Interpretation of the results of the CORA-33 dry core boiling water reactor test

All boiling water reactor (BWR) degraded core experiments performed prior to CORA-33 were conducted under ‘wet’ core degradation conditions, in which water remains within the core and continuous steaming feeds metal-steam oxidation reactions on the in-core metallic surfaces. However, one dominant set of accident scenarios would occur with reduced metal oxidation under ‘dry’ core degradation conditions and, prior to CORA-33, this set had been neglected experimentally. The CORA-33 experiment was designed specifically to address this dominant set of BWR ‘dry’ core severe accident scenarios and to resolve partially phenomenological uncertainties concerning the behavior of relocating metallic melts that drain into the lower regions of a ‘dry’ BWR core (the ex-reactor experiments at Sandia National Laboratories will further address these uncertainties). CORA-33 was conducted on 1 October 1992, in the CORA test facility at Karlsruhe. A review of the CORA-33 data indicates that the objectives were achieved; i.e. core degradation occurred at a core heat-up rate (characterized by the absence of any temperature escalation caused by oxidation) and a test section axial temperature profile (at incipient structural melting) that are prototypic of full-core nuclear power plant simulations under ‘dry’ core conditions. Simulations of the CORA-33 test at Oak Ridge National Laboratory (ORNL) have required the modification of existing control blade-canister materials interaction models to include the eutectic melting of the stainless steel-zircaloy interaction products and the heat of mixing of stainless steel and zircaloy. The timing and location of canister failure and melt intrusion into the fuel assembly appear to be adequately simulated by the ORNL models. This paper will present the results of the post-test analyses carried out at ORNL based on the experimental data and the post-test examination of the test bundle at Karlsruhe. The implications of these results with respect to degraded core modelling and the associated safety issues are also discussed.     

Bioactive compounds in rye flours with different extraction rates

Rye flours with extraction rate of 100% (wholemeal flour), 95% (brown flour), 90% (brown flour) and 70% (light flour) were prepared in order to study the relation between flour extraction rates and content of bioactive compounds. The following compounds were analysed: total phenolic compounds (TPC), total flavonoids (TF), inositol hexaphosphate (IP6), reduced (GSH) and oxidized (GSSG) glutathione, tocopherols (T) and tocotrienols (T3). The reduced/oxidized glutathione status (GSH/GSSG) of the flours was examined as a potential index of flour resistance against oxidative stress. The following observations were made in relation to the flour extraction rates and bioactive compounds contents: (a) milling process caused decrease in content in TPC, TF, IP6, GSH and GSSG, T and T3, (b) the most resistant against oxidation processes were suggested a brown flours, then light and finally wholemeal flour, (c) the ratio of tocotrienols to tocopherols (T3/T) was the highest in rye flours with extraction rate of 100–90% whereas light flour was the poorest source of tocopherols and tocotrienols. The provided data support current trend to increase number of rye products from wholemeal or brown flours.     

Antiwear Action of Mineral Lubricants Modified by Conventional and Uncoventional Additives

The authors of this paper investigated the influence of esters of rapeseed oil fatty acids on the lubricating properties of mineral lubricants containing chosen AW/EP additives. Methyl esters, ethylene glycol esters, and glycerol esters as well as some commercial AW/EP packages based on zinc dialkyldithiophosphate, S–P organic compounds, and sulphurized esters of fatty acids were tested. The tribological tests were carried out with the use of a four-ball machine. Antiwear (AW) properties of tested compositions were determined using their limiting load of wear (G_oz(40)). It appears that the AW action of esters of rapeseed oil fatty acids depends on their structure. The best AW action is shown by compositions of mineral oil lubricants containing AW/EP additives and methyl esters of rapeseed oil fatty acids. The SEM/EDS analysis of the scar surface layer indicated that the presence of these esters in lubricants causes a change in the interaction between AW/EP additives and the metal surface. These observations were confirmed by the XPS surface analysis.     

On-Line LC-GC for the Analysis of the Minor Components in Edible Oils and Fats – The Direct Method Involving Silylation

The previous on-line LC-GC method for the direct analysis of the minor components in oils and fats (without cleavage of esters) was modified: The free alcohols/sterols were silylated instead of acylated, and the LC fraction transferred to GC is widened to range from the beginning of the LC chromatogram up to the sterol esters. Silylation eliminated the problem that acylation may esterify some free alcohols with free fatty acids from the oil if the oil or fat is of high acidity. Widening of the LC fraction to include squalene and the tocopherols added information to that previously obtained.     

