An Improved Multifactor User Authentication Scheme for Wireless Sensor Networks

Wireless Personal Communications - Wireless Sensor Networks (WSNs) are used to collect and transmitted the data in various applications from normal to those which requires significant security...     

Analytical modeling of subthreshold current and subthreshold swing of Gaussiandoped strained-Si-on-insulator MOSFETs

This paper presents the analytical modeling of subthreshold current and subthreshold swing of short- channel fully-depleted （FD） strained-Si-on-insulator （SSOI） MOSFETs having vertical Gaussian-like doping pro- file in the channel. The subthreshold current and subthreshold swing have been derived using the parabolic approx- imation method. In addition to the effect of strain on silicon layer, various other device parameters such as channel length （L）, gate-oxide thickness （tox）, strained-Si channel thickness （ts_Si）, peak doping concentration （Np）, project range （Rp） and straggle （op） of the Gaussian profile have been considered while predicting the device characteris- tics. The present work may help to overcome the degradation in subthreshold characteristics with strain engineering. These subthreshold current and swing models provide valuable information for strained-Si MOSFET design. Ac- curacy of the proposed models is verified using the commercially available ATLASTM, a two-dimensional （2D） device simulator from SILVACO.     

Quasi-elliptic filter characteristics of an asymmetric defected ground structure

An asymmetric defected ground structure (DGS) with respect to a microstrip line is proposed. Its unit cell consists of two square slots connected with a rectangular slot by meandered transverse slots. The simulated, measured and equivalent circuit responses have been presented. The unit DGS pattern under microstrip line produces wide rejection bandwidth and high sharpness factor. Its elliptic band-reject filter response is modelled by appropriate LC equivalent circuit. Two such DGS cells under a microstrip line produce 3-pole quasi-elliptic bandstop filter response, which shows deeper attenuation without appreciable change in pole frequencies in comparison to single cell structure. Unit DGS pattern under coupled gap microstrip lines produces band-accept filtering characteristics. The frequency characteristics show a quasi-elliptic highpass filtering characteristics with sharp lower transition knee. Accordingly, an LC equivalent circuit is proposed. A cascaded band-accept and band-reject filter is proposed for designing a wideband bandpass filter. The bandwidth and centre frequency of the bandpass filter can be varied by choosing different set of DGS dimensions.     

Characterization of hello message exchange to estimate sensor node's neighborhood residual energy distribution in initialization phase

The paper characterizes the hello message exchange (HME) procedure for a sensor node to develop its neighborhood residual energy distribution in the initialization phase of a static wireless sensor network. Because of the lack of coordination on channel access in the initialization phase, hello messages from multiple nodes face a high risk of data collision in the exchange course. A discovery ratio is hereby defined to measure the sufficiency of the HME procedure. The discovery ratio is related to the precision of the parameter estimates for the probability density function of a node's neighborhood residual energy distribution. To achieve an arbitrarily high discovery ratio within a resolvable time interval, the HME procedure is implemented using Birthday protocol, which results in large node energy consumption. To overcome this flaw, a method termed carrier sensing mini‐slot algorithm is proposed to carry out the HME procedure. The time duration and the node energy consumption for the HME procedures based on the Birthday protocol and the carrier sensing mini‐slot algorithm, respectively, are theoretically analyzed and verified by simulations. Copyright © 2011 John Wiley & Sons, Ltd.     

Simulation of single phase non-Newtonian flow characteristics of heavy crude oil through horizontal pipelines

The effect of diameter, velocity, and temperature on flow properties of heavy crude oil in three horizontal pipelines using computational fluid dynamics (CFD) was studied. The flow characteristics were simulated by using CFD software, ANSYS Fluent 6.2. The mesh geometry of the pipelines having inner diameter of 1, 1.5, and 2 inch were created by using Gambit 2.4.6. From grid independent study, 221, 365 mesh sizes were selected for simulation. The CFD ANSYS Fluent 6.2 Solver predicted the flow phenomena, pressure, pressure drop, wall shear stress, shear strain rate, and friction factor. A good agreement between experimental and CFD simulated values was obtained.     

A unique method for reducing losses of bends in dielectric optical wave guide

The dielectric optical wave guide is finding growing attention at millimeter wave frequencies. However the dielectric optical waveguide radiates at bends and thus transmission loss increases. These radiations are in the outword direction of bends. This output radiation at output bends arises due to change in phase velocities of the propagating wave at the centre of the dielectric guide and the phase velocity at the outer surface of the dielectric guide. A unique methiod is suggested to avoid these radiation losses.Experimental results are also shown at microwave frequencies.     

Variation of wave impedance of shielded suspended dielectric guide

A shielded suspended dielectric guide is a dielectric rectangular slab enclosed by regular metallic side walls from all the sides. This type of structure is used in dual mode phase shifter where the size of the normal rectangular wave guide is reduced at the ends, where a dielectric material is embeded in ferrite core. Hence impedance variation of a phase shifter at its transition may be easily calculated using shielded suspended dielectric guide which is a prime parameter for optimum efficiency of wave launching.     

4-phase sequences with near-optimum correlation properties

Two families of four-phase sequences are constructed using irreducible polynomials over Z₄. Family A has period L =2^r-1. size L+2. and maximum nontrivial correlation magnitude C_max⩽1+√(L+1), where r is a positive integer. Family B has period L=2(2^r-1). size (L+2)/4. and C_max for complex-valued sequences. Of particular interest, family A has the same size and period as the family of binary Gold sequences. but its maximum nontrivial correlation is smaller by a factor of √2. Since the Gold family for r odd is optimal with respect to the Welch bound restricted to binary sequences, family A is thus superior to the best possible binary design of the same family size. Unlike the Gold design, families A and B are asymptotically optimal whether r is odd or even. Both families are suitable for achieving code-division multiple-access and are easily, implemented using shift registers. The exact distribution of correlation values is given for both families     

Stability and throughput analysis of unslotted CDMA‐ALOHA with finite number of users and code sharing

We consider a system comprising a finite number of nodes, with infinite packet buffers, that use unslotted ALOHA with Code Division Multiple Access (CDMA) to share a channel for transmitting packetised data. We propose a simple model for packet transmission and retransmission at each node, and show that saturation throughput in this model yields a sufficient condition for the stability of the packet buffers; we interpret this as the capacity of the access method. We calculate and compare the capacities of CDMA‐ALOHA (with and without code sharing) and TDMA‐ALOHA; we also consider carrier sensing and collision detection versions of these protocols. In each case, saturation throughput can be obtained via analysis of a continuous time Markov chain. Our results show how saturation throughput degrades with code‐sharing. Finally, we also present some simulation results for mean packet delay. Our work is motivated by optical CDMA in which “chips” can be optically generated, and hence the achievable chip rate can exceed the achievable TDMA bit rate which is limited by electronics. Code sharing may be useful in the optical CDMA context as it reduces the number of optical correlators at the receivers. Our throughput results help to quantify by how much the CDMA chip rate should exceed the TDMA bit rate so that CDMA‐ALOHA yields better capacity than TDMA‐ALOHA. This revised version was published online in June 2006 with corrections to the Cover Date.