low concentrations of aldehydes, but has a high AOC concentration. A correlation between aldehyde production and AOC production was observed in the tested water with ozonation.     

Oculomotor paralysis. The perspective of a neuro-ophthalmology consultation

Ocular paresis is a usual diagnosis in neuro-ophthalmologic consultation, and its aetiology is indeed a challenge. The authors studied 3400 records concerning this consultation, between 1982 and the third quarter of 1993. During this period 221 cases with ocular paresis were selected. During this retrospective study we point out the following items: the cranial nerve affected; the neuro-ophthalmologic semiology; the aetiology and clinical evolution, according to the age groups. From 221 cases selected, 111 were paresis from the VIth pair (50.2%), 88 from the IIIrd pair (39.8%), 14 multiple paresis (6.4%) and 8 paresis from the IVth pair (3.6%). The most frequent complaint was diplopia (> 90%). As far as the aetiological diagnosis is concerned, this was easier to establish in patients > 50 years of age. In this age group the most usual aetiology was vascular and traumatic pathologies. In younger patients the most frequent pathologies were traumatic and tumoral. The prognostic was better in the vascular group, the paresis recovery being > 50% in all other pathologies, except the tumoral one.