Analysis of a homologous series of non-reducing oligosaccharides from Arnica montana L. Roots

The oligosaccharide component compositions of a series of non-reducing oligosaccharides extracted from the roots of Arnica montana L. has been determined by gel permeation chromatography (g.p.c.). The range of oligosaccharides present was found to extend beyond the octasaccharide previously reported. with 16% to 19% of the oligosaccharides having a degree of polymerisation of between 11 and 19 and almost 3% having a degree of polymerisation greater than 20. The chromatographic behaviour of this series of oligosaccharides is compared with that observed for series of D-gluco-oligosaccharides.     

Microstructural development and creep deformation in equiaxed γ, γ+α 2, and γ+α 2+B2 titanium aluminides

The development of microstructure and its influence on creep properties have been studied for structures including equiaxed γ, duplex, and other structures of varying α ₂ morphology in two Ti-48Al-2Cr-2Nb alloys. Heat treatments at 1125 °C have been utilized to produce equiaxed γ microstructures in alloys with or without Mo additions. The γ → α transformation produces α ₂ plates with several orientation variants within γ grains during subsequent annealing of the equiaxed γ microstructures below the α transus. Formation of this α ₂ morphology results from rapid up-quenching (UQ), and this structure persists through annealing, cooling, and creep testing. Differences in minimum creep rates for several microstructures containing varying amounts of multi- or single variant γ/α ₂ grains are shown to be minimal. The presence of Mo has also resulted in improved creep resistance in equiaxed γ and γ+α ₂+B2 structures, as compared to similar microstructures in the Ti-48Al-2Cr-2Nb alloy. Deformation during creep at 760 °C at stresses between 200 and 400 MPa occurs by a combination of twinning and dislocation glide without recrystallization, resulting in power-law stress exponents in the range of 6 to 9. Only minimal strain path dependence of the minimum creep rate is detected in a comparison of creep rates in stress jump, stress drop, and single stress tests. This article is based on a presentation made in the symposium “Fundamentals of Gamma Titanium Aluminides,” presented at the TMS Annual Meeting, February 10–12, 1997, Orlando, Florida, under the auspices of the ASM/MSD Flow & Fracture and Phase Transformations Committees.     

Identifying a putative common binding site shared by substance P receptor and an anti-substance P monoclonal antibody

Substance P G-protein coupled receptor and the antigen recognitionsite of a monoclonal antibody raised against substance P sharea stretch of five contiguous identical amino acids. This observationprompted us to build an atomic model of both the receptor andthe antibody and to analyse their common features. In particular,we report here that a pocket of similar size and compositionis present in both proteins, strongly suggesting a similarityin the mode of binding of both macromolecules to substance P.From the analysis of our models, the available data on the modeof binding of the antibody to substance P and recent data onsubstance P receptor mutants, we concluded that the pocket isvery likely to be involved in binding of the C-terminal 'messagesequence' of the tachykinin. This allowed us to suggest specificsite-directed mutants of the receptor which should shed somelight on the mechanism of peptide recognition by G-protein coupledreceptors.     

Macroscopic model for multispecies ion-exchange kinetics

A model for multispecies ion-exchange kinetics based on the Nernst-Planck equation is suggested. It is analyzed in comparison with the “locally-determinate” model described by Hwang and Helfferich [1]. The model makes possible simple computation. The conditions for the occurrence of unusual kinetic curves with a maximum are clarified. The proposed model is developed for different types of kinetic problems and verified by the experimental investigation of a kinetics in ternary systems.     

Abdominal T-cell non-Hodgkin's lymphoma of the gamma/delta type in a patient with selective immunoglobulin A deficiency

A 28-year-old man presented with selective immunoglobulin A deficiency and severe diarrhea responding to a gliadin-free diet. Biopsy samples of the small intestine showed dense T-cell infiltrations in the lamina propria and a slight increase of intraepithelial T-lymphocytes. No clonal rearrangement of the T-cell receptor c-beta chain genes was detectable by Southern blotting. Four years later, at the age of 32, the patient was hospitalized again with liver failure, abdominal lymphadenopathy, pancytopenia, and recurrent bacterial infections. Retrospective polymerase chain reaction analysis of formalin-fixed tissues of the intestinal biopsy samples obtained 4 years earlier showed monoclonal T-cell receptor gamma-chain gene rearrangement. Lymphoid cells of the peripheral blood showed an immunophenotype of CD3-positive gamma/delta T cells with a negativity for CD4 and CD8. A clonally rearranged T-cell receptor delta chain gene and a germline configuration of the c-beta chain genes was found by Southern blotting. Cytogenetics showed an abnormal karyotype with unbalanced translocations t(1;5) and t(9;13). The patient died of extensive lung infiltrations by gamma/delta T cells; autopsy showed a peripheral T-cell lymphoma of the gamma/delta type in the enlarged abdominal lymph nodes. This is the first report of an abdominal T-cell lymphoma of the gamma/delta type in a patient with selective immunoglobulin A deficiency.